A/R M/O Non Residential building under Sub Division No.II, NACD, APWD, Mayabunder. SW Outer painting Micro Concreting on roof slab for water tank of camp office cum residence of DC NMA including Guard Room and hut.

Amount

Painting with synthetic enamel paint of approved brand and manufacture of required colour to give an even shade :

One or more coats on old work

Distempering with 1st quality acrylic distemper (ready made) having VOC content less than 50 gm per ltr. of approved manufacturer and of required shade and colour complete. as per manufacturer's specification.

One or more coats on old work

Finishing walls with Acrylic Smooth exterior paint of required shade :

Old work (One or more coat applied @ 0.90 ltr/10 sqm).

Melamine polishing on wood work (one or more coat).

Renewing glass panes and refixing existing wooden fillets:

Float glass panes of nominal thickness 5 mm (weight not less than 12.5kg/sqm)

Surface preparation to micro concret by chipping to depth of maximum 75mm cleaning removing the traces of dust, loose concrete including the cost of labour charges, minor tools etc. complete.

Supply and application of epoxy concrete bonding agent (confirming to and having BIS 6319 certification) and over clean and properly prepared old concrete surface to give good bonding between old and new concrete, including cost of all materials minoe tools etc.

Supplying and fixing foam work and shuttering to receive the micro concrete including cost of all materials, all labour charges, minor tools etc. complete.

Supplying, mixing and applying curing membrane or equivalent with water including cost of all materials, all labour charges, minor tools etc. complete.

Supplying and applying high strength non shrink cementinous free flow concrete (with minimum 28 days flexural strength 50kg/sq.cm and compressive strength 500 kg/sq.cm as per BIS 4551-80) for above water level on site to enable completion of pouring in a continous operation. An approved grout concrete mixture of slow speed heavy duty drill and exact quantity of water as recommended should be poured into the vessel slowly and mix the same throughly in a forced action. The mix materials should be placed immediately to position foam work continously to an average thickness of 50mm without any gap including all materials and labour charges etc. complete.

S.KOODA LINGAM

S B SHARMA

RAM KISHAN