Loading
Loading…
Loading…
| # | Company | Amount | Rank | Status |
|---|---|---|---|---|
| 1 | L1₹13.4 LAccepted-AOC COAL INDIA LIMITED CIL | KODERMA | JHARKHAND | 825318 | L1 | Accepted-AOC L1 BIDDER IS TECHNO COMMERCIALLY ELIGIBLE | |
| 2 | Rejected-Technical LAMTIBAHAL BRAJRAJNAGAR B PIT BRAJRAJNAGAR JHARSUGUDA ODISHA 768216 | BRAJRAJNAGAR | JHARSUGUDA | ODISHA | 768216 | - | Rejected-Technical rejected as Bidder is NOT L1 | |
| 3 | Rejected-Technical AT IB PIT PO LAMBIHAHAL PS BRAJRAJNAGAR JHARSUGUDA ORISSA PIN 768216 | JHARSUGUDA | JHARSUGUDA | ODISHA | 768216 | - | Rejected-Technical rejected as Bidder is NOT L1 |
Tender Value
₹18.5 L
EMD Value
₹23,200
Closing Date
7 May 2024, 5:00 pmClosed
Staff Officer(ENM), IB Valley Area
Office of Staff Officer(ENM), IB Valley Area
Fabrication and erection of 03 nos of shed at pumping station and pump workshop for installation of pump starters and storage of electrical motors including covering of 08 motors on pontoons at SOCP, IB Valley Area.
2024_MCL_307097_1
MCL/GM/IBV/ENM/etender/112121 Dated.26.04.2024
Open Tender
Miscellaneous Works
Item Rate
30 days
SOCP, IB Valley Area
Please refer Tender documents.
3 documents required · 3 mandatory
₹23,200
29 May 2024
26 Apr 2024
9 May 2024
27 Apr 2024
7 May 2024
27 Apr 2024
27 Apr 2024 - 30 Apr 2024
Amount
Fabrication and erection of 03 nos of shed at pumping station and pump workshop for installation of pump starters and storage of electrical motors including covering of 08 motors on pontoons at SOCP, IB Valley Area.
Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.
Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-charge) 0.50 mm (+ 0.05 %) total coated thickness with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer- in-charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.
Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:3:6 (1 Cement : 3 manufactured sand derived from Recycled Concrete Aggregate (RCA) : 6 graded stone aggregate 40 mm nominal size Recycled Aggregate (RA) )
Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:2:4 (1 cement : 2 coarse sand (zone-III) derived from natural sources : 4 graded stone aggregate 20 mm nominal size derived from natural sources)
Total impact of GST plus Labour Cess [@ 1 % (BOCW Cess to be deducted from the RA bill as per the value of the work progress)] for the purpose of CTC
AKASH SINGH
MAHESH PRASAD SINGH
tech_eval.pdf
fin_eval.pdf
aoc.pdf
boq_comp_chart.xlsx
xlsx
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .