FOR CONSTRUCTION OF PARKING SHED AND OTHER MISC CIVIL WORK AT OFFICE OF THE CE (LUCKNOW ZONE) INDRALOK HYDLE COLONY, KRISHNA NAGAR LUCKNOW

Amount

Excavation in foundation in ordinary soil (Loam clay or sand) including lift upto 1.5 mtr. and lead upto 30 m and including filling watering and ramming of excavated earth into the trenches or into the space between the building and sides of the foundation trenches or in to the plinth and removal and disposal of surplus earth as directed by the Engineer-in-Charge upto a distance of 30 m from the foundation trenches.

Concrete with 4 cm. gauge 1st class brick ballast (Class 150) coarse sand (F.M. 1.8 to 2.5) and cement in proportion of 12:6:1 in foundations and under floors including supply of all materials, labour and T&P etc. required for proper completion of work.

Cement concrete with 2cm gauge approved hard stone ballast, coarse sand (F.M. 1.8 to 2.5) and cement in proportion of 3:1.5:1 including supply of all materials, labour,side shuttering if required and T&P etc. required for proper completion of work (CSI No. 5.21)

Mild Steel or Iron work in heavy sizes such as trusses built up gates, door frames, record, racks roof work gates etc. wrought to required form including holes rivetting or welding where necessary and also fixing in proper position and alignment including cost of all materials supplied by contractor.

Painting or varnishing new iron work in small areas or new wood work with one coat of ready mixed priming paint and two coat of approved superior quality ready mix paint "Luxol" or equivalent brand or varnish including supply of all materials, labour and T&P etc. required for proper completion of the work. Paint to be used should conform to the I.S. 103-1950.

Disposal of rubbish/debris out side the Board’s area as per direction of Engineer-in-charge including cartage, labour and materials, T&P etc. required for proper completion of the work. (No. deduction for voids shall be made).

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

Engaging of labour for misc. civil works with required T&P

1 GST Will paid only extra as applicable. 2 Quantity of individual item may increase or decrease to any extent as per site condition 3 Dismantling item work if recovery required it deducted from contractor bill’s 4 All the item rates including labour cess, no extra payment shall be done.

Mohd shahid