REPAIR OF DRAIN FOOTPATH SECURITY WALL GATE FENCING REPAIR TO PATH COMPOUND WALL AT SAMNABANJ RC PEAK AND BATTLE NODE UNDER GE ARMY DHAR ROAD

Amount

Taking down cement plaster of any description on concrete surfaces such as soffit of RCC slab, chajjas and brick walls, Ceiing etc including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed

M&L, Rendering 15mm thick in CM 1:4 on of brick work or concrete surface finish ever and smooth (w/o using extra cement) incl WPC as per user manual complete all as specified and directed. (WPC will be measured and paid separately).

Supply only liquid WPC

M&L for preparation of new plaster surface & apply two coats of cement based paint over a coat alkali primer resistance and all as directed.

Dismantling, floor, hearth or wall tiling including cement mortar bedding (but not backing), removing serviceable tiles to store yard and rubbish off the premises as directed.

M & L for 75 mm thick PCC 1:4:8 type D-2 (using 20 mm agg. ) in path, hardstanding, sub base of flooring etc complete all as spd and directed.

M&L for 75 mm thick cement concrete type B1 1:2:4 (20 mm graded aggregate) finishing cement concrete surface even and smooth Without using extra cement.

M&L for machine pressed precast concrete interlocking paver block of 80mm thickness any shape and size confirming to IS 15658 -2006, M-40 with grey cement and pigment incl 20mm thick fine sand as cushioning incl dismantling of old tiles complete all as specified and directed.

M&L for machine pressed precast concrete interlocking paver block of 60mm thickness any shape and size confirming to IS 15658 -2006, M-35 with grey cement and pigment incl 20mm thick fine sand as cushioning incl dismantling of old tilescomplete all as specified and directed.

M & L for Factory made prepolished precast concrete designer tiles, ISI marked with grey cement & pigment, 25mm thick of outdoor size 300mm x 300mm , in floors , set and jointed with grey cement slurry, over & incl 20 mnm thick cement mortar (1:4) screed incl dismantling of old tiles complete, all as specified.

M&L for factory made pre-cast cement concrete block type B1, 1:2:4 as in kerb stone made to shape as directed, exc. 10 cm in width and setting in mortar 1:4, complete all as specified and as directed.

M & L for prepolished precast concrete designer tiles size 300x300x10mm with grey cement & pigment, outdoor /parking design in floors , set and jointed with grey cement slurry, over & incl 20 mnm thick cement mortar (1:4) screed incl dismantling of old tiles complete, all as specified. Make : Somany/Kajaria/Johnson Endura etc

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for, as directed by the Engr-in-charge.

M&L for RCC 1;2;4 (using 20mm graded agg) pre-cast cover slabs (for manholes etc.) chajjas, shelves and similar articles all as specified with one hole at centre and both side ring to carrying complete all as directed and specified.

M & L for reinforced cement concrete (nominal mix) type B-1 1:2:4 (20mm graded aggregate) in slabs supported on walls, culvert etc and the like complete all as specified.

M&L for TMT Bar 10mm dia and over cut to length bend to shape required incl cranking, bending sprilly for hooping colmns hooking ends and binding with and incl MS wire complete all as spd and directed.

ditto all as above but 6 to 8 mm dia and over and including in stirrups, spacers and binders and complete all as specified.

M & L for formwork to sides and soffits of floor or roof beam,parpets , flat or vertcal surface etc incl supports, overhangs etc complete all as specified.

M&L for PCC (1:2:4) type B-1 (using 20 mm graded aggr) as in mass concrete/ staging/ post etc complete all as directed and specified.

Demolition/Dismantling of Brickwork or stone/ boulder masonry, built in cement mortar incl all quoins, arches, pillars, etc,complete all as specified and directed .

M&L for PCC (1:3:6) type C2 using 20 mm graded aggr as in surface channels/mass concrete complete all as directed and specified.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, mounds, mitred/stopped end etc.

M&L brick work with sub class 'B' bricks, straight or curgved in cm 1:4 straight or cuved on plan to exc 6m mean radius complete all as directed and specified.

-ditto- all as per above here in but except bricks.

M& L for stone masonry of walling of random rubble,uncoursed, well bonded, bedded and solidly hearted, built in CM 1;4 complete all as diretect.

Extra over stone walling for hammer dressing with miximum depression on face from straight edge held against the dressed surface not exceeding 20 mm to face stones (Granite or Trap stone) and dressing of face beds and joints, as specified of random rubble walling, uncoursed or brought upto courses complete all as specified.

Raised pointing to random rubble uncorsed stone masonary in CM 1:3 complete all as specified.

M&L for PCC 1:2:4 type B0 (using 12.5 mm graded stone aggregate) as in coping/benching and all other similar works including necessary formwork complete all as directed.

M & L for 50 mm thick PCC 1:3:6 type C-2 (using 40 mm agg. ) as in plinth protection / path/ any paved area including demolation complete all as specified and directed.

S&F in repair galvanised two strand steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any standardral straining bolt including securing or tying at rossing with an provision of galvanised stell pin etc complete all as specified and directed.

Restraining & resecuring existing barbed wire of any type incl making good staples etc any type of standard rails straining bolts including securing or tying at crossings with and provision of galvanised mild steel wire staples or steel pins etc (each line wire to be measured) complete all as specified.

Supply only Chain link fencing including wires, mesh of size 50x50/ 100x100 mm, confirming to IS, type standards rails, straining bolts etc including provision of binding wire, complete all as specified and directed.

Fixing only chain link fencing including line wire, any mesh, size and type to any type of standards, rails, straining bolts etc. including provision of binding wire, complete all as specified and directed Including dismantaling.

S&F in repair circular concertina coil punched tape (incl spikes and handle) with 50 turns and loop dia 750mm, width of barbed 9mm dia and spacing clips 23.5mm to 24.5mm c/c and weight of coil not less than 10 to 14 kg without packing, coil length will be 6meter when opened up etc, fixing at any position/at any height, binding with angle iron ground pickets and binding of coils with clips and binding wire as per manufactures's instruction & sample as approved by GE /EIC complete all as specified and directed.

Mild steel angle iron posts and struts confirming to FE-290 E-165 as in fencing including cutting tops for required shape, drilling holes, notching for wire including all necessary drilling of similar work, complete all as specified and directed.

S&F MS flat iron fillets (for securing wire mash etc) to fencing post including all necessary drilling, bolting or riviting etc and similar work conforming to Fe-290 Gde E-165.

M& L for Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete (Fe 410-W (Gde-E-250) quality A) at any position complete all as specified and directed.

S&F for expanded metal, cut to length, bent to shape required and tying with and including annealed mild steel wire not less than 0.9mm dia or fixed with galvanized steel staples supplied /welding to steel member, weight exc 4 kg per Sqm complete all as specified and directed.

M&L for preparation of new steel or iron surfaces of any description not otherwise described over 10 cm girth or width and applying two coats of synthetic enamel paint over a coat of red oxide zinc chrome primer complete all as directed and specified.

M&L for complete removal of existing treatment on wall, ceilling etc by scraping, sand papering or by using mechanical saneter and preparing plastered surfaces and applying two coats of cement base paint over a coat of primer of approved tint on walls by using roller/spray complete all as specified and as directed by Engr-in-Charge.

M&L for one coat of synthetic enamel paint over old painted steel & iron surfaces of any description, not otherwise described, over 10 cm in width or girth, including preparation of surfaces complete all as specified.

Dismantling Asbestos cement, GI or galvolume (corrugated, semicorrugated, etc.) sheets in roof coverings complete all as specified.

S & F for Pre-painted galvalume aluminum zinc coating GI based corrugated steel sheet 0.50mm thick of any colour having tensile strength of 550 Mpa as in roof covering/cladding/chajja projections, fixed with self tapping screws all as specified.

S&F in repair Vitreous china wash down water closet pan (pedestal pattern) , white ,including sheet cover of closed pattern with flat bottom and mild steel chromium plated including sor p trap or aluminiumised hinging device, complete.

S & F Vitreous china squatting pan ‘Orissa’ pattern, size 580 x 440 mm, coloured, with integral foot rests, fixed in repairs including provision of lime concrete bedding complete.Squatting pan including connection to S or P trap, and to flushing pipe, anti-syphonage pipe, etc. complete including making good to floor complete.

supply and fixing in repairs low level flushing cistern 10 ltrs capacity, and connections to pies an fixing of chain and pull, or lever, if any PVC valveless, syphonic action type, flushing cistern, low level, white,with inlet, including brackets complete all as specified and directed.

Dismantling water tanks exc 500 & n exc 1000 capacity in litres and removing to contractors store

S&F for 1000 ltr rotational moulded polyethylene water storage tanks (cylindrical vertical with closed top), hoisted and fixed in position icluding 20 mm ball brass valve complete all as specified

M&L for demolition of existing old soakage well of any size incl demolition of brick work PCC and refill the same up[to the existing ground level complete all as as specified and directed

Soakage wells of size 1.80 Mtr dia x3.00m depth excavation in any types of soil, foundation in PCC 1:3:6 walls of honeycomb masonry with brick work all as shown in drg No CE/TDT1202/2003 top ring of M-25 concrete including intercepting chamber and screen chamber made of brick masonry in CM, RCC cover slabs in M-25/SFRC covers, interconnecting pipes of RCC/DWC complete filled with brick bats complete all as directed.

Excavation in trenches, in any type of soil not exceeding 1.50 metre wide and not exceeding 1.50 metre in depth; for foundation, etc. and getting out complete, all as specified.

Demolition and breaking up drain pipes (Salt glazed ware, AC or Reinforced concrete) including concrete bed set in cement mortar of 100/150/200 mm dia

M&L for concrete bed to drain for 150 dia pipes including packing under, and haunching against the sides of pipes after they are laid and tested; in cement concrete PCC 1:4 : 8 type D-2(Using 40mm graded stone aggt) complete all as specified.

S&F Reinforced concrete pipes, class NP2, 150 mm bore laid and jointed complete with collarslaid in trenches and jointed Concrete bed to drain pipes all as specified.

Removing excavated spoil to a distance not exceeding 50 metre and depositing where directed at a level not exceeding 1.5 metre above the starting point complete, all as specified.

Returning filling in, including spreading, levelling, watering and well ramming in layers not exceeding 25 cm thick each, complete, all as specified.

Deduct Schedule of Credit of Rs. (-) 27750.00 (Minus) as listed in Schedule 'A' Part-II. Contract Sum shall be arrived after deducting the credit amount Note: Tenderers will not quote against this item being a firm amount.

jyoti parkash sharma (BID ID -3311491)

M/s Ranpat Dev Infrastructure pvt ltd (BID ID -3311142)

M/S PAWAN KUMAR ANAND (BID ID -3307273)

M/S SHUBAM ENGINEERS (BID ID -3307247)