Wet Waste Processing Unit for 3 Tons at Nagar Panchayat Sahanpur Distt Bijnor

Earth work in surface excavation not exceeding 30 cm in depth but exceeding 1.5m in width as well as 10 sqm on plan including getting out and disposal of excavated earth upto 50 m and lift upto 1.5 m, as directed by Engineer-in-Charge 2.1.1. All kinds of soil.

Excavating, supplying and filling of local earth (including royalty) by mechanical transport upto a lead of 5KM also including ramming and watering of the earth in layers not exceeding 20cm in trenches, plinth, sides of foundation etc. complete

Providing & Laying of C.C. in 1:6:12 with c/s and 40 mm G.S.B. in foundation of Floor i/c all labour ,materials and T&P etc.

R.C.C. work in column/slab/wall 1:2:4 with cement, coarse sand, 20 mm gauge stone grit I/c all complete

M150 Brick Work in 1:6 c/s mortar in sub-structure i/c all labour & T&P etc.

12 mm thk Internal Plaster in 1:3 with c/s mortar in wall i/c all materials, labour & T&P etc. S.I-586

Providing & laying steelbars including cutting binding, placing and complete in all respect

Mild steel or iron work in heavy size such as trusses, build up gates record racks, roof work, gates etc wrought to required from including drilling holes riveting or welding where necessary and their fixing required for proper completion of the work.

Mild steel or iron work of small size and sections such as holding down bolts, hold fast, tie rods, grating etc,(when not included in an overall rates) wrought to required shape as necessary for bending etc including supply of steel and its wastage including cost of bolts, nuts if required, welding, grinding and making holes as required for completion of work but

Providing and fixing precoated galvanised iron sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+0.05%) total coated thickness with zinc coating 120 grams per sqm as per IS:277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling metre or as desired by Engineer-in-charge. The sheet shall be fixed using self drilling/self tapping screws of size (55x55mm) with EPDM seal, complete upto any pitch in horizontal/vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required