Construction of 30000 litre OHT at Near Periya kulamin Senbathaniruupu Panchayat Sirkali Block Mayiladuthurai District

Amount

Construction of 30000 litre OHT at Near Periya kulamin Senbathaniruupu Panchayat Sirkali Block Mayiladuthurai District

Earth work excavation & depositing on bank with an initial lead of 10 metre & initial lift of 2 metre in Hard shift clay, stiff block cotton, hard red earth shales, murrum, gravel, stoney earth, and earth mixed with small size boulders and hard gravelly soil (SS 20B) for foundation including shoring, strutting, baling out water providing danger light wherever necessary depositing the surplus earth on bank and other incedential charges etc., complete and as directed by TWAD board Officers

First depth of 2m From 0 to 2 m below GL

Second depth of 1m

Sand filling for foundation with clear river sand including cost of sand, watering ,ramming and consolidation etc complete as directed by TWAD Board officers

Plain Cement Concrete 1:4:8 (one cement, four sand and eight hard granite broken stone of 40mm size ISS gauge) for foundation and footing including mixing, placing, ramming ,finishing curing etc. complete in accordance with standard specification and as directed by the TWAD Board Officers.

Reinforced Cement Concrete Mix M30 grade using 10mm & 20mm Hard blue granite Broken stone (machine crushed) excluding the cost of RTS rods for reinforcement and centering, strutting, shuttering but including cost of all materials mixing, laying, Vibrating the concrete with mechanical vibrators, ramming, consolidating, finishing and curing etc., Complete and as directed by the TWAD Board Officers.

For items 1.5m to 4.5m below GL

For items 0 to 1.50m below GL

For items 0m to 4.5m above GL &1.00 m Above G.L

For items 4.50m to 7.32m above GL

For items 7.32m to 10.98m above GL

For items 10.98m to 14.64m above GL

For items above 14.64m & up to 18.30m from GL

Supply and erection of steel centering, shuttering for soffits and sides including necessary supports and strutting for all RCC works using MS sheets of suitable size of BG10 stiffened with MS angle of size 25 X 25 X 3 mm for boarding laid over I type MS Truss of size 25 X 25 X 3mm about 90cm c/c and supported by 40mm GI pipes (Medium) spaced at 75cm c/c etc complete and as directed by the TWAD Board Officers.

PLANE SURFACES

Below G.L.

ABOVE G.L. to 3.30m

Curved Surface

Square column

Below G.L.

Ground level to 3.30 m

3.31m to 4.30m ht

Painting two coats with approved cement paint over one priming coat of white cement over cement plastered wall surface and ceiling including cleaning preparing the surface and curing etc., complete (using cement paint of colour as approved by the Departmental officer) and as directed by the TWAD Board officers.

Supplying, cutting, bending, tying, fabricating and placing in position of steel rods for all RCC works including cost of steel and binding wire etc.( The steel should conform to the relevant ISspecification and supplied with test certificate Fe. 415 grade as per IS specification No.1786/1985 and as amended from time to time) delivery at site of work including loading, freight, unloading, stacking, transit insurance charges, taxes etc. complete.and as directed by the TWAD Board officers.

Fabrication, supply, delivery and fixing of outside MS Ladder of 45cm clear wide made out of 50 mm x 50mm x 6mm MS angle for both sides and for steps at 30cm C/C welded jointed etc ., for I staging from GL to 1st level brace (weight 4.5kg/m) IInd and IIIrd staging upto floor slab and IVth staging from floor slab to roof top. Supply, delivery and fixing of 32 mm GI pipes medium for hand rails from I stage to IVth stage. RCC M30 Grade mix for Landing slab 5 nos. at Ground Level- 1No. and above Ground Level - 4Nos. Supply and fixing of 32mm GI pipe medium for hand rails for the Landing slab. Supplying and fixing of MS Base plate of 100mm X 100mm X 6mm thick for fixing Anchore fastener bolt for fixing of hand rails at Landing slab and MS Ladder providing locking arrangements with two coats of approved enamel paint over one coat of red oxide paint as per approved Type Design and as directed by TWAD board officers.

Providing and fixing of RCC inner access ladder in RCC 1:11/2 :3 (one cement,one and half sand and three aggregate) using 20mm HBG stone for OHT including cost of reinforcement, placing grill in position, centring,shuttering charges, mixing concrete,curing etc. to required height and clear width of 45 cm consisting of 2 nos. of vertical post of 10 cm x 15 cm and step slab of 25mm x 25mm etc.complete and as directed by TWAD Board Officers.

Providing 110mm PVC vent cowl arrangements mosquito proof nylon net and as directed by TWAD Board officers

Providing manhole cover of size 0.60 x 0.60M in RCC 1:1.5:3 with suitable reinforcement and 50x50x6mm MS angle fixed along edges and as directed by TWAD Board officers

Painting TWAD Board emblem on the SR with enamel paint as per Board's specification and as directed by TWAD Board officers

Pipe connection arrangements for inlet,outlet,scour and overflow etc. including cost of pipes,specials,valve,labour charges for lifting, aligning, cutting, threading ,fixing and painting of GI pipes with two coats of approved quality enamal paint etc. complete as detailed below.

Supply of GI Pipes for OHT Connections 65 mm dia

Supply and Delivery of G.M.Gate valve 65mm size

Supply & Delivery of 65 mm G.I Tee

Supply & Delivery of 65 mm G.I Coupling

Supply & Delivery of 65 mm G.I bend

Supply & Delivery of 90mm T.Coupler PVC

Supply & Delivery of 80mm x 65mm G.I.Reducer

Supply & Delivery of 65mm G.I.flange set

Labour charges for fixing of G.I. Pipes & Specials for OHT pipe connections as directed by the Deparment Officers,

Refilling of the foundation with execavated soil in layers of thick including ramming watering etc., complete as directed by the Department officers

Drilling of borewell anywhere in Tamilnadu including transportation from one place to another place within Tamilnadu in alluvial soil or sedimentary strata of clay and sand or sand, stone, shale, pebbles, boulders etc.,by first taking a pilot bore of 140 mm/150mm dia and then enlarging to required dia by direct or reverse rotatry mud and circulation method using Contractor’s rig, fuel, labour, drilling, betonite mud and water required for drilling at the site shown by the TWAD Officers including construction of mud pit (only Calyx drills are to be used).

Reaming from 200 mm dia pilot bore to 300 mm dia bore as directed by the TWAD Board Officers upto 60 m Depth ending from ground level

Labour Charges for inserting 200mm dia PVC casing pipes assembly (with slots or without slots) in the drilled hole including jointing the pipes with PVC couplers with cement paste etc. complete

Charges for developing the borewell with air compressor of 300 CFM capacity (Minimum 8 Hours) including transportation labour and One hour 1303.93 fuel charges for compressor as directed by TWAD Board Officers and conducting yield test by ‘V’ notch method.

Supply and delivery of 200mm OD PVC plain casing (CS) pipe

Supply and delivery of 200mm PVC end cap

Supply and delivery of 5.0 HP submersible pumpset 200*75

Supply and delivery of 5.0 HP Panel Board

Supply and delivery of 2.5 Sqmm submersible cable

Supply and delivery of UPVC - Column pipe 50mm

Supply and delivery of 50mm GI flange set

Supply and delivery of 50mm GI coupling

Supply and delivery of 50mm MS Clamp set

Supply and delivery of G I PIPES 50mm (MEDIUM) AS PER IS 1239/PART I/2004

Bore CoverBore cap using M.S. Flat of size 1 cm x 3 mm and M.S. sheet on top with bolting arrangements for securing the cap in position (Bore caps with M.S. Couplings need not be made) 8" Casing Pipes

Labour charges for the erection of submersiblepumpset inborewell/openwell including fixing and jointing submersible cable with proper clamps upto the starter to required depth and also fixing of riser pipes to the requireddepth valves erection clamps, pressuregauges upto the exterior wall of pump room and erection of panel board consisting of TPICN switches starter, Voltmeter, Ammeter,three pilot (indicating) lamps capacitor single phasing preventor, water level guard and laying and jointing the cables and twin earthing as per IE rules etc., complete and testing the pumpset and trail run for 10 days. up to 5.0 HP

labour charges for slotted

Earth work Excavation in all soils for laying pipes including refilling.

Supply and delivery of 63 mm OD PVC pipe 4 Kg/Sq.cm

Supply and delivery of 63mm OD PVC Tee.

Supply and delivery of 63mm OD PVC Elbow

Solvent Cement

Laying and Jointing of 50mm to 63mm dia (OD) PVC pipe

Earthwork excavation in all classes of soils and depositing on bank with an initial lead and lift such as sand or other loose soil, wet sand not under water silt and ordinary soil, sandy loom, and hard stiff, black cotton soil, red earth, earth mixed with

Filling with good river sand into foundation and basement including cost and conveyance of all materials to work site and all labourcharges for filling, watering etc., complete.

CC 1:4:8 mix using 40mm ISSHBG metal including cost and conveyance of all materials to work site and all labour charges for mixing, laying and watering etc., complete.

Reinforced Cement concrete 1:1.5:3 mix using 20mm ISSHBG metal from approved sources including cost and conveyance of all materials to work site and all labour charges for mixing, laying, and watering etc., complete. UPTO basement

Reinforced Cement concrete 1:1.5:3 mix using 20mm ISSHBG metal from approved sources including cost and conveyance of all materials to work site and all labour charges for mixing, laying, and watering etc., complete. Above basement

Brickwork in CM 1:5 mix using country bricks of standard size including cost and conveyance of all materials to work site and including all labour charges and all incidential charges etc., complete. Upto basement

Brickwork in CM 1:5 mix using country bricks of standard size including cost and conveyance of all materials to work site and including all labour charges and all incidential charges etc., complete. Supersture

Special ceiling plastering in CM 1:3 –10mm thick including cost and conveyance of all materials and all labour charges etc., complete.

Plastering in CM 1:5 ,12mm thick including cost and conveyance of all materials to work site and all labour charges etc., complete.

Distembering two coats with best approved colour with Priming Coat over the new plastered surface including cost and conveyance of all materials to site and all other labour charges etc complete.For INNER WALL and Ceiling

Painting two coats of newly plastered wall surface with ready mixed Plastic Emulsion Paint of First quality of approved colour over a Priming Coat including thorough plaster of paris putty wherever required etc, complete complying with scrapping , clean removal of dirt and including necessary plaster of paris putty wherever required etc, complete complying with standard specification(including primer).For OUTER WALL Surface.

Painting two coats with ready mix paint of approved colour and trade for doors & windows including cost and conveyance of all materials and all other labour charges etc., complete.

Supplying and erriecting, centring for plane surfaces structures such as RCC slab, beam etc., inlcuding strutting upto 3m height using mild steel sheets of size 90cm x 60cm x and B.G 10 stiffened with M.s angles of size 25 mm x 25mm x 3mm for boarding lai

Supplying and erriecting, centring for plane surfaces structures such as RCC slab, beam etc., inlcuding strutting upto 3m height using mild steel sheets of size 90cm x 60cm x and B.G 10 stiffened with M.s angles of size 25 mm x 25mm x 3mm for boarding lai

Supply and fabrication of steel including cost and conveyance of steels to worksite including labour for cutting, jointing and welding if necessary including all labour charges for dying with binding wire etc., complete.

Supplying Steel Door and windows as per standard specification Door of size 0.90mx2.10m

Towards Labour charges for Fixing of Steel Doors

Wiring with 2 x 1.50 sqm ( 22/0.3 ) PVC insulated unsheathed single core Copper Conductor of 1100 v Grade in suitable PVC Rigid Pipe on wall and ceiling with PVC accessaries with TW Switch box with 5 A F . T . Switch with painting of suitable colour for Light Point and Fan Point ( For Electronic Regulator ) S D N o 18

Supply and fixing of 15w CFL Lamp (spiral lamp) for existing holder on wall etc complete.

Supply and fixing of 16amps DP Switch with metal clod of 500v with tube connection 32Amps and netural on suitable T.W Plug plante with supplying on reeper on Either side With PWD Earthen etc.

Supply and run of 2 of 6s.qm 84/100 pvc SC Unstrenthed on condition of 1100v grade in 25mm side GI Pipe lend with both ends with necssary angles etc

Supply and run of 2 of 6s.qm 84/103 pvc SC Unstrenthed on condition of 1100v on 7/70 GI Reducer with fuse service connection etc

Provision for EB Service connection charges

Towards cost and supply of RCC Jolly of size 0.60*0.60

GST Amount for providing Service to Government Contract Works for the above Construction Works. { GST Amount is the Total GST Amount for total overall quoted amount above this row in column "BB" for all works in this package}

T.Rajarajan