DEVELOPMENT OF PARK BY CONSTRUCTION OF TOE WALL IN PARK NEAR COMMUNITY CENTER, SECTOR 25, CHANDIGARH, UNDER WDF.

Earth work in excavation by Mechanical means (Hydraulic excavator) manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan) including dressing of sides and remming of bottoms,lift upto 1.5 m,including getting out the excavated soil and disposal of surplus excavated soil as directed, within lead of 50m. All kinds of soil (DSR 2.8.1-2.36)

Filling available excavated earth (excluding rock) in trenches, plinth, sides of foundations etc. in layers not exceeding 20cm in depth, consolidating each deposited layer by ramming and watering, lead up to 50 m and lift upto 1.5 m. (DSR 2.25)

Carriage of earth by mechanical transport including loading, unloading Lead of 2 km complete in all respect to the entire satisfaction of the Engineer-In-Charge.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 5 coarse sand (zone-III): 10 graded stone aggregate 40 mm nominal size) DSR 4.1.10

Brick work with F.P.S. bricks of class designation 75 in foundation and plinth in: Cement mortar 1:4 (1 cement : 4 coarse sand) (DSR 6.1.1)

Providing and laying position cement concrete of specified grade excluding the cost of centring and shuttering , All work plinth level: - 1:2:4 (:1 cement : 2 coarse sand : 4 graded stone agg 12.5mm nominal size Complete in all respect to the entire satisfaction of the Engineer-In-Charge.(DSR 4.1.3)

15mm cement plaster of mix: 1:4 (1 cement: 4 coarse sand) to the entire satisfaction of Engineer-in-Charge. (DSR 13.5.1)

Pointing on brick work or brick flooring with cement mortar 1:3 (1 cement : 3 fine sand) Flush/ Ruled/ Struck or weathered pointing to the entire satisfaction of Engineer-in-Charge. (DSR 13.31.1)

Steel work welded in built up sections/ framed work including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer using structural steel etc. In gratings, frames, guard bar, ladder, railings, brackets, gates and similar works. as required. (DSR 10.25.2)

Providing and fixing M.S flat gate having flat size 50 x12 mm having 6'-0" long of each openable shutter and 3'-3" high above ground level and ,1'-0" below ground level welded with 2 no's M.S flat 40 x10mm including horizontally at 6' upper and 6' from bottom and 10 no's M.S square bars of 45 degree angle at 6'' center to center between the 2 no's horizontally M.S flat 40 x 10mm including the 2 no's M.S. Channel 75x40mm in posts having 2no's channel welded to form post of size 75x80mm & 6'-0" long with lugs 1'-3" long 2no's M.S. Flat 40x10mm at bottom under each post to be provided on both sides of shutter with 2 no's hinges for openable arrangements with sliding bolt for locking arrangements and gate shall be properly embedded in cement concrete 1:2:4 be painted with two coats of approved quality paint over one coat of primer complete in all respect to the entire satisfication of Engineer- in-Charge.