Maharajganj- Construction of Jay Prakash Narayan Sarvoday Vidyalaya (A.T.S.) Maharajganj (Balance Work of Dormitory)

Amount

Materials

Supply of P.P.C. Cement (ACC, Birla, Prizm)

Supply of Coarse Sand (Koilawar)

Supply of 10mm thick Dhaulpur chips (Red/yelow Color)

Supply of Color Pigment (Red/yelow Color)

Cinder filling in sunken portion

Supply of 25mmØ PVC Curring Pipe

Supply of White cement birla, J&K 50kg/bag

20mm guage stone grit Jhasi

1st class brick batt

40mm brick ballast

25 to 50mm Stone ballast

Supply of Local Sand

Supply of 1st class brick

Kota stone slabs 20-25mm thick

Providing & fixing white vitreous china water closet squatting pan 1SI marked (Indian type W.C. pan ) with 100 mm. Sand cast iron P or S trap. 10/12.5 litrs. PVC low level flushing cistern with fittings & brackets 40mm dia. C.P. flush pipe with fitting & clamps, 20mm overflow pipe with specials and mosquito proof coupling of approved municipal design, including painting of fittings and brackels, cutting & making good the walls & floors wherever required: a)White Vitreous china Orissa pattern W.C. pan of size 580x440 mm with integral type foot rests

Providing and fixing white viterous china pedestal type water closet (europen type) with seat and lid, 10 litre low level flusingcistem with fittings &C.I/M.S Brakets 40mm fluse bend arrangment with special of standard make and mosqiito proof coupling of approved design complete including painting of fitting and brackets , cutting and making good the walls and floors where ever required .Confirming to IS : 7231, Parryware, /Hindware/ Seabird/Orient(Coral) W.C. pan with ISI marked white solid plastic seat

Providing & fixing white vitreous china wash basin with C.I. brackets painted white, 15 mm C.P. brass pillar taps, C.P. brass chain with rubber pług,l 32mm C.P. brass waste of standerd pattern including cutting & making good the walls wherever required. a)Flat back wash Basin size 550x400 mm with single 15 mm OC.P. brass pillar tap.

Providing & fixing white vitreous china flat back or wall corner type lipped front urinal basin of 430x260x350 mm and 340x410x265 mm sizes respectively with automatic flushing cistern with C.I. /M.S. brackets standard flush pipe and C.P. brass spreaders with brass unions and G.I. clamps complete, including painting of fittings and brackets, cutting and making good the walls and floors wherever required: Range of two urinal basins with 5 litre P.V.C. automatic flushing cistern.

Providing and fixing one piece construction white vitereous china squating plate with an intregral longitudinal flushing pipe white P.V.C. automatic flushing cistern with fittings standerd size G.I.flush pipe for back and front flush with standerd spreader pipe with fittings G.I.clamps and C.P. brass coupling complete. including painting of fittings and brackets, cutting and making good the walls and floors wherever required: Single squating Plate with 5 litre P.V.C. automatic flushing cistern

Providing and fixing Stainless Steel A ISI 304 (18/8) kitchen sink as per IS: 13983 with C.I. brackets and stainless steel plug 40 mm, including painting of fittings and brackets, cutting and making good the walls wherever required: Kitchen sink with drain board

Prividing&Semirigid P.V.C. waste pipe for sink, wash basin & urinal basin including PVC waste| fittings complete. a) 32mm dia

OIL WASTE & VENT PIPES AND FITTINGS - II Providing & fixing soil. waste and vent pipes Providing and fixing on wall face unplasticised Rigid PVC soil and wasle water plpes conforming to IS : 13592 Type B including jointing with seal ring conforming to IS : 5382 leaving 10 mm gap for thermal expansion . (I) Single socketed pipes. a) 110mm dia P.V.C. pipe

b) 75mm dia P.V.C. pipe

Providing & fixing UPVC Floor trap of self cleansing design with CP Jali complete in all respects. (Make : Supreme / Finolex / Prince) P-Trap type Floor Trap 110 x 110 mm

Providing and fixing terminal guard. a) 110mm

Providing and fixing on wall face unplasticised PVC moulded fittings/accessories for unplasticised Rigid PVC pipes including jointing with seal ring leaving 10 mm gap for thermal expansion. 110mm bend

75 mm bend

Providing and fixing 600 x 450 mm bevelled edge mirror of superior glass (of approved quality). complete with 6 mm thick hard board ground fixed to wooden cleats with C.P. brass screws and washers complete.

Providing and fixing PTMT towel rail complete with brackets fixed to wooden cleats with CP brass screws with concealed fitting arangement of approved quality colour and make (Prayag or equivalent). 600mm long toweł rail with total length of 645mm width 78mm and effective height of 88mm, weighing not less than 190gms.

Providing and fixing heavy quality stainless steel jali (grating) with or without hole for waste pipe for floor /nahani trap.

Providing & fixing 32 # G.I. Pipes spout including curing & making good the walls etc.

WATER SUPPLY PIPES AND FITTINGS-III Providing and fixing G.I. Pipes complete with G.I. fittings and clamps, i/c making good the walls etc. concealed pipe, including painting a) 15mm nominal bore.

b) 20mm nominal bore.

Providing & fixing G.I. Pipes complete with G.I. Fittings including trenching and refilling etc. (External work) b) 20mm nominal bore.

c) 25mm nominal bore.

d) 32mm nominal bore.

Painting G.I. Pipes and fittings with synthetic enamel white paint over a ready mixed priming coat, both of approved quality for new work. 20mm diameter pipe

25mm diameter pipe

32mm diameter pipe

Providing and fixing ISI Marked CP brass bib cock 15mm with flange of approved quality including threading the pipe etc. for completion of work. a) short body bib cock

b) long body bib cock

Providing & fixing brass full way valve with C.I. Wheel of approved quality (Screwed end)a) 15 mm nominal bore.

b) 25 mm nominal bore.

Providing and fixing ISI marked C.P. brass angle valve 15 mm with flange of approved quality including threading the pipe etc. for completion of work a) 15 mm nominał bore

Providing and fixing 45 cm long unplasticised PVC connection pipc with brass unions. a) 15 mm nominal bore

Making connection of G.I. Distribution branch with G.I. Main of following sizes by providing and fixing tee including cutting and threading the pipe etc. 25 to 40mm nominal bore

Providing and fixing G.I. Union in G.I. Pipe including cutting and threading the pipe and making long screws etc. complete (new work) 15mm nominal bore

20mm nominal bore

25mm nominal bore

32mm nominal bore

Providing and placing on terrace (at all floor levels) polyethylene water storage tank, ISI : 12701 marked, with cover and suitable locking arrangement and making neçessary holes for inlet, outlet and overflow pipes but without fittings and the base support for tank.

LABOUR RATE 30% Labour Charge in Sanitory & Water Supply on cost of Material Washed stone grit plaster on exterior walls height upto 10 metre above ground level, in two layers , under layer 12 mm cement plaster 1 : 4 (1 cement : 4 coarse sand) , furrowing the under layer with . scratching tool , applying cement slurry on the under layer @ 2Kg of cement per square metre , top layer 15 mm cement plaster 1 : 1 / 2 : 2 ( 1 cement : 1 / 2 coarse sand : 2 stone chipping 10 mm nominal size) , in panels with groove all around as per approved pattern , including scrubbing and washing the top layer with brushes and water to expose the stone chippings , complete as per specification and direction of Engineer-in-charge (payment for providing grooves shall be made separately)

15mm cement plaster on the rough side of single or half brick wall of mix 1:6 ( 1cement 6 finc sond )

15mm cement plaster on the rough side of single or hall brick wall of mix :1:6 (1cement : 6 fine sand)

12mm cement plaster of mix : 1:4 (1cement 4 fine sand)

Add for plaster drip course / groove in plastered surface or moulding to . C . C . projections .

20 mm thick cement plaster 1:3 c: c/s mortar with N.C.F.

10mm cement plaster 1:3 c: c/s mortar

15mm cement plaster on rough side oll single or halt brick wall of mix : 1:4 (1 cement : 4 coarse sand )

Sand Filling Underfloor

Providing and applying white cement / based putty of average thickness 1mm , of approved brand and manufacturer . lover the plastered wall surface to prepare the surface even and smooth complete .

FLOORING Kota stone slabs 20-25mm thick in risers of steps , skirting , dado and pillars laid on 12 mm (average ) thick cement mortar 1 : 3 ( 1cement : 3 coarse sand ) and jointed with grey cement slurry mixed with pigment to match the shade of the slabs , including rubbing and polishing complete . (Dormitory & School Building)

Providing and fixing 18mm thick gang saw cut , mirror polished , premoulded and prepolished , machine cut for kitchen platforms , vanity counters , window sills , facias and similar locations of required size , approved shade , colour and texture laid over 20 mm thick base cement mortar 1 : 4 (1cement : 4coarse sand ) , joints treated with white cement , mixed with matching pigment , epoxy touch ups , including rubbing , curing , moulding and polishing to edges to give high gloss finish etc . complete at all levels

Brick edging7 cm wide 11 . 4cm deep to Iplinth protection with bricks of class designation 75 i/c grouting with cement mortar 1 : 4 (1cement : 4 fine sand )

MISCLANEOUS WORK Making khurras 45x45cm with average minimum thickness of 5cm cement concrete 1 : 2 : 4 (1cement : 2 coarse sand : 4graded stone aggregate of 20mm norminal size ) over P . v . c . sheet 1mx1mx400 micron , finished with 12mm cement plaster 1 : 3 ( 1 cement : 3 coarse sand ) and a coat of neat cement | rounding the edges and making and finishing the outlet complete .

Making drain around apron

Providing and fixing on wall face unplasticised Rigid PVC rain water pipes conforming to Is : 13592 Type A , lincluding jointing with seal ring conforming to Is : 5382 , leaving 10 mm gap for thermal expansion, (i) Single socketed pipes . 110mm diameter

Cinder filling in sunken portion

Providing and fixing of expansion joint system related with floor location as per drawings and direction of Engineer - In Charge . The joints system will be off extruded aluminum base members , self aligning / self centering arrangement and support plates etc . as /per ASTM B221 - 02 . The system shall be such that it provides floor to floor / floor to / well expansion control system for various , vertical locations in load application / areas that accommodates multiy directional seismic movement without stress to it ' s components . System shall consist of metal profiles with a universal aluminum base member designed to accommodate various project conditions , and finish floor treatments . The cover plate shall be designed of width and thickness required to satisfy projects movement and loading requirements and secured to base members by utilizing manufacturer ' spre engineered self - centering arrangement that freely rotates moves in all directions . The Self - centering arrangement shall exhibit circular sphere ends that lock and slide inside the corresponding aluminium extrusion cavity to allow freedom of movement and flexure in all directions including vertical displacement . Floor Joint of 100mm gap

WATER PROOFING Providing and laying " Brick coba " 120mm th . Laid with M 150class brick ball coba 7 . 5 cm thick with gap of 15 mm to / each other over 20 mm th . base off cement mortar 1 : 4cement and coarsel sand mixed with water proffingt compound spreading cement slurry, mixed with . acrelic cement concrete water proffing compound filled gaps of coba & top of coba mortar mixed with water profing compound in 1:4 cement and coarse sand mortar finished smooth and top mashed false square 30 cm x 30cm and side wall parapet shall be monolythic plaster wall up to 30 cm higher and junction and corner shall be rounded by brick ballast cement and coarse sand masonary coba with top finished plaster mixed with acetic water

Providing and laying water proofing treatment in sunken portion of WCs, bathroom etc., by applying cement slurry mixed with water proofing cement compound consisting of applying : a ) First layer of slurry of cement @ 0.488 kg / sqm mixed with water proofing cement compound @ 0 . 253 kg / sqm . This layer will be allowed to aircure for 4 hours . b) Second layer of slurry of cement @ 0 . 242 kg / sqm mixed with water proofing cement compound @ 0.126 kg / sqm . This layer will be allowed to air cure for 4 hours followed with water curing for 48 hours . The rate includes preparation of surface , treatment and sealing of all joints , corners , junctions of pipes and masonry with polymer mixed slurry.

M/S BHAGWAN CONSTRUCTION