Work of installing cat eyes, solar blinkers etc. on Baghpat bypass road Other District Road in Baghpat district in the financial year 2026-27.

Reflective Raised pavement Marker with Shank providing and fixing of Raised Pavement Marker with Twinkshank of adequate length anchored with epoxy-bitumen adhesive of approved make (Cat-eyes) Type XASTMD-4956-04 Avery Dennision/3M (USA Make) having moulded body of Polycarbonate, ASA, HIPS or ABS able to support a load 13.635 MT. tested in accordance with ASTMD-4280 Type-H and other requirement mentioned MORT & H Circular, its refective lence made of Micro Prismatic Lence (capable of providing total internal reflection of light) electronically welded to the body. The length, height, width of the body shall not exceed 130mm., 20mm. and 105mm. respectively. The area of each reflective surface shall not be lessthan 13Sqm. on each site sloping at the angle of 35+5 Degree to the base to ensure maximum reflectively. It shall be comply to specification of category 'A' of MORT & H Circular No. RW/ΝΗ 33023/10/97-Do-III dt. 11.06.1997 lences shall be moulded of Methylmethecrylate confirming to ASTMD788 or equavalant. Rate shall be inclusive of all taxes, royalty etc.. All T & P/M-Material and labour required for proper completion of the (including labour cess but excluding GST.). Note: The complete warrantly jontly signed by original manufacturer and authorized of at least 7 years shall be furnished on non-judical stamp of required denomination. Including supply of all Material, Labour, T&P etc also including VAT, labour cess, royalty, but excluding GST and all other applicable Taxes required for proper completion of work as per direction of Engineer-in-charge

Supplying and erecting red /yellow unbreakable polycarbonate body Solar Blinker 300mm dia. LED lamp confirming to IRC:93 and IS:7537. It shall have Light Emitting Diode (LED) Hi Bright technology (Compliant to EN12368 or equivalent BIS standard). The Signal Switching shall be Solid State, with Opto-isolation. The Automatic operation mode shall have functional flashing rate available at 50% Duty Cycle 50 or 60 Flashes/minutes. The Electrical Power Supply shall be solar based 12 VDC operating at Ambient Temperature 0 to 55°C. The solar power system shall have in-built charge Controller - Low/High cut out, Solar SPV Module -60 Watts, Maintenance Free Battery (60AH) (having back up for operating blinker for 72 Hrs in absence of Sun or during rainy or foggy days. The Solar System shall be housed in a weatherproof pole mounting cabinet with clamp and mounting accessories. The Solar Blinker shall be supported on Gl circular pipe 80 NB, 3.2 mm thickness confirming to IS 1239, 3m above the Finish Road level. Gl circular pipe shall be firmly fixed to the ground by means of properly designed foundation with M 25 grade cement concrete 45 cm x 45 cm x 60, 60 cm below ground level as per approved drawing. Alternate white and yellow bands (Minimum four bands) of Type XI retro-reflective sheeting shall be pasted 0.5m c/c starting from a height of 0.5 m above the finish road level, Including supply of all Material, Labour, T&P etc also including VAT, labour cess, royalty, but excluding GST and all other applicable Taxes required for proper completion of work as per direction of Engineer-in-charge