Const. of Residence of the Executive Officer in Nagar Panchayat Gabhana.

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineer-in-charge. All kinds of soil DSR 2023 Code 2.6.1

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering. All work up to plinth level 1:2:4 (1 Cement & 4 coarse sand (zone-III) derived from natural sources: 8 graded stone aggregate 40 nominal size derived from natural sources

Reinforced cement concrete work in beams suspended floors, roofs having slope up to 15 degree landings, balconies, shelves, chajjas, lintels, bands, plain window sills, staircases and spiral stair cases above plinth level up to floor five level, excluding the cost of centering, shuttering, finishing and reinforcement with 1:1.5:3 (1 cement: 1.5 coarse sand (zone-III) derived from natural sources: 3 graded stone aggregate 20 mm nominal size derived from natural sources) Lintel of doors & window sunshades etc

Brick work with common burnt clay F.P.S (non modular) bricks of class designation 7.5 in foundation and plinth: Cement mortar 1:4 (1 cement & 4 coarse sand)

Providing and laying damp-proof course 40mm thick with cement concrete 1:2:4 (1 cement: 2 coarse sand (zone-III) derived from natural sources: 4 graded stone aggregate 12.5mm nominal size derived from natural sources)

15 mm cement plaster on rough side of single or half brick wall of mix: 1:4 (1 cement: 4 coarse sand)

Centering and shuttering including strutting, propping etc. and removal of form for all heights (1) UPTO PLINTH LVL (a) Foundations, footings, bases of columns, etc. for mass concrete. (b) Columns, Pillars, Piers, Abutments, Posts and Struts.

Extra for additional height in centering, shuttering where ever required with adequate bracing, propping etc., including cost of de-shuttering and decentering at all levels, over a height of 3.5 m, for every additional height of 1 metre or part there of (Plan area to be measured) Suspended floors, roofs, landings, beams and balconigs (Plan area to be measured)

Providing and fixing ISI marked flush doors shutters conforming to IS: 2202 (Part I) decorative type, core of block board construction with frame of 1st class hard wood and well matched teak 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters (a) 35 mm thick including ISI marked Stainless Steel butt hinges with necessary screws

Providing and fixing two track two panels sliding window with aluminium channel for roller track. Using R4 series with frame (64mm & above) x (45mm & above) ....................................(Height above 1.8 m)