Repair/Maint to drain compound wall fencing, hardstanding etc in the area of AGE B/R-II under GE Gaya at Mil Stn Gaya

Amount

Demolition of brick work or stone/boulder masonry built in cement mortar including all quoins, arches, pillars etc complete all as specified and directed.

Demolition of cement concrete in drain paving etc. not exc. 15 cm thicknes above or below ground level.

Excavation in trenches not exc 1.5m wide and not exc 1.5m in depth for foundation etc or for shafts, wells, cesspits, manholes pier holes etc not exc 10 sqm on plan and not exc 1.5m in depth and getting out in soft/loose soil etc complete.

Returning, filling in, incl spreading, levelling, watering & well ramming in layers n. exc 25 cm in soil.

Removing excavated soil to a distance n exc. 50m & depositing where directed at a level n exc. 1.5 m above the starting point

Removing demolished material exc 250 mtr but n exc 500 mtr and deposited where directed rubbish materials all as specifed and directed.

M & L Brick work with sub class 'B' bricks straight or curved on plan exc 6 m mean radius built in cement mortar (1:4) complete all as specified and directed by EIC

M&L Brick work except Bricks straight or curved on plan exc 6m mean radius built in cement mortar 1:6 complete all as specified and directed.

M & L Plain cement concrete type C-2 (1:3:6) using 40mm graded stone aggregate as in surface channel & drain complete all as spd and directed by Engr-in-Charge.

M&L Rendering 15mm thick on brick wall or concrete surface in cement mortar (1:4) finished even and fair without using extra cement complete all as specified and directed by Engineer-In- Charge.

M&L Rendering 10mm thick on brick wall or concrete surface in cement mortar (1:4) finished even and smooth with using extra cement complete all as specified and directed by Engineer-In- Charge.

M&L Extra for forming fair finished drain or channel 30cm inner girth in cement concrete using extra cement etc complete.

Demolition and breaking up drain pipe (salt glazed stone ware,AC or reinforced concrete ) set in cement mortar for 100 mm internal dia of pipe complete all as specified and directed.

M & L Reinforced concrete pipes, class NP2, laid and jointed complete with collars bore of pipe 450mm complete all as spfd and directed.

M&L Formwork to sides of concrete foundations, footings, bases of columns, raft and raft beams, sides and soffits (if any) of foundation and plinth beams;and similar work;vertical or to batter

M&L Formwork to sides of pillars,posts, struts, piers, columns and stanchions all as specified and directed

M&L Formwork to rough finished flat surface of concrete to sides and soffits of floor or roof beams, beam haunchings, lintels, cantilevers, shelves incl supports, overhangs, etc. complete as all spfd and directed.

M&L PCC (1:4:8) type D2 (using 40mm graded stone aggregate) in foundations, filling and mass concrete complete all as specified and as directed.

M&L RCC (1:2:4) type B1 (using 20mm graded stone aggregate) Foundations, including rafts, footings, foundation beams; plinth beams; bases for columns, etc.; basement slabs, under-reamed piles and mass concrete as per directed.

M&L RCC (1:2:4) type B1 (using 20mm graded stone aggregate) in Columns, pillars, piers, posts as per directed by Engr-in-Charge.

M&L RCC (1:2:4) type B1 (using 20mm graded stone aggregate) in beams, cantilevers, bressummers, lintel etc.

Demolition of cement concrete reinforced in any position complete all as specified and directed.

S & F PVC (SWR) pipes 110 mm bore single socketed in any length with rubber ring joints fixed to walls as in repair

S&F PVC (SWR) bends 110 mm bore any radius

S & F PVC (SWR) pipes 110 mm bore single socketed in any length with rubber ring joints laid in trenches or in floors as in repair

M&L Precast cement concrete (1:2:4) type B1 using 20 mm graded stone aggregate as in landings, cover slab (for manholes , drain cover etc) and similar work including necessary form work and set in CM (1:6) complete all as specified and directed. Note :- Reinforcement shall be measured and paid separately.

M&L Mild steel TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips .

M&L Mild steel TMT bars 6 to 8 mm dia and over cut to lengh bent to shape required including cranking bending spirally for hooping for columns hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or or securing clips.

M&L Providing precast cement concrete louvers and jallies 35mm thick solid including all moulding incl frame of pcc (1:2:4) type B0 (12.5mm graded aggregate) crushed stone & set in CM 1:6 coplete all as spfd & directed. Note- Reinforcement shall be measured and paid separately , the precast jali shall have even & smooth finished in one side & even & fair on other side .

M&L Two coats of cement based paint including preparation of newly plastered surfaces complete all as specified and directed by Engr-in-Charge

M&L One coat of cement based paint including preparation of old plastered surfaces complete all as specified and directed by Engr-in-Charge

Dismantling structural steel work including doors, gates but excluding framed truss etc.

S&F Ornamental & intricate framed work such as grilled ,gates including pintle hinge , stops , hand made sliding bolt etc with ends of bar should and /or reveted or forged into spikes , framed gard bar barred iron door ladders, framed balustue , railing and similar works conferming to Fe 290 grade E-165 as specified and directed

M & L Two coats of syntetic enamel paint over new steel surface of any description over 10cm in width or grith not otherwise described over one coat red oxide primer including preparation of surfaces complete.

M & L Sand filling under floors are in foundation including watering and consolidation.

M & L 75mm thick cement concrete type D2, PCC (1:4:8) (40mm graded stone aggregate) as in path/hardstanding as directed by Engr -in -charge

M & L Machine pressed precast concrete interlocking paver block coloured rubber moulded with grey cement and pigment any shape and size conforming to IS 15658-2006 of 60 mm thickness M-35 Grade complete all as specified and directed.

M&L PCC (1:2:4) Type B1 (using 20mm graded stone aggregate) as in copings,kerbs and like incl weathering slightly rounded or chamfered angles and throating as directed

Supply only Chain link MS galvanisd fencing, any size or type. Note : Fixing of chain link fencing will be measured seperately

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire

S&F as in repair Galvanised. 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. as directed (each line wire to be measured) as directed

Clearing & removal of all blockage in sewage line of any dia of sewer lines, manholes of any section and any depth, in any situation by way of cleaning / desludging foreign materials as well as blockage of sewage line in between successive manholes mechanically by RIDGID K-1500G W/C-14 Sectional Drain Cleaning Machine (by deploying the Skilled and unskilled manpower to handling this machine) including desludging of manhole /sewage line where required and odered by Engineer-in-charge and keeping sewer line functional, upto final drop/outlet into septic tank /central sewage system terminating in other joining zone/ area or into sewage wells complete all as specified. Note :- (a) Contractor shall detail his supervisor to office of AGE B/R Gaya daily by 9.00 AM who will report to concerned JE B/R/Engineer-in-Charge to receive complaints under this job. (b) Contractor shall provide service providers (minimum Skilled 1 No and unskilled 02 Nos manpower) for cleaning of sewage line with RIDGID K-1500G W/C-14 Sectional Drain Cleaning Machine alongwith all requisite tools, equipments, including safely measures for attending complaint and ensure completion report by 5.00 PM same day. (c) In case any complaints pertaining to clearing of blockage in sewage line is not removed/cleared the same shall not be taken into measurement and no payment shall be claimed on that part of sewage line. (d) Fuel for the machine shall be included in the quoted rates of cleaning of sewage line by the contractor and no addn claim on account of fuel will be paid to the contractor. (e) Repair/ Replacement of any damage parts only through OEM of the RIDGID K-1500G W/C-14 shall also be included in the quoted rates. (f) Machine will be issued to contractor with no cost basis for cleaning purpose on daily basis from MES Store Yard Gaya and transportation from MES store Yard to working site shall also be included in the quoted rates. The machine should be returned to MES Store Yard in working condition and any cost on this to be borne by the contractor.

RAMRAS BUILDERS

M/S SANJAY KUMAR YADAV