Repair and routine maint of electrical lifts installed at CGRA Phase I Thalakancherry area under GE (I) (CG) Chennai

Amount

SCHEDULE 'A' - PART I (MAINTENANCE)

Comprehensive Maintenance and repairs of electriclly operated lifts of ECE Make 07 Nos at CGRA Thalkancherry including renewal/replacement of defective parts of Automatic Rescue device and over load warning device with a capacity of 10 passengers lift , 680 kg each-07 Nos for 6 stops/6 landings ,1.0 metre/Sec ,single speed single push button control system with micro processor control system with collectve control scheduled in Appx A by carrying out periodical checks , repairs and testing as per Proforma no :01 to 05 as recommended by the manufacturer to ensure smooth functioning and efficient operation including fixing only for the items mentioned below in schedule A part II ..

Comprehensive Maintenance and repairs of electriclly operated lifts of ECE Make 2000 KG capacity Goods Lift ,07 Nos at CGRA Thalkancherry including renewal/replacement of defective parts of Automatic Rescue device and over load warning device with 2000 kg each-07 Nos for 6 stops/6 landings ,0.50 metre/Sec ,single speed single push button control system with micro processor control system with collectve control scheduled in Appx A by carrying out periodical checks , repairs and testing as per Proforma no :01 to 05 as recommended by the manufacturer to ensure smooth functioning and efficient operation including fixing only for the items mentioned below in schedule A part II ..

Note for item No 2 to 3 (i) The spares/electrical items as listed in Sch 'A' will be used whenever required only and measured and paid separately under respective items. (ii) The rate is inclusive of all items as required at site except those items as given in supply only to keep the lift operational round the clock including cleaning and greasing all moving parts on monthly basis complete all as specified and as directed by Engineer-in-Charge. (iii) If spare parts of original make is not available in market necessary suitable spare equivalent to existing lift part as approved by GE shall be used in the work so that to run the lift with smooth functioning. (iv) Cost of renewal of lift license is deemed to be included in the quoted rate .

(v) Quoted rate incl the testing of all the lifts by licensed Lift Inspector of tamil nadu twice in contract period for saftey.Certificate issued by the licensed lift inspector shall be submitted to Eng-in-charge. (vi) In case of any of the lift/lifts is/are not working for more than 24 hours but less than 10 days, Recovery will be affected at the rate of Rs 2,000/- per lift per day and Rs 3,000/- per lift per day after 10 days. (vii) The above lifts shall be repaired through OEM (Original Equipment manufacturer) or through their nearest authorised/accredited agency service personel only.The lowest bidder shall submit and uploading MoU from the OEM of lift or their authorised/accredited agency at time of uploading of tender. (viii) Contractor should submit all valid docucments before the opneing of tehcnicial bid.

SCHEDULE 'A' - PART II ( SPARE PARTS)

Supply only mother board APCLD R 4 Make ECE

Supply only Door drive PKS 16 Make ECE

Supply only Main drive for goof lift Make: Toshiba

Supply only Main drive for 10 passanger lift make Yashkawa

Supply only Door motor make ECE

Supply only Door lock contact make ECE

Supply only Landing / Car door shoe make ECE

Supply only Door bearing make ECE

Supply only Break arm make ECE

Supply only Break pad make ECE

Supply only Main sheave make ECE

Supply only Break drum make ECE

Supply only Limit switch make ECE

Supply only Jc switch make ECE

Supply only Reed switch make ECE

Supply only Gear oil EP 460 make servo

Supply only VFVR Relay card , DC 24/110V make ECE

Supply only Transformer for controller T-500 input 230V AC output 90/20 V ac make ECE

Supply only OEN Relay DC 24V make Sallzer

Supply only Contactor assembly 4 pole DC 110V 32 Amps with Auxiliari contact Make :Siemen / ABB

Supply only SMPS Input 230V AC output 54V DC

Supply only VMVFCard DC 24V make ECE

Supply only Micro card for automatic rescue device Make Jeltron

Supply only Charger Card for automatic rescue device Make jeltron

Supply only Converter Card for automatic rescue device Make Jeltron

Supply only Transformer for automatic rescue device input 230V Output 12/110V DCand 230V AC

Supply only Six Relay Card DC 24V Make : ECE

Supply only Twelve Relay Card DC 110V Make : jeltron

Supply only MCB DP 20 Amps Make : Schneider

Supply only Full length sensor (Make Meco) Suitable for 10 passanger lift Make ECE

Supply only Floor Position Indicator Card Make ECE

Supply only illuminated Bush Button Working on DC 24V Make ECE

Supply only SS indicator Plate 1.5mm thick suitable for Full Collective lift Electronic Car Position Indicator make ECE.

Supply only Auxillary Contact Coil Amps With 4Nos NC AC 230V Make : Siemen / ABB

SCHEDULE 'A' - PART III

Taking down Main motor 3 phase 380 Volts, up to 09 KW, 1300/325 RPM and Material and labour for rewinding the same using suitable gauge of copper winding wire and all insulation item including varnishing drying and refixing of AME at site testing and incluing replacement of any minor parts if necessary including fixing of new nuts and bolts for foundation etc complete all as specified and as directed.

Taking down Main motor 3 pohase 380 Volts, up to 15 KW, 1300/325 RPMand Material and labour for rewinding the same using suitable gauge of copper winding wire and all insulation item including varnishing drying and refixing of AME at site testing and incluing replacement of any minor parts if necessary including fixing of new nuts and bolts for foundation etc complete all as specified and as directed.

Taking down cabin fan single phase, 230Volts and Material and labour for rewindingthe same using suitable gauge of copper winding wire and all insulation item including varnishing, drying and refixing of fan in lift cabin and testingcomplete all as specified and as directed.

Rewinding of break coil including opening and cutting old brunt out winding and Material and labour for rewindingthe same using suitable gauge of copper winding wire and all insulation item including varnishing, drying and refixing in same position and testingcomplete all as specified and as directed.

Supply and fix 10 watt (2') Tube light fitting. Make: havells Cat No: ENDURALINARNEARNEOBS10WLED 865 SPCWH or equivalent of philips, CG etc.

Velox Engineering Solutions Pvt Ltd

UNIVERSAL ENTERPRISES