REPAIR TO PATH, DRAIN, GATES, BOUNDARY WALL AND PLAIN CEMENT CONCRETE HARD STANDING AND OTHER MISCELLANEOUS WORK AT VAYUSENA NAGAR, NAGPUR

Amount

Demolition of reinforced cement concrete (reinforcement cut as required to facilitate demolition) of any description and in any position not otherwise specifically provided for complete all as directed. Note:- All demolition materials obtained from demolition shall be removed outside of MoD land.

Demolition Brick work or stone/ boulder masonry, built in cement mortar including all quoins , pillars etc, all as specified and as directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

Dismantling of fencing wire mesh, any type complete all as specified and directed.

Excavation in trenches n.exc 1.50m wide & n.exc 1.50m deep for foundation etc or for shafts wells cesspits ,manhole pier holes etc n exc 10 sqm on plan and n exc 1.5 m depth and getting in hard/dense soil complete all as specified and directed.

BLANK

Material and labour for RCC (Design mix) M-25 (20mm graded aggregate) for foundation including rafts footing, foundation beams, plinth beams, bases for columns etc basement slab,under reamed piles and mass concrete complete all as specified and directed.

All as per item No 8 but for columns, pillars, piers, posts and struts

All as per item No 8 but for beams, cantilevers, bressummers lintels over 1.5 m span

Use and waste of formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams; and similar work; vertical or to batter fair finished surfaces complete all as specified and directed.

All as per item No 10 above but pillars, posts, struts, piers, columns and stanchions fair finished surfaces

All as per item No 10 above but to sides and soffits of floor or roof beams, beam haunchings, girders, bressum-mers, lintels, cantilevers, shelves including supports, overhangs, etc. also splays between floors and beams, etc. fair finished surfaces.

Material and labour for brick work with fly ash old size bricks, straight or curved on plan exc 6 m mean radius built in CM 1:6 complete all as specified and directed.

Material and labour for Mild steel TMT bars 10 mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns , hooking ends and binding with and including mild steel wire ( annealed) not less than 0.90 mm dia complete all as specified and directed.

All as per item No 14 above, but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders.

Taking down cement plaster on brick or concrete surfaces on wall etc including racking out joint, hacking for key,scrubbing down with water etc complete all as specified and as directed.

Material and labour for rendering 15 mm thick on fair faces of brick work or concrete surfaces concrete surfaces in cement mortar (1:4), finished even and smooth without using extra cement complete all as secified.

Material and labour for preparation of newly plastered wall surfaces and applying two coats of cement based paint over a coat of alkali resistant primer complete all as specified and as directed.

Returning, filling in including spreading, levelling, watering and well ramming in layers not exc 25 cm for any types of soil complete all as specified and as directed.

Removing excavated material (soils) exc. 250 m but n exc. 500 m and depositing where directed complete all as specified.

Supply and fixing mild steel screw bolts (machine made) with hexagonal or square eads at one end and screwed the other to be fitted with washers and one hexagonal or square nuts, exc 22.5 cm but not exc 30 cm long, diameter of neck 16 to 20 mm complete all as specified and as directed.

Material and labour for rolled MS plates (plain or chequered) channels, square cut or notched (ordinary and counter sunk) forming holes, with welded attachment with MS angle confirming to Fe 290 (Gde - E-165) complete all as specified and as directed.

Material and labour for for mild steel work as in posts or struts of any frame work in fencing including cutting tops to shape as directed drilling holes, notching for wire etc flat iron fillets (for securing wire mesh etc) including all necessary bolting or riveting etc and similar work confirming to Fe-290 Gde E-165 complete all as specified and as directed.

Material and labour for preparation of new iron surfaces over 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and as directed by Engineer-in-Charge.

Supply and fixing Galvanised, 2 strand, steel barbed wire 2.24 mm dia barbed with 2 mm dia bars at 75 mm spacing and straining and fixing to any type of standard rails straining bolts, including securing or tying at crossing with and provision of galvanised mild steel wire, staples or steel pins, etc as directed (each line of wire to be measured) complete all as specified and as directed.

Supply and fixing hot dip galvanised punched type concertina coil of loop dia 1050 mm (dia of coil when upstretched) fixed to angle post, strut, barbed wire and tying at three places i.e two at bottom & one at top with 3.15 mm dia galvanised mild steel wire in each loop complete all as specified and as directed.

Material and labour for framed work such as grills, gratings,etc,with ends of bars shouldered and/or riveted ,or forged into spikes, framed guard bars barred iron doors,ladders,framed balusters,walk ways railings,framework of water tanks and similar work con-forming to Fe-290 Gde-E-165 complete all as specified and as directed.

Material and labour for prepartion of old plastered/unplastered surface of walls incl washing, rubbing down and stopping of painted surfaces etc & applying one coat of cement base paint complete including filling of hole, cracks etc with lime putty or plaster of paris complete all as specified and as directed. Note :- Shade and pattern of the colour to be approved by GE.

Material and labour for for preparation of old decorated surfaces in walls, soffits, facia roof etc and applying one coat of weather proof premium acrylic based emulsion paint (100% acrylic) as per manufacturers instructions etc complete all as specified and directed. Note :- Shade and pattern of the colour to be approved by GE.

All as per item No 29 above but two coats of weather proof premium acrylic based emulsion paint

Material and labour for complete removal of existing treatment on wall surfaces by scrapping with mechanical sander (having mechanical vacuum mechanism) with sanding pad of appropriate grit to make surface clean, free from dust, loose paint etc incl applying two or more coasts of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm complete all as specified and as directed.

Supply and fixing framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other cover-ing. Doors, etc. to be prepared for hanging or sliding with and includ-ing either hooks and hinges or steel hanging door fittings and hanging; also fastening and fixing complete confirming to Fe 410-W (Gde-E-250) quality-A. complete all as specified and as directed.

Excavating in post holes (or similar holes) each in loose/soft soil n exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance n exc 50 m and making good surface.

Fixing only Chain link fencing including line wires any mesh size and type to any type of standards, rails straining bolts etc including provision of binding wire all as specified and as directed.

Supply only Chain link MS galvanised fencing, any size or type all as specified and as directed.

Material and labour for mild steel round bars 10 mm dia and over, cut to length bent to shape required including cranking , bending and binding with MS wire (annealed) not less than 0.9 mm dia all as specified and as directed by engineer-in-charge

Material and labour for preparation of old steel surfaces of any description over 10cm width or grith and applying one coat of synthetic enamel paint complete all as specified and as directed.

Material and labour for preparation of old steel surfaces of any description over 10cm width or grith and applying one coat of aluminium paint complete all as specified and as directed.

Material and labour for preparation of old brick, stone, concrete, asbestos cement or plaster surfaces of any description over 10cm width or girth and applying one coat of synthetic enamel paint complete all as specified and as directed.

Material and labour for for preparation of old surfaces of paver tile, blocks, kerb stone etc and applying one coat of floor guard of premium acrylic emulsion paint in any colour of approved make etc complete all as specified and as directed.

Dismantling floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store and rubbish off the premises.

Demolition of cement concrete in ground floors and pavings n exc 15 cm thickness (below or above ground level) and demolished meterial to be removed out side of MD land.

Material and labour for plain cement concrete Type B2 (1:2:4) (using 40mm graded crushed stone aggregate) in surface channel, drains and similar works etc complete all as specifed and as directed.

Material and labour for plain cement concrete Type D-2, (1:4:8) (using 40 mm graded crushed stone aggregate) in foundation, sub base, below floor, filling and mass concrete etc complete all as specified and as directed.

Material and labour for 25 mm thick cement concrete type B-0, 1:2:4 (12.5 mm graded aggregate) as on floor.

Material and labour for polished chequered cement concrete tiles 30cm x 30cm x 25mm thick, set, jointed and pointed in neat cement slurry in floors

Material and labour for factory made machine pressed rubble moulded precast conctete interlocking paver block any shape and size with grey cement and pigments confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade over and including 40 mm thick stone dust cousioning complete all as specified and directed

Dismantling of stone slab and tiles of any description or thickness in floors, aprons etc laid, bedded and pointed in any mortar complete all as specified and directed

Material and labour for for 18-20 mm thick granite (of any type) work (table rubbed and polished) in steps, jambs, pillars, window-cills, cooking platforms and like in cement mortar (1:4) including pointing in white cement (1:2) using marble dust with admixture of pigment to match with shade of granite complete all as specified and directed

Demolition & breaking up drain pipe (salt glazed, AC or reinforced concrete ) set in cement mortar for 300 mm internal dia of pipe complete all as specified and directed

Material and labour for PCC (1:3:6) type C-2 (using 40 mm graded stone aggregate) as in bed to drain pipes, incl forming cradles etc of the pipes after they are laid and tested for 300 mm bore RCC pipe complete all as specified and directed

Material and labour for reinforced cement concrete pipes class NP - 2, laid in trenches & jointed complete with collars, bore of pipe 300 mm complete all as specified and directed

VIJ ASSOCIATES (BID ID -3207447)

M/s Ashwin Bhange (BID ID -3217864)

dhanshree enterprises (BID ID -3218095)

Raut Construction (BID ID -3218013)

M/s S. S. MUNDE (BID ID -3218164)

Bidder Name

M/s Prakash R. Verma

Raut Construction

M/s Ashwin Bhange

dhanshree enterprises

VIJ ASSOCIATES

M/s S. S. MUNDE