REPAIR TO CONNECTED PATHS PCC HARDSTANDING ETC OF ZONE C UNDER AGE BR DETT-III OF GE 862 EWS

Demolition of cement concrete (unreinforced) of any description & in any portion not otherwise specifically provided for & removal of demolition material to out side from site, complete all as specified and directed.

M&L for Cement concrete work (PQC) in pavement/hard-standing of flexural strength 40kg/per square centimetre in field using 400 kg of cement per cubic metre, thickness of concrete 25 cm or less, complete all as specified and directed.

Forming 12mm thick expansion joints filled with pre-formed bituminous filler and top 30mm primed and sealed with sealing compound, Grade ‘A’, thickness of concrete 150 to 200mm, complete all as specified and directed.

M&L for plain cement concrete 1:3:6, type C-2 (using 40mm graded crushed stone aggregates) as in surface channel and drains including necessary form work, complete all as specified and directed.

M&L for forming fair finshed drain or channel 30cm inner girth in cement concrete, using extra cement including forms, moulds, mitred/ stopped ends, complete all as specified and directed.

M&L for plain Pre-cast Cement Concrete 1:3:6, type C-1 (using 20 mm graded crushed stone aggregates) as in block masonry with solid blocks, exc 10cm in width and setting in CM 1:6, complete all as specified and directed.

M&L for Plain Cement Concrete 1:2:4, type B-1 (using 20 mm graded crushed stone aggregates) as in coping including necessary foam work, if required, complete all as specified and directed.

M&L for rendering 15mm thick in cement mortar 1:4 on stone walls or other than fair faces of brick walls fiinished even and smooth without using extra cement, complete all as specified and directed.

M&L for pre-cast RCC 1:2:4, type B-1 (using 20 mm graded crushed stone aggregates) cover slabs for manhole slabs (for manholes etc) chullah hoods, chajjas, water toughs, mangers, shelves and similar articles with plain faces set in CM (1:6) & including demolition, complete all as specified and directed.

M&L for mild steel TMT bars 6-8mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips, complete all as specified and directed.