REPAIR TO FENCING COMPOUND WALL AND PATHWAY AT SHILLONG CANTT

Dismantling post or strut (Wood, steel, RCC) any section incl taking out embeded portion by demolition of cement concrete in fdn and making good the disturbed portion of ground, Complete all as specified and directed.

Demolition of plain cement concrete in ground floors or above ground floor and paving n.exc 15 cm thickness (Below or above ground level) Complete all as specified and directed.

M&L for providing 50 mm thick cement concrete 1:2:4 type B1 (20 mm graded aggregate) as in flooring/subbase Complete all as specified and directed.

M&L for providing 100 mm thick cement concrete 1:2:4 type B1 (20 mm graded aggregate) as in hard standing Complete all as specified and directed.

M&L for sand filling in trenches as a cushioning/bedding and haunching to PVC pipe including watering complete all as specified and as directed.

M&L for chequered cement concrete tiles 30cm x 30cm x 25mm thick, set, jointed and pointed in neat cement slurry with gray cement and pigment in floors over and including 20mm thick screed bed in cement mortar 1:6 Complete all as specified and directed.

S & F prepolished coloured rubber mould paver block any shape and size conforming to IS 15658-2006 of 80mm thickness (M-40 grade) with grey cement and no pigment complete all as specified and directed.

Demolition of brick work or stone masonry built in cement mortar including all quoins arches, pillar etc but excluding ashlar facing , dressed stone work and precast concrete articles, all as specified .

M&L for pre-cast PCC solid block walling with cement concrete type C1 (1:3:6, using 20 mm graded crushed stone aggregrates) exc.10cm in width and setting in cement mortar 1:6, complete including demolition at old precast cement concrete block walling Complete all as specified and directed.

M&L for 75 mm thick PCC (1:3:6) type C2 using 40mm graded aggregates as in plinth protection including finishing even and smooth without using extra cement Complete all as specified and directed.

M&L for PCC (1:4:8) type D2 using 40mm graded stone aggregate as in foundation , filling and mass concrete complete all as specified and directed.

M&L for PCC (1:3:6) type C2 using 40mm graded aggregates as in surface channel and drain, complete all as specified and as directed including demolition of old PCC as in surface channel and drain Complete all as specified and directed.

M&L for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, miltred/stopped ends etc Complete all as specified and directed.

Taking down cement plaster, any description on brick or stone or cement concrete walls including raking out joints, hacking for key, scrubbing down with water complete, all as specified.

M&L for 10mm thick cement plaster in cement mortar 1:4 on fair faces of bricks or concrete surface and finished even and smooth without using extra cement, Complete all as specified and directed.

M & L for preparation of new plastered surfaces of walls including cornices, pilasters etc and applying two coats of white washing over a coat of chalk whiting complete all as specified and directed.

M&L for for applying two or more coats of 100% premium acrylic emulsion paint having VOC less than 50 gm/ltr and UV resistance as per IS 15489:2004, Alkali & fungal resitance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/10 Sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm over old surface on external surfaces including complete removal of existing treatment over wall and preparation of surfaces even and smooth complete all as specified and directed.

M&L for for applying two or more coats of 100% premium acrylic emulsion paint having VOC less than 50 gm/ltr and UV resistance as per IS 15489:2004, Alkali & fungal resitance, dirt resistance exterior paint of required shade (Company Depot Tinted) with silicon additives @ 1.43 litre/10 Sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm over new surface on new or previously untreated surfaces all as specified and directed.

M&L for applying two coat of cement base paint over a coat of newly plastering surface of wall incl preparation of new plaster/concrete surface complete all as specified and directed.

M&L Preparation of new steel and iron surfaces exceeding 10 cms width or girth and applying two coats of synthetic enamel paint over one coat of red oxide primer, Complete all as specified and directed.

M&L Preparation of old steel and iron surfaces exceeding 10 cms width or girth and applying one coat of synthetic enamel paint , Complete all as specified and directed.

Dismantling barbed wire fencing of any description, size, spacing, Complete all as specified and directed.

Dismantling fencing wire mesh any type, Complete all as specified and directed.

S&F Galvanised 2 strand steel barbed wire, 2.24 mm, barbed with 2.00 mm dia barbs at spoacing 75 mm and straining and fixing to any type of strandard rails straining bolts, incl securing or tying at crossing with provn of galvanised mild steel wire, staples or steel pins etc. complete all as specified and directed.

Restraining and resecuring incl making good staples etc. of barbed wire complete all as specified and directed.

M&L for MS Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering. Doors, etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive of steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete Fe.290.Gde-E-165 Complete all as specified and directed.

S & F in repair 1mm thick Mild steel, plain, black sheet in wall cladding, steel gates and similar work, cut to size, holes punched; including round headed screws, clout nails or rivets and fixed to wood or steel framing with plain 40 mm lap joints with riveted or welded seams, including bending or turning up, mitred angles, etc. as required Complete all as specified and directed.

Demolition of cement concrete (reinforced) of any description and in any position not otherwise specifically provided for Complete all as specified and directed.

Formwork to sides of concrete fdns,drains, footings, bases of cols, raft and fafts beams, sides and soffits (if any) of fdns and plinth beams, and similar works and fair finished surface Complete all as specified and directed..

M&L for RCC1 1:2:4 type B1 (using 20 mm graded aggregate) as in Slabs supported on walls, beams and columns in floors, roofs, landings, balconies, canopies, deck slabs and in shelves and the like Complete all as specified and directed.

M & L for Formwork to soffits of suspended slabs such as roof slabs, floor slabs, landings and similar work; not exceeding 200mm thick (Horizontal or sloping) incl fair finished surface Complete all as specified and directed.

M&L for provide precast cement concrete 1:2:4 type B-O,set in cement mortar 1:4 (12.5 mm graded aggregate ) louvres and jallies ,40 mm thick(meassured solid ), including all moulding complete all as specified & directed.

M&L walling of Random rubble , uncoursed, well bonded, bedded & sollidly hearted built in cement mortar 1:4 Complete all as specified and directed.

All as per item no33 above but except stone complete all as specified and directed.

M&L for PCC (1:3:6) type C1 (using 20mm graded stone aggregates) including necessary form works as in precast bond stone & set in CM 1:6 Complete all as specified and directed.

Extra over Hammer dressing with maximum depression on face from straight edge held against the dressed surface n, exc 20mm Complete all as specified and directed.

M&L for raised pointing to random rubble stone masonary uncoursed or brought upto course in cement mortar 1:3 Complete all as specified and directed.

M&L for PCC 1:2:4 type B-1 (using 20mm graded stone aggregate) as in coping complete all as specified and directed.

Excavation in post holes (or similar holes) in any type of soil, each not exceeding 0.5 cum, getting out, returning, filling in and ramming earth or broken rubble mixed with earth around in layers not exceeding 25 cm, watering and removing surplus spoil to distance not exceeding 50 mtr and making good surface Complete all as specified and directed.

S&F for MS Rolled sections as in main and cross beams, hip and jack rafters; purlins where connected to common rafters and running rails and guides for sliding doors; fixed with angle cleats or other connecting plates confirming to FE 410-W Gde E-250 quality 'A' Complete all as specified and directed.

S&F mild steel work as in hand rail, balusters, noising to steps, post and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire, drilling, bolting or riveting etc, conforming to Fe-290 , Gde-E-165 Complete all as specified and directed.

Supply only chain link fencing any size or type as approved by GE complete all as specified and directed.

Fixing only chain link fencing including line wires any mesh, size and type to any to any type of standard, rail, straining bolts, etc. including provn of winding wire Complete all as specified and directed.

M&L mild steel round bars 10 mm dia conforming to FE-410-W (Gde E-250) quality A or Fe-290 (Gde E-165) as in stiffner for chain link fencing as wind tie Complete all as specified and directed.

S&F for Mild steel screw bolts(machine made) with hexagonal or square heads at one end screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, length of bolt not exceeding 30 cm and dia of neack exc 12 mm but not exc 20 mm Complete all as specified and directed.

S&F for 110 mm bore PVC (SRW) pipe, type 'B', ISI marked single socketed in any length with rubber ring joints fixed to wall with clamps, complete all as spe;cified and as directed Complete all as specified and directed..

Dismantling of 100mm cast iron or reinforced concrete drain pipes, jointed in cement mortar and taking out of trenches, if required Complete all as specified and directed.

S&F for 75 mm bore PVC (SRW) pipe, type 'B', ISI marked single socketed in any length with rubber ring joints fixed to wall with clamps complete all as specified and as directed including taking down old serviceable PVC (SRW) pipe with fittings Complete all as specified and directed..