(CM MONIT) Construction Work of C.C. Floor From kampoo thana to kasturba chauraha beside 1000 bistar hospital kampoo. Ward No. 54, Zone 21 file No. 659/25X3/6.

Excavation for roadwork in soil with hydraulic excavator including cutting and loading in tippers, trimming bottom and side slopes, in accordance with requirements of lines, grades and cross sections, and transporting to the embankment location with all lifts and lead up to 1000 m as per Section-300 of the specifications.

Providing crushed stone aggregate, depositing on a prepared surface by hauling vehicles, spreading and mixing with a motor grader, watering and compacting with a vibratory roller including all leads and lifts confirming to Section 407 of specifications to form a layer of Base By Mixing Plant: For 53 mm maximum size

Providing, laying, spreading and compacting graded stone aggregate to wet mix macadam confirming to provisions of Section 406 of specifications including premixing the material with water at OMC in mechanical mix plant, carriage of mixed material by tipper to site, laying in uniform layers with paver in sub- base/base course on well-prepared surface and compacting with vibratory roller to achieve the desired density. Deduction if paver is not used for spreading.

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering All work up to plinth level. Cement concrete grade M-20 (Nominal Mix) with 20 mm maximum size of stone aggregate

Providing Brick masonry in cement mortar 1:3 (1 cement :3 sand) with well burnt chimney bricks (crushing strength not less than 40kg /sqcm and water absorption not more than 15%) in foundation complete excluding pointing and plastering, as per drawing and technical specifications and as per sections 1000, 1300 and 2100 of the specifications.

Plastering with cement mortar (1:3) on brick work in sub-structure as per Technical specifications.

Centering and shuttering including strutting, propping stretching etc. complete for and removal of form work by sheet plate or ply wood shuttering for :plint beam, beam

Reinforcement for R.C.C. work including straightening, cutting, bending, placing in position and binding upto floor level including cost of binding wire, wastage and over laps upto 12mm horizontal/ inclined position of reinforcement bars in slab and beams, plinth, chajjas, lintels, upto 4.5m vertical length of reinforcement in wall columns (over laps shall be provided as per requirement of IS : 13920; IS 456 & SP : 34) etc. complete Hot rolled deformed bars

Structural steel work riveted, bolted or welded in built up sections, trusses and framed work, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete:

Providing and laying below ground unplasticised PVC pipe to with stand working pressure of 4 kg/cm2 soild waste pipes confirming to IS:13592 and IS:4985 including jointing with seal ring confirming to IS :5282 leaving 10mm gap for thermal expansion all necessary fittings etc. complete. 110 mm diameter OD

Supplying, stacking and spreading of good earth at site including royalty and carriage (earth measured in stacks will be reduced by 20% fo rpayment.