Road Repair, Interlocking and Construction Work of K.C. Drain in Shanti Nagar Colony under Zone-01 (Shivpur Ward)

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineer-in-charge.All kinds of soil DSR SI NO(2.6.1)

Demolishing cement concrete manually/by mechanical means including disposal of material within 50 metres lead as per direction of Engineer-in-charge.(dsr 2023 si no 15.2.2)

Disposal of moorum/building rubbish/ malba/ similar unserviceable, dismantled or waste material by mechanical transportincluding loading, transporting, unloading to approved municipal dumping ground for lead upto 10 km for all lifts, complete as per directions of Engineer-in-charge.(DSR 2023 SI NO. 1.1.18)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in superstructure above plinth level up to floor V level in all shapes and sizes in : .[DSR-2023 SI No.6.1.1 ] cement mortar 1:4 (1 CEMENT :4 coarse sand)

12 mm cement plaster on rough side of single or half brick wall of mix: 1:4 (1 cement: 4 coarse sand)DSR 2023 si no (13.4.1)

Construction of granular sub base by providing welll graded material,spreading with in uniform layers with motor grader on prepared surface, mixing mix in place method with rotavator at OMC and compacting with Vibratr roller to achieve desired density complete as per technical specification clause 401 (AR)

Providing and laying factory made chamfered edge Cement Concrete paver blocks in footpath, parks, lawns, drive ways or light traffic parking etc, of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over 50mm thick compacted bed of sand,compacting and properembedding/laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand. complete all as per direction of Engineer-in-Charge. 80 mm thick C.C. paver block of M-35 grade with approved colour design and pattern DSR 2023 SI NO 16.91.2

Prime Coat over WMM/WBM Providing and applying primer coat with SS-2 grade bitumen emulsion on prepared surface and spraying primer at the rate of 0.70 kg/sqm using mechanical means.(AR)

Dense graded bituminous macadam Providing and laying dence graded bituminus macadam with higher capacity HMP using crushed aggregates of specified grading, premixxed with bituminus binder @ 4.5 per cent by weight of total mix and filler, transporting the hot mix to work site, laying with a hydrostatic paver finisher to the required grade, level and alignment, rolling with smooth wheeled, vibratory and tandem rollers to achieved the desired compaction as per MoRTH specifcation clause No. 505 complete in all respects.(AR)

Tack Coat on Bituminous Surface Providing and applying tack coat with bitumen VG-10using bitumen pressure distributor at of 0.30 kg per sqm on the prepared bituminous surface cleaned with mechanical broom.(AR)