Misc civil works for construction of Synthetic lawn tennis court including Synthetic surface cushion at HAL Township Lucknow

Surface dressing of the ground including removing vegetation and in-equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m. All kinds of soil

Preparation and consolidation of sub grade with power road roller of 8 to 12 tonne capacity after excavating earth to an average of 22.5 cm depth, dressing to camber and consolidating with road roller including making good the undulations etc. and re-rolling the sub grade and disposal of surplus earthwith lead upto 50 metres.

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, lift upto 1.5 m, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand (zone-III) : 8 graded stone aggregate 40 mm nominal size)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in : Cement mortar 1:6 (1 cement : 6 coarse sand)

15 mm cement plaster on the rough side of single or half brick wall of mix : 1:6 (1 cement: 6 coarse sand)

Supplying chemical emulsion in sealed containers including delivery as specified. Chlorpyriphos/ Lindane emulsifiable concentrate of 20%

Diluting and injecting chemical emulsion for POST-CONSTRUCTIONAL anti-termite treatment (excluding the cost of chemical emulsion) : Along external wall where the apron is not provided using chemical emulsion @ 7.5 litres / sqm of the vertical surface of the substructure to a depth of 300mm including excavation channel along the wall & rodding etc. complete: With Chlorpyriphos/ Lindane E.C. 20% with 1% concentration

Providing, laying, spreading and compacting graded stone aggregate (size range 53 mm to 0.075 mm ) to wet mix macadam (WMM) specification including premixing the material with water at OMC in for all leads & lifts, laying in uniform layers with mechanical paverfinisher in sub- base / base course on well prepared surface and compacting with vibratory roller of 8 to 10 tonne capacity to achievethe desired density, complete as per specifications and directions of Engineer-in-Charge.

Providing and applying tack coat using hot straight run bitumen of grade VG - 10, including heating the bitumen, spraying the bitumen with mechanically operated spray unit fitted on bitumen boiler, cleaning and preparing the existing road surface as per specifications : On W.B.M. @ 0.75 Kg / sqm

Providing and laying bituminous macadam using crushed stone aggregates of specified grading premixed with bituminous binder,transported to site by tippers, laid over a previously prepared surface with paver finisher equiped with electronic sensor to the required grade, level and alignment and rolling with smooth wheeled, vibratory and tandem rollers as per specifications to achieve the desired compaction and density, complete as per specificatons and directions of Engineer-in-Charge laid in 30 mm average compacted thickness with bitumen of grade VG-30 @ 3.50% (percentage by weight of total mix) prepared in Batch Type Hot Mix Plant of 100-120 TPH capacity.

Providing and laying semi- dense Bituminous concrete using crushed stone aggregates of specified grading, premixed with bituminous binder and filler, transporting the hot mix to work site by tippers, laying with paver finisher equiped with electronic sensor to the required grade, level and alignment and rolling with smooth wheeled, vibratory and tandem rollers to achieve the desired compaction and density as per specification, complete and as per directions of Engineer-in-Charge. 25 mm compacted thickness with bitumen of grade VG-30 @ 5% (percentage by weight of total mix) and lime filler @ 2% (percentage by weight of Aggregate) prepared in Batch Type Hot Mix Plant of 100-120 TPH capacity.

Providing and laying seal coat of premixed fine aggregate ( passing 2.36 mm and retained on 180 micron sieve) with bitumen using 128 kg of bitumen of grade VG - 10 bitumen per cum of fine aggregate and 0.60 cum of fine aggregate per 100 sqm of road surface, including rolling and finishing with road roller all complete.

Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shade : New work (Two or more coats applied @ 1.43 ltr/10 sqm over and including priming coat of exterior primer applied @ 2.20 kg/10 sqm)

Providing and applying white cement based putty of average thickness 1 mm, of approved brand and manufacturer, over the plastered wall surface to prepare the surface even and smooth complete.

Providing and laying " ALL SEASON SYNTHETIC SURFACE-9 LAYERS" consist of 9 layer synthetic surface cushion system (a) One layer of primer(undercoat is applied on the surface to increase the retention of the material to be applied. (b) One layer of resurface layer after the primer layer is applied to cover the pores on the floor. (c) Three coats of heavy cushion. (d) Two coats of fine cushion. (e) Two coats of synthetic/Acrylic paint. (f) Two coats of synthetic paint marking.

Supplying and installation of Court accessories

Lawn tenis pole

Lawn tenis net

HAL-AD/9904/4686/CE/2025

Misc civil works for construction of Synthetic lawn tennis court including Synthetic surface cushion at HAL Township Lucknow

Description

Name of the Individual / Firm / Company: * Mandatory

Type of ownership Pvt. Ltd./ Proprietorship/Partnership/ Public limited/ Govt. Agencies/ Trust

Details of Constitution or Legal Status such as certificate of incorporation, shops and establishments, Contractor registration No etc.,

Address for correspondence:

Contact details

Intending parties having credentials as mentioned below may participate in e-tendering. The pre-qualification requirements for the works are as under :-

List of similar works executed in the past 7 years with value, schedule period of completion reasons for delay in completion if any and salient features of works, with documentary evidence of satisfactory completion.

PAN No.:

Constitution and legal status i.e. Proof of proprietary/Partnership firm or company & authorised person for receiving or signing the documents to be submitted.

Goods and Service Tax ID No.

SAC (Service Accounting code) along with the tax structure.

Bank account details such as account no., name of account holder, name and address of the bank, IFSC code duly certified by the bank along with cancelled cheque as a document of proof shall be attached.

Registered Contractor

Average annual financial turn over during the last 3 years, ending 31st March 2022 of the previous financial year [ should not be less than 30% of Amount put to tender]

EMD of Rs.29700.00

Latest Solvency Certificate issued from Nationalized/ scheduled Bank issued and NOT before 12 months from the last date of Tender submission

Experience of having successfully completed similar works during last 7 years ending last day of previous month. [Latest work experience certificate may be uploaded]

(i) THREE similar completed works each costing not less than the amount equal to 40% of the estimated cost.

(ii) TWO similar completed works each costing not less than the amount equal to 50% of the estimated cost.

(iii) ONE similar completed work each costing not less than the amount equal to 80% of Amount put to the tender.

Details of person holding the power of Attorney (If different from contact person)

DECLARATION I

DECLARATION II

DECLARATION III