CAMOUFLAGE PAINTING TO CERTAIN BLAST PENS AND HANGERS IN TECH AREA AT AF STN SIRSA

Amount

Taking down Cement Plaster including raking out Joints, hacking for Key, scrubbing down with Water and removing Debris, etc. to Outside MD/AF Land, complete all as specified and as directed by Engineer-in-Charge.

M&L for Rough Cast Plaster on Brick Walls consisting Under Coat of Cement and Sand Mortar 1:3 not less than 10mm thick and while it is still in Plastic state the Rough Cast Mixture consisting of Crushed Stone or Fine Gravel mixed with Coarse Sand and Cement in the ratio 1:1:1 shall be applied and finish Even, complete all as specified and as directed by Engineer-in-Charge.

M&L for Rendering 15mm thick in Cement Mortar 1:4 on Brick work or on Concrete Surfaces, Plastered Surfaces finished Even and Smooth without using Extra Cement, complete all as specified and as directed by Engineer-in-Charge.

M&L for preparing newly Plastered Surfaces of Walls and applying Two coats of Weather Coat Exterior Paint (in Camouflage pattern) with approved Tint over a coat of Primer, complete all as specified and as directed by Engineer-in-Charge.

M&L for preparing New Rough Cast Plastered Surfaces of Walls by applying Two Coats of Weather Coat Exterior Paint (in Camouflage/Plain pattern as ordered) with approved Tint as per manufacturer's instructions over a coat of primer, complete all as specified and as directed by Engineer-in-Charge.

M&L for preparation of old painted steel sheet (corrugated/plain) by removing complete existing treatment, over 10cm width or girth and applying two coat of synthetic enamel paint (camouflage pattern) over a coat of primer including necessary safety arrangement for labour up to 15 m height (Approx) complete all as specified and as directed by Engineer-in-Charge..

M&L preparing old Plastered Surfaces of Walls and roof by Complete Removing of existing Treatment , rubbing to obtained a Smooth Surface, applying Two Coats of Weather Coat Exterior Paint (in Camouflage pattern) with approved Tint over a coat of Primer (as per Manufacturer's instructions), complete all as specified and as directed by Engineer-in-Charge. NOTE: Rates quoted by the tenderer are included with following apllication as under:- (a) The surfaces shall be cleaned to remove loose dirt or dust,lichen, algae, fungi or any organic growth by use of stiff brush , washed well and allow water to dry. (b) All cracks, voids and minor damages shall be patched/repaired prior to application of paint with white cement putty or with Plaster of Paris.

Ajay Enterprises

M/s Har Nandi Construction Company

YESH BUILDERS

VIVEK CONSTRUCTION CO

shiv shanker enterprises

DCM ENTERPRISES