Upgradation of training center including e class room under NHP

Amount

Dismantling wall panelling work clearing away and carefully stacking materials in the rear side of circle office etc, complete and as ditected by the departmental officers .The rate is exclusive GST

Thorough scrapping of old plastered surface

Spplying and fixing the Wall panelling with the following specification fixing horizontally and vertically in position of wall. Fixing the water proof ply wood 9mm thick board over the country wood planks. Over the ply wood OST sheet of 4mm thick will be fixed with necessary screws and fevical giving neat finish. The top will be finished with two coats of sanding polishing. The surface will be finished with necessary design as directed by the Departmental Officers. The rate inclusive of all materials, labour power and conveyance of materials to the work site,loading & unloading etc., and as per drawing and design by the Departmental Officers. The water proof ply wood and OST sheet and other materials to be used shall be got approved by the Executive Engineer concerned before use on work, etc., complete as per standard specification.

Providing post constuction of Anti termite treatment for the building as per IS6313 with the insecticides Act 1968 by the insecticides board including cost of termicides of ISI standard labour charges for preparing the site charges for etc., the chlophriphos termisides will be dilued to 0.50% strength for the entire treatment. Providing post constuction of Anti termite treatment by drilling 1/2" holes a depth of 1 ft 4" to 6" at an equal intervel or 12" at the floor level. Plinth beam level joints and the chemical termicides be injected in these holes will its refusal or maximum of 1lt/hole the hole will be closed eith cement mortor 1:3 ratio. The outer perophery of the building by making holes at an interval of 12" to a depth of 9" and the termicides by spread in this holes all the wooden joinery fixed to the building like door frames chemicals usedall will have 0.5% concentration for entire operation etc., all complete complying will standard specifications and directed by the Departmental Officers. Rate including GST

Rewiring with 2x1.5 sq.mm (22/0.3) PVC insulated unsheathed SC Cu.Conductor of 1100V grade in suitable PVC rigid pipe on a wall and ceiling with PVC accessories with TW switch box with 5A F.T switch inflush with wall covered with hylum sheet of 3mm thick with painting of suitable colour for open PVC light/fan point (for electeonic regulator) (5 point per coil)

Renewal by supply and fixing of 440W Twin mirror optic recessed mounting type fitting with copper choke and condensor complete suitable for 2 nos fluorescent tubes.

GST for line items 1 to 6

Muthuvel