Badminton court work at Kasturba Gandhi Residential School, Kurara District Hamirpur.

Earth work in excavation by mechanical means (Hydraulic excavator)/ manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and lift upto 1.5 m, as directed by Engineer-incharge. (DSR 2.6.1)

Sand filling in plinth under floors including watering, ramming, consolidating and dressing complete including lead up to 50m and lift upto 1.5m and including cost of sand.DSR.2.27

P/L in position cement concrete of specified grade excluding the cost of Centering and shuttering all work upto plinth level 1:4:8 (1 Cement: 4 coarse sand (zone-III) derived from Natural sources:8 graded stone aggregate 40 mm nominal size derived from Natural sources .D.S.R Code No-4.1.8

M-150 brick work in 1:6Cement & C. Sand Mortar in Foundation and plinth…Complete Item. D.SR-6.1.2

Providing and laying in position specified grade of reinforcement cement concrete,excluding the cost of centering, shuttering, finishing and reinforcement of R.C.C 1:1.5:3 with cement coarse sand .column T beam slab as DSR NO-5.1.2

M.S (Tor steel or plain ) in plain work such as R.C.C or R.B work including cutting / bending for proper shape as necessary including supply of all steel & wastage ,bend ,hook & authorised overlapping shall be measured … complete item.DSR 5.22.1

Earthwork in cutting or filling in ordinary soil form 3k.m.i/c all complete work

Cement concrete floorig 1:2:4 ( 1 cement 2 coarse sand 4graded stone aggregate) finished with a floating coat of neat cement,including cement slurry,excluding the cost of nosing of steps etc complete 40 mm thick with 20 mm nominal size stone aggregate DSR.11.3.1

Steel work inbuilt up Tubular(round,square or ractangular hollow tubes etc) Trusses etc including cutting,hoisting,fixing in position and applying a priming coat of approved steel primer including welding and bolted with with special shaped washers etc all complete.DSR-10.16.2

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineerin- charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.(0.63 mm thick sheet) DSR.12.1.3