Loading
Loading…
Loading…
Tender Value
₹2.4 Cr
EMD Value
₹4.8 L
Closing Date
7 Aug 2026, 5:15 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
Above/Below/Par
GENL
15 conditions · 4 needing a document upload
The tenderer must have minimum average annual contractual turnover of V/N or V whichever is less, where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited (for details correction slip no. 01 vide L. No. 2022/CE-I/CT/GCC 2022/Policy dt. 4.07.2022 to be referred.) The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Annexure-VIB, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.(For details pl. refer GCC April 2022 with amendment, if any)
The Bid Security shall be deposited either in cash through e-payment gateway or submitted as Bank Guarantee bond from a scheduled commercial bank of India or as mentioned in tender documents. The Bank Guarantee bond shall be as per Annexure VIA and shall be valid for a period of 90days beyond the bid validity period(For other details GCC april 2022 para 5 of part -I to be referred with amendment,if any)
(a)The tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works each costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works each costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender.(For details pl. refer GCC April 2022 with amendment ,if any)
Manufacturing of High Mast or Flood Light Tower" OR "Supply, erection, testing and commissioning of flood light/high mast towers/HT/LT power supply distribution system/street lighting/station lighting/tunnel lighting. OR "AMC of flood light/high mast towers/HT/LT power supply distribution system/street lighting/station lighting/tunnel lighting." O R "Repair and Maintenance of flood light/high mast towers/HT/LT power supply distribution system/street lighting/station lighting/tunnel lighting
19 conditions · 12 needing a document upload
FOR DOCUMENT TO BE SUBMITTED BY THE TENDERER FOR TENDER ALONG WITH THE OFFER. OFFERS WITHOUT THESE DOCUMENTS WILL BE SUMMARILY REJECTED as detailed given in checklist of tender booklet attached in document.
Tenderer should submit copy of PAN Card along with their tender.
The Tenderer shall submit copy of Goods and Services tax (GST) Registration Certificate containing GST Registration Number.
Following documents shall be submitted by the tenderer: (a) Sole Proprietorship firm : An undertaking on suitable stamp paper to this effect clearly mentioning PAN number.
Following documents shall be submitted by the tenderer: (b) HUF : (i)A copy of notarized affidavit on Stamp Paper declaring that he who is submitting the tender on behalf of HUF is in the position of 'Karta' of Hindu Undivided Family (HUF) and he has the authority, power and consent given by other members to act on behalf of HUF. Note - 1. For Partnership firm/Hindu Undivided family(HUG)/Limited Liability Partnership (LLP) etc Name of constituent partner should be mentioned in point no. 1 of Annexure V(A).
Following documents shall be submitted by the tenderer: (c) Partnership Firm : (i) A notarised copy of partnership Deed or Copy of Partnership deed registered with the Registrar. (ii) A notarized or registered copy Power of Attorney in favour of the individual to tender for the work, sign the agreement etc. and create liability against the firm. (iii) An undertaking by all partners of the partnership firm that they are not blacklisted or debarred by Railways or any other Ministry / department of the Govt. of India from participation in tenders / contracts as on the date of submission of bids, either in their individual capacity or in any firm/LPP in which they were/are partners/ members. Note - 1. For Partnership firm/Hindu Undivided family(HUG)/Limited Liability Partnership (LLP) etc Name of constituent partner should be mentioned in point no. 1 of Annexure V(A).
Following documents shall be submitted by the tenderer: (d) Company registered under Companies Act-2013 : (i) The copies of MOA (Memorandum of Association) / AOA (Articles of Association) of the company (ii) A copy of Certificate of Incorporation (iii)A copy of Authorization/Power of Attorney issued by the Company (backed by the resolution of Board of Directors) in favour of the individual to sign the tender on behalf of the company and create liability against the company
Following documents shall be submitted by the tenderer: (e) LLP (Limited Liability Partnership ) registered under LLP Act 2008: (i)A copy of LLP Agreement (ii)A copy of Certificate of Incorporation (iii)A copy of Power of Attorney/Authorization issued by the LLP in favour of the individual to sign the tender on behalf of the LLP and create liability against the LLP. (iv)An undertaking by all partners of the LLP that they are not blacklisted or debarred by Railways or any other Ministry / Department of the Govt. of India from participation in tenders / contracts as on the date of submission of bids, either in their individual capacity or in any firm/LLP or JV in which they were / are partners/members. Note - 1. For Partnership firm/Hindu Undivided family(HUG)/Limited Liability Partnership (LLP) etc Name of constituent partner should be mentioned in point no. 1 of Annexure V(A).
Following documents shall be submitted by the tenderer: (g) Registered Society & Registered Trust: (i)A copy of the Certificate of Registration (ii)A copy of Memorandum of Association of Society/Trust Deed(iii)A copy of Power of Attorney in favour of the individual to sign the tender documents and create liability against the Society/Trust. (iv)A copy of Rules & Regulations of the Society
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
Provision of 20 High masts at 10 stations. (AMLA-1, NRKR-1, KOHL-2, KLBA-2, NGP- 4, AJNI-2, SEGM-3, YNA-1, BUPH-2 & DEOLI-2)
NGP-L-2026-T-30
NGP-L-2026-T-30
Open
Works - General
12 Months
Nagpur, Maharashtra
₹0
₹4.8 L
7 Aug 2026
14 Jul 2026
24 Jul 2026
31 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 2,39,42,946.3 | ||
| — | 20.00 | — | — | ||
| Supplying and erecting 25 m (clear height) High Mast (Top-150mm,Bottom- 540mm) with lowering and raising motorized unit, lantern carriage assembly suitable for max. 12 nos. luminaries and its control gear box, lightning finial arrangement for fixing aviation light and foundation bolts on provided foundation as per specification(excluding luminaries). | — | — | — | 90,88,329.2 | |
| — | 20.00 | — | — | ||
| Making M-20 cement concrete foundation by considering the safe soil bearing capacity at site as 10 T/sq. m at 2 m depth including excavation and fixing provided nut bolts with the help of template, duly plastered as per design complete (for 25 m raising lowering high mast). | — | — | — | 9,56,117.8 | |
| — | 20.00 | — | — | ||
| Supplying and erecting Outdoor Stand Mounted Feeder Pillar for high mast of the same manufacturer with 63A TPN MCB incomer, single dial timer switch, 45A TP contactor for automatic switching of luminaries, 2 no's 9A contactors and raise/lower push button, and provision for termination of adequate size of incoming and outgoing cables erected in min. 14 SWG CRCA sheet box powder coated with supporting angles, self-lock, gasket and slanting top erected with CC foundation complete. | — | — | — | 6,52,738.6 | |
| — | 240.00 | — | — | ||
| SETC of 400 Watts flood light IP 65 LED fitting complete with all accessories & mounting arrangement as per site requirement | — | — | — | 60,95,284.8 | |
| — | 5000.00 | — | — | ||
| SETC of LT XLPE insulated, Armoured, PVC sheathed Alluminium Conductor cable with aluminium lugs, glands suitable nut bolt etc. 4 Core 25 Sq. mm | — | — | — | 12,57,950 | |
| — | 2000.00 | — | — | ||
| SETC of LT XLPE insulated, Armoured, PVC sheathed Alluminium Conductor cable with aluminium lugs, glands suitable nut bolt etc. 4 Core 50 Sq. mm | — | — | — | 8,44,060 | |
| — | 3000.00 | — | — | ||
| Provision of trench in all kind of normal Soil to depth 40x100cm & filling the trench (After laying cable) to bring the original condition. | — | — | — | 2,81,820 | |
| — | 4000.00 | — | — | ||
| Provision of trench in hard rock/soil/road track crossing to depth 40x100cm & filling the trench (After laying to bring the original condition. | — | — | — | 8,19,280 | |
| — | 6000.00 | — | — | ||
| Supply and laying of 50mm HDPE Pipe, Material grade PE:100, PN:20, Conforming to IS 4984:2016. | — | — | — | 9,11,220 | |
| — | 1000.00 | — | — | ||
| Supply and laying of 75 mm HDPE pipe, material grade PE:100, PN:8, Conforming to IS 4984:2016. | — | — | — | 2,20,000 | |
| — | 160.00 | — | — | ||
| Cable trench by horizontal drilling and supply & laying of cable in HDPE pipe as per specification. | — | — | — | 10,15,771.2 | |
| — | 70.00 | — | — | ||
| Provision of maintenance free earthing as per RDSO specification no. RDSO/PE/ SPEC/ PS/0109- 008(REV'0') complete. | — | — | — | 10,15,545.3 | |
| — | 350.00 | — | — | ||
| Supply and laying of GI earthing strip, 25 x 4 mm with PVC sleeve -The price shall cover for supply and laying of G.I. earthing strip of 25 x4 mm size covered with black coloured PVC sleeve of superior quality from earth pit to control/distribution panel board. The earthing strip when laid on wall shall be fixed by means of suitable size of GI clamps and screws. | — | — | — | 25,886 | |
| — | 20.00 | — | — | ||
| Provision of Pole mounting type MS junction box size 300 x 200 x 125 mm deep, shall be double doors, outdoor type, weather proof with degree of protection no less than IP54 and conforming to IS:8623 & IS:13032, suitable for operation on single phase, 230 volts Ac 50 Hz supply system. The junction Board shall be manufactured with CRCA sheet steel 1:6 mm thick, duly powder coated and complete with 4 pole termination arrangement and earthing studs etc. Outer door shall be hinged on top in vertical formation,with provision of holding arrangement horizontally. The front cover of the junction box shall be provided with a lock which can be opened with a special key. | — | — | — | 1,28,943.4 | |
| — | 10.00 | — | — | ||
| SETC of MDB outdoor type consisting of 1x63 A FP MCCB for incoming with 3 phase and neutral copper bus bar of suitable size and 2x32 A FP MCB, 2x25A FP MCB for outgoing complete as per specification. | — | — | — | 6,30,000 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Annexure-VA1.pdf
ATTACHMENT
TENDERBOOK_1.pdf
ATTACHMENT
GCCwithcorrection.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .