Construction of civil hospital at Rohru District Shimla SH Providing EI therein left out work

Amount

Wiring for light point / fan point / exhaust fan / call bell point with 1.5 Sq. mm. PVC insulated heat resistant flame retardant (HRFR) and low smoke single core (flexible) copper conductor cable in surface/recessed steel conduit and earthing the light point with 1.5 Sq.mm. HRFRLS/PVC insulated single core copper conductor cable as required. Group 'C'.

Fan Point

Exhaust Fan Point

Providing and laying of one No. aluminium conductor, PVC insulated and PVC sheathed, armoured/XLPE power cable, working voltage 1100 volts grade direct in ground; to be laid 1 meter below the ground level including excavation sand cushioning, protective covering and refilling the trench etc. of the required size:-

Armoured cable 6 sq. mm (twin core)

Armoured cable 25 sq. mm (3.5 core)

Armoured cable 35 sq. mm (3.5 core)

Providing and fixing 25mm x 5mm copper strip in 40 mm dia. G.I. pipe from earth electrode etc. as required.

Supplying and fixing sheet metal bus-bar chamber suitable for 63 Amp. 415 volts capacity with 4 No. copper strip bus-bars each of length 450mm & cross-sectional area (16mmx3.17mm), enclosure made from 1.6 mm thick M.S. sheet having overall dimensions (530mmx350mmx150mm) nominal with all accessories including connections, earthing the body etc. as required:-

Providing and fixing following rating, four pole, 415 volts, On-Load change over switch unit, AC 23 A duty, in sheet steel enclosure, with side handle operation, including drilling holes on the board, making connections, etc. as required.

Supplying and fixing following rating, four pole, 415 volts, Isolator in the existing MCB DB complete with connections, testing and commissioning etc. as required.

63 Amps. Cat-A.

Supplying and erection of street light bracket made of G.I. pipe 'A' class of suitable length and dia, the pipe bended to give an angle of 100 to 110 degree fitted with bolt & nuts at the top of existing pole or wall including painting the pipe with two coats of approved paint over priming coat complete in all respects as required:-

40 mm dia. G.I. pipe, heavy class

Providing, Installation, testing and commissioning of ceiling fan with regulator, including wiring the down rods of standard length (up to 30 cm) with 16/0.20 mm twin twisted flexible, cotton braided, copper cable, including providing and fixing phenolic laminated sheet cover on the fan box and earthing etc. as required:-

Ceiling Fan 1200 mm sweep, Category-A

Providing and installation of exhaust fan of following sizes in the existing opening, including making the hole to suit the size of the above fan, making good the damages, connections, testing and commissioning etc. as required:-

Exhaust Fan, Light duty, (Domestic) 300 mm sweep

Providing and installation of following type of ultra slim decorative LED batten with extruded aluminium heat sink,with anti glare polycarbonate diffuser and energy efficient constant integral,electronic driver,suitable for input voltage:AC 220-240 V,50/60Hz,complete with all accessories,including mounting clips & loop in loop out wire,connections,testing and commissioning etc.as required with two years warranty. Make:Philips,GE,Twinkle or any other approved by Engineer-in-Charge.

LED Batten Light 10 W 600mm

Supplying and fixing of surface mounting Square Ceiling Lights LED type of all size and shapes,complete with all accessories including making connectoins, testing etc.as required to the best setisfication of Engineer-in-Charge as required with two years waranty. Make: Philips, Twinkle, GE or any other approved by Engineer-in-Charge.

Surface mounting Ceiling Fitting 18 watt.

Providing and installation of following type of Surface / Recess mounting Round / Square type LED Panel Light , powder coated housing made of CRCA sheet, suitable for input voltage: AC 220-240 V, 50/60Hz, complete with all accessories, including making connections, testing and commissioning etc. as required with minimum 2 years warranty. Make: Twinkle, GE, Philips or any other approved by Engineer-in-Charge.

LED Panel Light 36 Watt. ( Size : - 2' x 2' )

Providing, installaton of following type of LED Type Street Light with polycarbonate body and aluminium heat sink,suitable for input voltage AC 220-240 V, 50/60 Hz, including mounting the fixture, testing etc. as required complete in all respects with two years warranty. Make:- Philips, GE, Twinkle or any other approved by Engineer-in-Charge.

Street Light LED 150 Watt

Shifting of 2 no Generator set at the entrance to back sideincluding providing Re-erectioninstalation testing and commissioning of the both generator set to a pre-defind place to the best satisfaction of engineer in charge

Generator 10KVA

Generator 100KVA

vijan agencies

D.S Ranta Electrical Contractor

sai electricals