CA NO. CWE/CHM(U)-92/2023-24 REPAIR/MAINT OF ELECTRICALY OPERATED LIFT AT COMMAND HOSPITAL (WC) CHANDIMANDIR UNDER GE (U) CHANDIMANDIR

Amount

M & L for Comprehensive Maintenence of electrically operated lifts suitable for serving passengers / patients / load carrying lifts installed as under by service engineers/ technically qualified teams including attending the breakdown of lifts if any, complete inclusive cleaning of lift cabin, lift well and room all as specified and directed. Details of installed lifts are as under :- 04 Nos lift of make Tyhssenkrupp with six landings (Ground + five floor ) of capacity-20 persons, 1360 kgs, travel speed of 1.0 m/sec, Operation on 415 volts, 3 phase AC 50 Hz at Command Hospital (WC) Chandimandir.

M & L for Comprehensive Maint of electrically operated lifts suitable for serving passengers / patients / load carrying lifts installed as under by service engineers/ technically qualified teams including attending the breakdown of lifts if any, complete inclusive cleaning of lift cabin, lift well and room all as specified and directed. Details of installed lifts are as under:- 02 Nos lift of make OTIS with six landings( Ground + five floor) capacity-16 persons, 1088 kgs, travel speed of 1.50 m/sec, Operation on 415 volts, 3 phase AC 50 Hz total 2 Nos of lifts at Command Hospital (WC) Chandimandir.

Note for item No 1 & 2. All items required pertaining to repair/ replacement of these lifts shall be deemed to be included in quoted rate except items covered under ser No 04 to 24 . The comprehensive maintenance will also include checking entire system as per manufacturer's maintenance manual such as checking all parts for serviceablility, repairing/replacement/adjustment as per site requirement of the following : - (a) Renew wire ropes and chains (where fitted) as required to maintain an adequate factor of safety, to equalize the tension on all hoisting ropes, repair or replace conductor cable and hoistway and machine room elevator wiring.

(b) Examining, adjusting and repairing Machine Worm Gear, Thrust Bearings, Drive sheave, Drive sheave bearings, Brake Contact, Linings and components. (c) Examining and repairing Motor, Motor Generator, Motor Windings, Rotating Elements, Commentator, Brushes, Brush Holders, Bearings, Coils, Resistance for operating and Motor circuits, Magnet Frames and other Mechanical parts.

(g) Examining and repairing Deflector or secondary sheave, Bearings, Car and counterweight guide rails and buffers, top and bottom limit switches, Governor Tension sheave Assembly, Compensation sheave Assembly, Car counterweight and counterweight guide shoes including rollers or Gibs. (h) Examining and repairing Interlocks on Hoistway door, Hoistway door hangers, Guides, Automatic Power operated door operator, Car door hanger, Car Door contact , safety shoe, load weighing equipment , Car Frame, Car safety mechanism and platform.

(j) Providing lubricants compounded to respective OEMs stringent specifications. (k) Examining periodically all safety devices and governors and make all customary safety tests. (l) The contractor shall be submitted the memorandum of understanding (MoU) of minimum 100 Rs stamp paper duly notarized with original Equipment Manufactuer (OEM) i.e. ThyssenKrupp Elevators India Pvt Ltd and OTIS Elevator Co. India Ltd within 15 days of acceptance of tender, failing which the contract will be liable to be cancellled under condition 54 of IAFW-2249. Maintanance shall be carried out under OEM overall supervision direction/ instruction.

(m) Contractor will conclude AMC with OEM and copy of the agreement will be submitted to Engr-in-Charge and GE before commencement of AMC. No payment will be made to contractor without submission of valid AMC agreement. (n) Rep of OEM shall submit a monthly comprehensive testing certificate to the contractor, the monthly comprehensive testing certificate shall be submitted by the contractor to the Engineer-in-Charge while claiming payments.

Suuply, installation, Commissioning and Testing in repair/replacement of Micro Processor with VVVFD and Latest Technology-Based Controller Panel complete all as specified and directed by Engineers-in-Charge.

Supply & fixing in repair/replacement of full length IR door Sensor 12V/0.2A with 20 number of Diodes complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of latest technology false ceiling system with stainless steel mirror finish, stainless sheet of 1.2 mm minimum thickiness complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of Reed switch suitable for 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of defective travelling Cable PVC insulated flexible flat copper conductor of size 4 Core x 0.75 Sqmm complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of SMPS 12 Volts, 42 AH battery complete all as specified and directed by Engineer-in-Charge.

M & L for Aluminium chequered plate flooring minimum 3 mm thick complete all as specified and directed by Engineer-in-Charge.

Supply, installation, Commissioning and Testing in repair/replacement of ARD (Automatic Rescue Device) 1.5 KVA with Battery 12 Volt 180 AH suitable for 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of Landing Operating Panel (LOP) with digital indicator for counting of floors up and Down & up, down complete all as specified and directed by Engineer-in-Charge.

Suuply, Installations, Commissioning and Testing in repair/replacement of latest technology-based Cabin Operating Panel (COP) for 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of robust MS Car Door Seal of 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of robust MS Landing Door Seal of 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Supply & fixing in repair/replacement of Power Contactor Model No LCI-D80116F5 or equivalent in performance as approved by GE for elevator complete all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of steel hand rail (36" x 5") of 25 mm dia for hand grip complete all as specified and directed by Engineer-in-Charge.

Supply & fixing in repair/replacement of LB-II Card (PCB for Elevator) Complete suitable for 16/20 Passengers lift complete all as specified and directed by Engineer-in-Charge.

Suplly and fixing in replacement of Upper and Lower limit switch suitable for 16/20 Passenger lift complete all as specified and directed by Engineer-in-Charge.

Supply and fixing in repair/replacement of Door Spring 800CO as per sample suitable for 16/20 Passengers lifts complete all as specified and directed by Engineer-in-Charge.

Supply & fixing in repair/replacement of Over Speed Governor Assembly 1.00 mps including OSG unit, pit pulley, auto limit switches etc. complete set all as specified and directed by Engineer-in-Charge.

Supply & Fixing in repair/replacement of Encoder Assembly with all fixing accessories complete all as specified and directed by Engineer-in-Charge.

Supply & fixing in repair/replacement of Overload Warning Indicator System with complete accessories complete all as specified and directed by Engineer-in-Charge.

Supply & fixing in repair/replacement of lift rope complete in all respect for one lift (Total six landing) as per manufacturer's recommendation complete set all as specified and directed by Engineer-in-Charge.

KAPOOR ENGINEERS

SANJEEV ENTERPRISES

M/s Dhapola Elevator and Engineering