Loading
Loading…
Loading…
Tender Value
₹2.3 Cr
EMD Value
₹4.7 L
Closing Date
23 Apr 2026, 3:00 pmClosed
No
No
Single Packet System
Normal Tender
No
Not Applicable
Lowest to Highest
60 days
Expenditure
Capital (Works)
Above/Below/Par
SRDSTECSIG
14 conditions · 2 needing a document upload
Financial Eligibility Criteria: The tenderer must have minimum average annual contractual turnover of V/N or 'V' whichever is less; where V= Advertised value of the tender in crores of Rupees N= Number of years prescribed for completion of work for which bids have been invited. The average annual contractual turnover shall be calculated as an average of "total contractual payments" in the previous three financial years, as per the audited balance sheet. However, in case balance sheet of the previous year is yet to be prepared/ audited, the audited balance sheet of the fourth previous year shall be considered for calculating average annual contractual turnover. The tenderers shall submit requisite information as per Form-2, along with copies of Audited Balance Sheets duly certified by the Chartered Accountant/ Certificate from Chartered Accountant duly supported by Audited Balance Sheet.
Technical Eligibility Criteria: The Tenderer must have successfully completed or substantially completed any one of the following categories of work(s) during last 07 (seven) years, ending last day of month previous to the one in which tender is invited: (i)Three similar works costing not less than the amount equal to 30% of advertised value of the tender, or (ii)Two similar works costing not less than the amount equal to 40% of advertised value of the tender, or (iii)One similar work costing not less than the amount equal to 60% of advertised value of the tender.
Defination of Similar Work :- Any Signalling or Telecom work involving provision of marking boards of any type. Note 1: Tenderer may be required to submit the schedule of those works, Completion/Performance Certificates of which have been submitted by him/her in support of 30% / 40% / 60% (as the case may be) criterion of similar nature of work.
14 conditions · 9 needing a document upload
Please enter the percentage of local content in the material being offered. Please enter 0 for fully imported items, and 100 for fully indigenous items. The definition and calculation of local content shall be in accordance with the Make in India policy as incorporated in the tender conditions.
PAN Number to be attached.
Registered Office Address with contact no.
Detail of Bid Security paid, through only payment modes available on IREPS portal like net banking, debit card, credit card etc.
Mandatory undertaking regarding Employment/Partnership of Retired Railway Employees as per Clause No. 12 of Chapter-I as per Annexure- E.
Mandatory certificate to be submitted by tenderer along with tender documents as per Annexure- A.
GST Number to be attached.
Mandatory Power of Attorney to be submitted by tenderer along with tender documents as per Annexure- B.
MOA & AOA, Resolution of Board and POA, Sole Proprietorship, Notarized partnership deed with POA and latest certificate of registration with Registrar of the firms must be attached. Year of Formation / Incorporation. (As per Clause-10 of Tender Document
Upload duly filled and signed Cover Letter (Tender Form 1)
Mandatory Document Tenderer uploaded Annexure-A (1) {This certificate is to be given by attorney/authorized signatory/each member of Partnership firm/Joint Venture (JV)/Hindu Undivided Family (HUF)/Limited Liability Partnership (LLP) etc.)}of tender documents.
An undertaking by the tenderer shall be provide at the time of tender submission that the equipment shall be procured from RDSO/TEC/OEM covering supply, installation, testing, commissioning of system including after sales support required during the warranty period.
Provision of Retroreflective Number Plates, Markers, Boards, and other misc items for Signalling Assets over Delhi Division.
558-Sig-16-M-Tender-1475
558-Sig-16-M-Tender-1475
Open
Works - General
12 Months
Delhi, Delhi
₹0
₹4.7 L
23 Apr 2026
1 Apr 2026
9 Apr 2026
27 items across 1 schedule
| # | Description | Unit | Qty | Rate | Amount |
|---|---|---|---|---|---|
| — | — | — | 2,33,05,787.35 | ||
| — | 850.00 | — | — | ||
| Casting, concreting, curing of foundations of size (400mmx300mm) at surface and 1000mm deep and erection of retroreflective SLB/BSLB/SB/ calling on boards/stop dead boards/ Goods Warning Board/ Passenger Warning Board / Automatic Signalling Territory board etc as per drg. No. NR/S&T/CON/7.4/97 & provisions of SEM. Supply of SLB/BSLB/SB/calling on boards etc as per approved Drg. No.SA-2373 or latest has to be done by the contractor. Inspection: Site Engineer | — | — | — | 78,52,300 | |
| — | 250.00 | — | — | ||
| Supply of Stop Board as per RDSO Drg No 7235/B / Block Section Limit Board/Shunting Limit Board as per RDSO Drg. No. SA2375 (Adv.) . This includes Painting and retro reflective arrangement should be as per SEM. Inspection: Consignee | — | — | — | 4,74,022.5 | |
| — | 250.00 | — | — | ||
| Supply of Different warning Boards /Calling on Board/Automatic territory board used for Railway Signalling system as per RDSO Drg.No. SA2380 (Adv). This includes Painting and retro reflective arrangement should be as per SEM. Inspection: Consignee. | — | — | — | 10,25,290 | |
| — | 500.00 | — | — | ||
| Fixing of Stop Board, Block section limit Board, Shunting Limit Board, goods warning board, Calling on Board with contractors own material. This excludes supply of Stop Board /Block section limit Board / Goods warning board/Calling on board. The work shall be done as per instruction of Rly Engineer at site. Inspection: Consignee. | — | — | — | 1,47,945 | |
| — | 5500.00 | — | — | ||
| Fabrication, Supply and fixing of retroreflective P/G/C/A/AG markers with complete fittings as per as per as per SEM Drg.19-D10 (Sheet 1 to 5) with film thickness 0.3mm on ACP sheet with Clamp for Main/Shunt Signal made of MS Flat of size 30mm x 3mm with nut & bolt as per SEM Drg.No. 19-D10 (Sheet 9-10).Inspection: Consignee. | — | — | — | 43,96,095 | |
| — | 7000.00 | — | — | ||
| Supply of Signal Number plate pressure sensitive Retro reflective type-high intensity grade white with imprinted 'Number/Alphabet' in black/White of size as per SEM Drg.19-D10 (Sheet 6 to 7) with film thickness 0.3mm on ACP sheet with Clamp for Main/Shunt Signal made of MS Flat of size 30mm x 3mm with nut & bolt as per SEM Drg.No. 19-D10 (Sheet 9-10).Inspection: Consignee. | — | — | — | 17,73,030 | |
| — | 4500.00 | — | — | ||
| Supply of Signal Marker Retro reflective type, high intensity grade white with imprinted Arrow Marker in white on red background of size as per SEM Drg.19-D10 (Sheet 8) with film thickness 0.3mm on ACP sheet with Clamp for Main/Shunt Signal made of MS Flat of size 30mm x 3mm with nut & bolt as per SEM Drg. No. 19-D10 (Sheet 9-10). Inspection: Consignee. | — | — | — | 9,48,915 | |
| — | 11500.00 | — | — | ||
| Fixing of P/G/C/A/AG/IB Marker/Arrow marker/Signal Number plates with complete fittings as per site requirement. | — | — | — | 23,66,700 | |
| — | 130.00 | — | — | ||
| Supply, installation, wiring, testing and commissioning of SPT (Half Duplex) at IBS location and adjacent stations. Each set shall comprise one no. of signal post telephone SPT) master unit post (Which should be installed on IBS post) along with one no. of slave unit to be installed in SM'S office suitable for working on 24VDC, 25KVRE area and compatible to work on OFC/Copper media both, ACES make or similar. Note: the contractor shall ensure that there is no interference in communication between the master and slave unit sowing to power hump due to RE induction. Cable from IB signal unit to the cable termination board in SM'Sroom/relay, room will be provided by Railways. (Inspection Agency: -Consignee) | — | — | — | 36,61,386.3 | |
| — | 2500.00 | — | — | ||
| Supply of Plastic cover for 2 (Two) Aspect Signal Unit Cover opened from front side and bottom side and made of black polythene sheet of 150 micron thickness. Size:- 1200mm X 460mm X 205mm On back side 75mm wide corner to corner diagonal cross mark 3 of silver colour of 150 micron thickness to be provided. To tie up cover with signal unit suitable nylon rope of 5mm Dia. and 4mtr length to be provided on front side and of 1.5 mtr length at centre. NOTE - Sample should be approved before bulk supply. Inspection agency : Consignee. | — | — | — | 1,74,325 | |
| — | 2500.00 | — | — | ||
| Supply of Plastic Cover For 3 Aspect Signal Unit, Cover Is Opened from Front Side and Bottom Side and Made of Black Polythene Sheet Of 100 Micron Thickness.Size:1300mmx460mmx205mm. On Back Side 75mm Wide Corner to Corner Diagonal Cross Mark of Silver Colour Of 100 Micron Thick Ness to Be Provided. To Tie Up Cover with Signal Unit Suitable Nylon Rope Of 5mm Dia. And 4 Mtr Length to Be Provided on Front Side and of 1.5mtr Length at Centre Make/Brand: self. Inspection agency: Consignee. | — | — | — | 1,89,100 | |
| — | 2545.00 | — | — | ||
| Supply of Plastic cover for 4 Aspect Signal Unit Cover is opened from front side and bottom side and made of black polythene sheet of 150-micron thickness. Size: -1700 mm X 460 mm X 205 mm on back side 75 mm wide corner to corner diagonal cross mark of silver colour of 150- micron thickness to be provided. To tie up cover with signal unit suitable nylon rope of 5 mm Dia. and 4 mtr length to be provided on front side and of 1.5mtr length at center. NOTE - Sample should be approved before bulk supply. Make/Brand: self. Inspection agency: Consignee. | — | — | — | 2,34,623.55 | |
| — | 1500.00 | — | — | ||
| Supply of Plastic Cover for Calling on Signal Unit Cover Open from Front & Bottom side of UV protected Black Polythene Sheet of 150 Micron thickness of size 300mm x 300mm x 190mm and Back side 50MM Corner to Corner white diagonal mark of silver color of 100 Micron thickness. Cover to be provided with Suitable Nylon Rope of 5mm Dia. and 1.5-meter length. (sample to be get approved from consignee before bulk supply). Inspection agency : Consignee. | — | — | — | 62,055 |
Tap a document below to read it instantly. You can also download everything as a ZIP if you prefer.
details.html
HTML
nit.pdf
NIT
Tender-Doc1475.pdf
ATTACHMENT
ACS-9.pdf
ATTACHMENT
GCCACS11.pdf
ATTACHMENT
Download all tender documents and submit your bid
Disclaimer: TenderKart has made every reasonable effort to ensure that the information on this page is accurate and authentic, however it cannot be held liable for any third-party claims or losses or any damages. TenderKart makes no warranty, expressed or implied, as to the results obtained from the use of this information. If you notice any error or omission, please let us know at .