Special repairs to 20 x shutter of special vehicle garages of 344 MSL Regt at New Mil Stn Kapurthala under GE Kapurthala.

S&F of motorized side-operated electric motor for MS rolling shutter of size 5.5 m (Width) × 5.0 m (Hight), shutter weight min 800 Kg or above, 230V AC single phase 50 Hz, 400–550W (for heavy duty min 0.75 HP or as recommended by OEM), 640 N·m torque, 4.1 Rpm speed, with push button control (Up/stop/down), chain operation for manual over ride, limit switches, safety brake, and complete mounting bracket set as per IS-6248 complete all as specified and directed.

M&L for providing and fixing heavy-duty electrically operated worm gear box gear motor set for roller shutter of size 5.5 m (W) × 5.0 m (H), shutter weight 800 kg, 460 W (0.75 HP), 230V AC single phase 50 Hz, output torque 647 N·m minimum, gear ratio 40:1, output speed 3-7 RPM, maximum lifting height 8-9 m, hardened steel worm gear with bronze wheel, IP 54 protection class, side-mounted with brackets included, manual chain over ride and crank handle operation, push button control (Up/stop/down), 2 remotes, receiver, lock box and complete hardware accessories, seal for life lubrication, 1 year warranty, complete all as specified and directed.

M&L for sub main wiring with one runs of three core PVC insulated, unsheathed copper condutor, multi stranded cable of size 4.00 Sqmm 1100 volts grade drawn PVC surface/recessed conduit of size 19/20 mm (ISI marked) including PVC accessories complete including cutting and chasing and making good to disturbed surface of wall/floor/etc; complete all as specified and directed. Note:- (i) One run of three core 4.00 Sqmm cable and one run of PVC conduit shall be measured & paid as one unit. (ii) 15 Rm considered for each motor)

- ditto - all as per above item No. 3 but single core copper wire of size 2x2.5 sqmm + 1x2.5 sqmm earth wire and in casing caping complete all as specified and directed.

S&F in repair LED flood light 70 watt 230 V AC outdoor type, not less than 105 lumens/watt , toughned glass with high pressure die cast aluminum hosing, thermal management in multiple optics, IP-66 protection, impact and corrosion resistant complete with driver and lamp all as specified and directed.

Supply, install, testing and commissioning of LT Distribution Panel (CPRI type tested) cubicle type IP-65 , Outdoor type confirming to IS-61439 factory fabricated prewired made out of 3.15 mm thick CRCA sheet outer & 2 mm thick CRCA sheet inner of suitable size to accommodate all accessories/ fittings compartmentalized in construction to accommodate the incoming/outgoing MCCB ad TPN bus bars and outgoing feeders. The TPN bus bars shall be insulated with colour coated heat shrinkable sleeve and shall be mounted on DMC support. The incoming as well as outgoing MCCBs shall have extension links of current carrying cap not less than 1.5 times the rated capacity of individual feeders. The extension links shall be supported on DMC support having provision of termination of incoming and outgoing cables. All extension links/ interconnections shall be colour coated sleeves. The cubicle shall have frame work at bottom of MS channel MC 100 fixed to the top of platform. The plateform of LT Panel shall be pedestal type of suitable width and 600 mm height above ground level and minimum 400 mm below the ground level constructed with bricks (sub class 'B') work duly plastered in cement mortar 1:3 and PCC copping (1:2:4) not less than 50 mm thick over brick pedestal with adequate opening for entry of cable complete as per manufacture recommendation and as directed. A detachable gland plate of thickness not less than 3 mm thick should be used at the bottom for entry of armoured cable of adequate size compression glands, the panel shall be painting with powder coated finish with RAL 7032 SIEMENS GRAY structure after seven tank phosphate treatment front & back opening type and fixing 2 Nos danger notice plan with letter figures and conventional skull bones in signal red colour and fixed front & back door to LT Panel with voltage and danger indicated in Hindi and English with double door shutter and shall have louvers and air vent gasket for natural flow of air Neoprene adhesive type gasket shall be used to make panel vermin proof & comprising of following :-

Incoming:- MCCB 4 Pole, 250 Amps ,415 Volt of breaking capacity 35 KA with Ics=100%Icu Adjustable thermal and adjustable magnetic release - 01 Nos. Busbar:- TPN 500A - 01 Sets. Outcoming:- MCCB 4 pole 415 V 63 Amps 25 KA, Ics=100%Icu Adjustable thermal and adjustable magnetic release - 05 nos MCB 4 pole 415 V 06-32 Amps 10 KA, TM release - 01 nos Voltmeter (0-500) V digital type with selector switch.-01 No, Astro timer switch with auto ON/Off to street lights including TPN MCB 15A Ampere Meter (0-500) Amperes, 96mm square, digital type, CT connected with suitable CTs and selector switch-)1 No, Phase indicator, LED type each Set

Supplying and laying of cable XLPE insulated screened PVC bedded,galvanised steel strip or wire armoured,electric power cable (heavy duty) 1100 volts grade with stranded aluminium conductor of size 25 Sqmm 4 core complete all as specified and directed.

Excavation in trenches in soft/loose soil not exceeding 1.50 mtr wide and not exceeding 1.50 mtr in depth for foundation of poles/ stays/ laying of cables etc and getting out including trimming of sides of trenches complete all as specified and directed.

Returning, filling the soft / loose soil including spreading, leveling watering and well ramming in layers not exceeding 25 cms thick each layer complete all as specified and directed.