REPAIR TO PERIMETRE WALL (INSIDE AND OUT SIDE), FENCING, KERB STONES, DRAINS AND OTHER CONNECTED WORKS AT BAIRD PLACE IN THE AREA OF AGE B/R-I UNDER GE (EAST) DELHI CANTT-10

Amount

Demolition of brick work built in cement mortar including all quoins, arches, pillars etc complete all as specified and as directed.

M&L for brick work with sub class 'B' straight or curved on plan exc 6m mean radius and built in CM 1:4 complete all as specified and directed.

Taking down cement plaster on brick walls etc including raking out joints hacking for key scrubbing down with water etc all as directed.

M&L 10 -12mm thick polymer modified readymix cement base plaster (Make: Ultratech readiplast or equivalent) as per manufacturer instruction on fair / unfair faces of brick work or concrete surfaces & finishing the surface even & smooth as per manufacturer instruction complete all as specified & directed.

M&L for prepration of newly plastered surfaces of wall and applying 2mm thick birla white wall care putty complete all as specified and as directed.

M&L for prepration of new/Old plastered surfaces of wall and applying Two or more coats of 100% Premium acrylic emulsion paint having VOC less than 50 gm/litre and UV resistance as per IS 15489:2004, Alkali & fungal resistance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/ 10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/ 10 sqm over complete all as specified and directed.

Preparation of new steel and iron surfaces of any description over 10cm in width or girth , priming with a coat of red oxide primer and applying two coats of synthetic enamel paint complete all as spd

Preparation of old steel and iron surfaces of any description over 10cm in width or girth, and applying two coats of synthetic enamel paint complete all as spd

M & L for angle iron posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E complete all as directed by Engr-in-Charge.

S & F in Repair galvanised 2 strand , steel barbed wire 2.24 mm dia barbed with 2 mm dia barbs at 75 mm spacing and staining and fixing to any type of standard rails straining bolts , including securing or tying at crossing with and provision of galvanised mild steel wire , staples or steel pins etc,(each line wire to be measured) complete all as specified and directed and fixed in repairs.

M&L for cutting holes superficial area exc. 150 sqcm but not exc. 400 sqcm into or through brick walls built in CM and maikng good in cement mortat 1:3 or cement concrete 1:2:4 type B-1 as required for inserting hold fasts and making good dismantled portion in CM (1:3) or PCC (1:2:4) type B-1 as required.

S&F concertina coil 2.5 mm dia of core wire in 450 mm circular dia of each coil having a core wire of high carbon spring steel of high tensile strength as per grade of IS-1454(Part-I) with low carbon steel strip punched tape of 19 mm wide, 0.50 mm thick and series of knife edge sharp barb/blades @ 25 mm centre to centre punched all along the length of both sides of strip at regular interval conforming to IS-513 and minimum 6Mtr length cover after opening complete all as specified and directed.

S&F in repair/replace factory made steel fibre reinforced (SFRC) Drain covers without frames incl necessary hold fast/hooks of (Heavy duty) 600x450x70mm rectangular complete all as specified. Make Kreative concrete Company Product Code DC - 01 and equivelent.

Dismantling post or struts (wood, steel or RCC) any section incl taking out embeded portion in concrete, brick work, RR masonary etc. and making good disturbed surface complete all as specified and as directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

M&L for framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc. of steel comforming to Fe-410-W (Gde E-250) quality 'A' complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing including one shop coat of zinc chromate primer paint (including preparation of surface) at Contractor’s workshop before fabrication complete all as specified and directed.

Demolition in cement concrete of cement concrete in ground floor and paving not exc. 15 cm thick below or above ground level complete all as specified and as directed.

Dismantling fencing wire mesh, any type complete all as specified and as directed.

Supply only MS galvanisd Chain link fencing, any size or type complete all as specified and as directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified.

S&F 10mm round bars of gread Fe-410-W (Part I) (Gde.E-250) quality-A or Fe 290 (Gde -E-165) for tying /tightening wire mesh complete all as specified and directed.

Excavating in any type of soil in post holes (or similar holes) each n exc 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25cm, watering, and removing surplus soil to a distance n exc 50 m and making good surface

Demolition cement concrete (unreinforced) of any description or any position all as directed.

M&L in repair for providing precast cement concrete louvers and jallies, 35 mm thick type B- 0, 1:2:4 using 12.5mm graded stone aggregate (measured solid) including all moulding and necessary form work and set in cement mortar 1:4 fixed in repairs complete all as specifed and as directed.

S&F precast RCC coping/post of size 600x100x50 mm suitable for fixing of RCC Jallies in vertically & horizontally including necessary moulds and grooves as required in shape and size complete all as specified and directed.

M&L providing cement concrete 1:2:4 Type B-0 (Using 12.50 mm graded stone aggeregage ) set in CM 1:6 Size as per site requirement as in lintels upto 1.5m clear span, cills, steps; seismic and other similar bands, plinth courses, string courses, lacing courses, parapets and railings upto 60 cm in height, copings, Kerb stone, kneelers, apex stones, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles and throating incl necessary form work etc complete all as specified and directed by Engineer in Charge.

M&L for preparation of new stone/ concrete surface of any description over 10cm girth or width, not otherwise described and applying two coat of synthetic enamel paints over priming paint plaster complete all as specified and directed.

S & F of Tie bars with screwed ends, nuts, washers and mild steel plates for walls, chimneys, roofs, arches, etc. king rods and straining bolts conforming to Fe- 290 Gde-E-165

M&L for cement concrete in foundation fillings and mass concreting type C-2 (1:3:6 ) using 40mm graded agg as in manholes foundation. complete all as specified and directed by engr- in -charge

M/s Shubh Enterprises

Simran construction Company

VIKRANT CONSTRUCTION CO.

Akhil Enterprises

ASHUTOSH BUILDERS

Baljeet Builders & Interior Decorators

S GOURAV PRAKASH ENTERPRISES

Akarsha Enterprises