GF 2025-26

CENTRIFUGAL MONOBLOC PUMPSET AS PER IS 9079/2002 WITHOUT PANEL BOARD THREE PHASE Supply and delivery of Electric Monoset centrifugal pump conforming to IS 9079:2002 as amended from time to time, with CI FG 200 Casing, hydraulically and dynamically balanced Bronze grade LTB-2 impeller, impeller ring and casing ring, stainless steel shaft capable of is charging required quantity of water against a total head noted below due to all causes. Pump shall of BEE 3 Star Rated and capable of discharging the specified quantity at the head noted at the minimum NPSHA at site conditions. The shut off head shall be atleast 25% over and above the head at duty point. The pump shall be suitable for operation in AC three phase , 415 V+/- 10%, 50 Hz +/- 5%. Squirrel cage induction motor for continuous operation. The speed of the Pump and Motor shall be not less than 2700 to 2900 RPM respectively. 150x50 LPM

Labour Charges for erection of Horizontal shaft, centrifugal pumpset (Coupled/Monoblock) in bore well/Openwell including fixing of suction pipe and foot valve upto a maximum depth of 7 metres and delivery pipes to the required length with valves, pressure gauges upto the exterior wall of pump room and erection of panel board consisting of TPIC switches starter, Voltmeter, Ammeter, Capacitor single phasing preventor and laying and jointing the cables and twin earthing as per IE rules including providing bed blocks etc., complete and operating the pumps and trial run for 10 days including signing of completion of reports as required by EB authorities. .

Earth work excavation in all soils and sub-soils to a full depth as may required except hard rock requiring blasting with an initial lead and lift of 10m and 2m respectively

Plain Cement Concrete 1:4:8 (one cement four Parts of crushed stone sand and eight coarse aggregates) using 40mm size ISS HBG metal including cost and conveyance of all materials to site and including for the mixing, laying and labour charges and all incidential charges such as water providing etc., complete as per standard specification

Brick work using Fly Ash Bricks 230 x 110 x 70mm in Cement Mortar 1:5 (One cement and five m.sand) including curing neat finishing, etc., complete complying with standard specifiction.

Plastering in cement mortar 1:5 mix 12mm thick using clean screened sand and including cost of curing for fifteen days from the completion of the work and surface should free from undulations and including the cost of preparing the surface for plastering and protecting for plastering for plastering and protecting from other damages till setting of mortar etc.complete complying with standard specification--10m2

Supply and delivery of M.S. Kiosk of size 1.20m x 0.6m x 0.70m made up of MS angle of size 50mm x50mm x4mm alround covered with 16 gauge MS sheet and kiosk door made up of MS plates of size 25mm x 3mm including cutting, welding, grinding, locking arrange as per bill