SPECIAL REPAIR TO APPROACH PATH AT WATCH TOWER AT BASE HOSPITAL, PROVISION OF CHAIN LINK FENCING INFRONT OF BASE HOSPITAL AND PROVISION OF BARBED WIRE FENCING WITH MS SWAN NECK ABOVE EXISTING BOUNDARY WALL OF DEPOT AREA FMSD AT BASISTHA AND PROVN OF

Amount

M&L Site development/area filling with approved earth to be obtained from outside MOD land and filling including raising (or lowering) soft/loose earth, spreading in layers not exc. 30cm thick, watering, ramming/rolling with power roller (8 to 10 Tonne) and finishing to required size, shape, etc, to any heigth from original ground level complete all as specified and as directed. NOTE: - (i) Payment shall be done on the basis of compacted thickness as defined in MES SSR 2020 (Part II) Clause No 3.6 (ii) All cost of procurement of earth including cost of transporation, royalities, taxes etc shall be deem to be included in the Unit Rate Quoted. (iii) Quoted rates are inclusive of necessary surface dressing including removing of surplus soil as directed

Demoliation of cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and as directed.

M&L for PCC (1:4:8) type C-2 (using 40 mm graded stone aggregate) as in in foundations, filling and mass concretecomplete all as specified and as directed.

M&L for PCC (1:3:6) type C-2 (using 40 mm graded stone aggregate) as in surface channels and drain complete all as specified and as directed.

Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc.complete all as specified and as directed.

Add to or deduct for each 25 mm girth or part thereof over or under 30cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc. complete all as specified and as directed. Note:- Rate quoted is for adjustment of rate only for the actual size excuted at site for the item no 5 mentioned as above

Demolition of brick work or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars etc. complete all as specified and directed.

M&L brick work with sub class 'B' bricks, old size bricks, straight or curved on plan exceeding 6m mean radius built in cement mortar (1:6) complete all as specified and directed.

M&L Sand filling under floors or in foundations including watering and consolidation complete all as specified and directed.

M&L Hardcore of gauge n exc. 63 mm, using broken stone or boulders, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed.

M&L 100mm thick PCC (1:3:6) type D-2 (using 40mm graded stone aggregate) as in floor finished even and fair complete all as specified and as directed.

M&L providing plain cement concrete type B-0, (1:2:4), (using 12.5 mm graded stone aggregate), as in Coping, kneelers, apex stones, bed plates, water troughs and the like including weathering, slightly rounded or chamfered angles & throating as directed including necessary form work as required complete all as specified and directed.

S&F Machine pressed precast coloured concrete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade complete all as specified and as directed.

M&L 600mm bore Reinforced concrete pipes, class NP2, laid and jointed complete with collars including dismantling the existing unservicable pipe complete as required and as directed.

Dismantling and taking out fencing post of any description and in any position including taking out embeded portion from natural ground and making good disturbed surface of site complete all as directed.

Dismantling and taking out fencing post of any description and in any position including taking out embeded portion from concrete or massonry work and making good disturbed surface complete all as directed.

M&L Providing reinforced cement concrete type B-l, 1:2:4 (20 mm graded aggregate) in precast posts, fencing posts, straining or terminal posts, struts etc. for fencing, average sectional area exc 100 sq. cm and exc 250sq.cm, with or without chamfered angles and flat, splayed, rounded or mitred tops complete all as specified and as directed.

S&F posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, etc.; flat iron fillets (for securing wire mesh etc.) including all necessary drilling, bolting or riveting, etc., and similar work conforming to Fe-290 Gde E-165 including necessary preperation of surfaces and appllying a coat of red oxide zinc chrome primer complete all as specified and as directed.

S & F mild steel TMT bars 10mm dia and over cut to length, bent to shape reqd including cranking, bending, spirally for hooping for columns hooking ends and binding with MS wire (annealed) not less than 0.9mm dia all as specified and as directed

S & F mild steel TMT bars 5mm dia and over upto and including 10mm dia as in stirrups and binders and binding with MS wire (annealed) not less than 0.9mm dia all as specified and as directed

M&L PCC (1:3:6) type C-2 (using 40 mm graded agreegate) as in foudation, Mass concrete for post etc and in similar works etc. complete all as specified and as directed

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provision of binding wirecomplete all as specified and as directed. Note: Chain link fence will be measured and paid seperately at Supply only rate under appropiate item

Supply only chain link MS galvanized fencing of any size or type complete all as specified and as directed.

S & F galvanized 2 strand steel barbed wire 2.24 mm dia barbed with 2mm dia barbs at 75mm spacing & straining & fixing to any type of standards rails straining bolts including securing or tying at crossing with & provn of galvanized mild steel wire , complete all as specified and directed:-(Each line wire to be measured)

S & F mild steel screw bolts (machine made) with hexagonal head at one end and screwed the other, each screwed end to be fitted with washers and one hexagonal nut, length of bolt exceeding 5cm and not exc 10cm long dia of neck 12mm complete all as specified and as directed.

Mild steel bars 10mm dia TMT bar cut to length, bent to shape required, hooking ends fixed with chain link fencing complete all as specified and directed

M & L preparing new concrete surfaces of fencing post and applying two coats of white wash including necessary preperation of surfaces complete all as specified and directed

M&L preparation of new iron and steel surfaces of any description, exceeding 10cm width or girth and applying two coats of synthetic enamel paint complete as specified and directed.

M&L preparation of new iron and steel surfaces of any description,n exc 10 cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide, zinc chrome primer complete as specified and directed.

M&L for rendering 15mm thick plastering in cement mortar (1:4) on on fair faces of brick work and finished the plastered surface even and smooth without using extra cement.complete all as specified and as directed.

M & L preparing new plastered surfaces and applying two coats of cement base paint over a coat of primer complete all as specified and directed

S&F framed work portions hung as gates, including pintle hinges, stops, hand-made sliding bolts, etc.such as grills, grating, etc, with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars, barred iron doors, ladders; framed baluster; walk ways, railings, framework of water tanks and similar work conforming to Fe 290 Gde E-165 including necessary preperation of surfaces and applying one shop coat of red oxide, zinc chrome primer complete all as specified and as directed.

Excavation in trenches n.exc 1.5m wide n.exc 1.5m deep for foundationetc and getting out in soft/loose soil complete all as specified and as directed.

Returning, filling in, including, spreading, levelling, watering and well ramming in layers not exceeding 25cm in soft/loose soil, complete all as specified and as directed.

Removing excavated material (Soil) n.exc 50m and depositing were directed at a level not exceeding 1.5m above the starting level complete all as specified and as directed.

S&F mild steel framed work of angle or other section as in gusset plates, rails braces, wind ties, cleat hold fasts etc, complete as required conforming to Fe-290 Gde E-165 including necessary preperation of surfaces and applying one shop coat of red oxide, zinc chrome primer as specified and directed.

S&F framed work using MS tubular pipe using ERW or induction butt welded tubes conforming to I.S.1161- 1979 grade St.-240 including necessary preperation of surfaces and applying one shop coat of red oxide, zinc chrome prime complete all as specified and as directed.

S&F Welded steel wire fabric fixed to steel members, (weight not exc 4Kg/Sqm) including necessary preperation of surfaces and applying one shop coat of red oxide, zinc chrome prime complete all as specified and directed.

M/S RAJA CONSTRUCTION

MOINUL HOQUE CHOUDHURY