Special repair works to 1 No. of DSP, 1 No. of INS and 40 Nos. of PC/HC quarters building at Attur in Salem District.

Amount

41 : Painting - New "iron work"

52 : PVC Water supply (ASTM) a. 32 mm dia

b. 25 mm dia

c. 20 mm dia

Electrical arrangements 74 : Charges for fixing of "Fan"

81 : Meter cupboard

ANNEXURE-I 10.2.1 : Brick partition work in C.M. 1:4 using chamber Burnt bricks of size 23 x 11.4 x 7.5 cm (9" x 4 1/2"x 3") 114 mm tk (B.P.) with admixture (using crushed stone sand) in the following floors b. In Ground Floor

d) In Second Floor

14.1.1.II : Precast cupboard slab 40 mm tk using standardised concrete mix M20 grade.(using crushed stone sand) a. In Foundation & basement

23.2.1 : 4mm thick pin headed Glass panels with Aluminium beedings

23.5 : Supply & fixing of MS door including labour charges and all relevant materials etc., all complete. a) MS door of size 900 x 2100mm

32.1.1: Finishing top of roof with one course of Hydraulic Pressed Tiles of approved superior quality of size 23cmx 23cmx20mm thick laid over weathering course in cm 1:3 (One of cement and three of crushed stone sand) 12mm thick mixed with Water proofing compound at 2%

33.1 : Plastering in C.M. 1:5, 12 mm tk. (using crushed stone sand) with plasticizer

35.1.2 : Spl. Ceiling plastering in C.M. 1:3, 10 mm tk. (using crushed stone sand) with plasticizer

38.7 : Plastic Emulsion PAINT including primer for inner walls

43.1 : Supply & Fabrication of Mild steel / RTS grills (without cement slurry) for all sizes of rods.

54.1.1 : S & F of 15mm dia half turn CP long body tap

54.2.1 : S & F of 15mm dia half turn CP short body tap

57.1.2 : S & F of E.W.C (White) 500mm with PVC SWR grade "P" or "S" Trap (using crushed stone sand)

58.3 : PVC SWR pipe (Soil line) with ISI mark - type 'B'. a. 110 mm dia.

b. 75 mm dia.

61.3 : UPVC Non Pressure pipe of SN8 SDR 34 (S 16.5) as per IS 15328/2003 a. 110 mm UPVC Non Pressure pipe

b. 160 mm UPVC Non Pressure pipe

75.1.2 : Supply and delivery of 48" (1200 mm) Fan with ISI mark with Eletronic Dimmer

84: Run off the 2 wires of 4sqmm copper PVC insulated single core cable with one run of 7/20GI stay wire suspended with porecelin reel insulators at 1.0m centre to centre for support of phase and neutral cable from top of street pole to the house / flats including all materials etc... all complete for EB service connections including labour charges for fixing GI wire and MS angles (For EB Service connection single phase)

87.1: Supplying and delivery of Three phase ELCB/RCCB

211: Clean removal of the old cement plastering both inside and outside from the existing walls of brick masonry and racking out joints to 20mm deep without damaging the existing structure and surroundings and clearing the debris away from the site including cost of required tools and plant and necessary scaffolding if necessary etc., all complete in all respect and as directed by the departmental officers.

211.2: Clean removal of the old cement plastering both inside and outside from the existing walls of brick masonry without damaging the existing structure and surroundings and clearing the debris away from the site including cost of required tools and plant and necessary scaffolding if necessary etc., all complete in all respect and as directed by the departmental officers.

218.1: Dismantling the existing damaged Pressed tiles and weathering course in cement mortar without affecting the adjacent structures in all floors including the cost of required tools and plants and clearing the debris away from the site etc., all complete and as directed by the departmental officers.

241: Dismantling the existing damaged brick works of cement mortar in all floors without affecting the adjacent structures, including the cost of required tools and plants and clearing the debris away from the site including cost of loading, unloading & vehicle hire charges etc., all complete in all respect and as directed by the departmental officers. a) Upto 3.00m height

ANNEXURE - I A1: Painting the old walls with two coats of oil bound distemper of approved brand over the thorough scrapped wall surfaces including scrapping.

A2: White washing two coats for old walls using clean shell lime slaked

A3: Painting the old wood work with two coats of approved Ist class synthetic enamel paint including clean removal of old paint using sand sand paper as required by the departmental officers including cost of paint, brushes labour charges etc., all complete as directed by the departmental officers. (The quality and the shade of paint should be got approved by the Executive Engineer before use) complying with relevant standard specifications.

A4: Painting the old Iron work and other similar works such as steel windows ventilators and grills with two coats of approved Ist class synthetic enamel ready mixed paint of approved quality and brand, through scrapping including cost of paint, brushes labour charges etc., complete. (The quality and the brand of paint should be got approved by the Executive Engineer before use) complying with relevant Standard specifications.

A5: Painting two coats for old walls with ready mixed plastic emulsion paint of first class quality paint of approved colour and shade for outer wall and other similar works including thorough scrapping and without priming coat

A6: Clearing the scrub jungle available in the site and removing the same and disposing off as directed by the departmental officers. The cost include uprooting roots if any, all tools and plants required etc. all complete as per relevant standard specifications and as directed by the departmental officers.

A7: Supply and fixing of 32mm dia PVC waste pipe and CP couplings with required gratings of best approved quality to the sink already fixed including cost of all materials, labour for fixing etc., all complete and as directed by the departmental officers.

A8: Removing and refixing of 150mm dia aluminium tower bolt best quality with ISI mark including cost of fittings with required specials and labour charges for fixing etc., all complete and as directed by the departmental officers.

A9: Removing and refixing of 250mm dia aluminium aldrop best quality with ISI mark including cost of fittings with required special and labour charges for fixing etc., all complete and as directed by the departmental officers.

A10: Removing and refixing of 16 amps fuse unit best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A11: Removing and refixing of Battern type holder best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A12: Removing and refixing of ceiling rose best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A13: Removing and refixing of 5 amps flush type switch best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A14: Removing and refixing of 125 mm long x 30 mm width aluminium Butt hinges best quality with ISI mark including cost of fittings with required special and labour charges for fixing etc., all complete and as directed by the departmental officers.

A15: Removing and refixing of 75mm long aluminium towel rail best quality with ISI mark including cost of fittings with required special and labour charges for fixing etc., all complete and as directed by the departmental officers.

A16: Removing and refixing of 150mm aluminium door handle best quality with ISI mark including cost of fittings with required special and labour charges for fixing etc., all complete and as directed by the departmental officers.

A17: Removing and refixing of 5 amps 5 pin plug switch best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A18: Supplying and fixing of Dimmer Type Electronic 300W / 450W Square Type Fan Regulator best quality with ISI mark including cost of material and labour charges for fixing etc., all complete and as directed by the departmental officers.

A19: Supplying and laying of following dia PVC pipe including earth work excavation & refilling trenches etc., all complete. (Below GL ) a. 50mm dia PVC pipe 6Kg/cm²

A20: Cleaning the existing septic tank such as sewage waste and liquid using 5000 litres capacity tank vehicles and disposing the same away from the site including hire and conveyance charges for the vehicle, labours all tools and plants employed there of as directed by the departmental officers.

A21: Supplying and fixing of 25W LED Street light with necessary fittings (Superior variety) Charges for fixing 25W LED lamp street light fittings

A22: Supplying and fixing of LED blubs suitable for fixing it to pendent / bakelite battern holder of best approved variety a) 9 watts LED bulb

A23: Supplying and fixing of 4 feet 18watts LED tube light with ISI mark including cost of materials and labour fixing etc

A24: Charges for removal of old PVC tank and cutting plants and refixing the PVC tank in position etc., all complete and as directed by the departmental officers.

A25: Supplying and fixing of PVC water storage tank cover lid for 700 lit capacity including cost of conveyance, labour charges for fixing etc., all complete and as directed by the departmental officers.

A26: Run of main with 2 wires of 1.5 sq.mm. copper PVC insulated unsheathed single core 1.1 kv grade cable with continuous earth by means of 1.5 sqm copper PVC insulated unsheathed single core1.1. kv. grade cable (open wiring)

A27: Supplying and fixing of 16Amps double pole main switch with fuse and neutral link

M K SARAVANAN (BID ID -1065351)

S Kumar and Co (BID ID -1070446)