REPAIR TO PERIMETER WALL GATE FENCING PCC PATH HARD STANDING AND CERTAIN B AND R WORKS AT WAR MEMORIAL COLONY 60 SCIENTIST HOSTEL AND MES KEY PERSONNEL QTRS UNDER GE I R AND D KANPUR

Amount

M&L for Brickwork with sub class ‘B’ bricks, straight or curved on plan exc 6m mean radius built in cement mortar (1:4) complete including demolition of brick or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles all as specified and directed.

As per Srl Item No 1.00 above but except bricks including demolition of brick or stone/boulder masonry, built in cement mortar including all quoins, arches, pillars, etc, but excluding ashlar facings, dressed stonework and precast concrete articles all as specified and directed.

Taking down old cement plaster from brick or concrete surfaces including raking out joints, hacking for key, scrubbing down with water etc. complete all as specified and directed.

M&L for rendering 15 mm thick on fair faces of brick work or concrete surfaces of wall in cement mortar (1:4) surface finished even and fair complete all as specified and directed.

M&L for rendering 15 mm thick on other then fair faces of brick work or concrete surfaces of wall in cement mortar (1:4) surface finished even and fair complete all as specified and directed.

M&L for preparation of new plastered surface of wall and applying two coats of cement base paint complete all as specified and directed.

M&L for preparation of new plastered surface of wall and applying two coats of colour wash complete all as specified and directed.

M&L for preparation of old plastered surface of wall and applying one coats of cement base paint complete all as specified and directed.

M&L for preparation of old plastered surface of wall and applying one coats of colour wash complete all as specified and directed.

Demolition of cement concrete in ground floor and paving not exc.15 cm thickness (below or above ground level) all as specified.

M&L for 75mm thick PCC (1:3:6) type C-2 as in plinth protection & finishing the surface even & smooth without using extra cement complete all as specified & directed.

M&L for Providing cement concrete 1:2:4 type B-1 in roof kerbs or Coping on compound wall, mud stops, gola, rounded, flat or chamfered on edges,complete all as specified and directed.

M&L for PCC 1:4:8 type D-2 (using 40mm graded stone aggregate) as in foundation, filling, mass concrete complete all as specified

Demolition of reinforced cement concrete of any description and in any position not otherwise specifically provided for complete all as specified and directed.

M&L for RCC (1:2:4) type B-0 (using 12.5 mm graded stone aggregate) as in cills, Fins, fascias, louvres, parapets, and railings exc. 60cm in height, , including necessary form work etc all as specified.

M&L for RCC (1:2:4) type B-1 (using 20mm stone agg type B1 using for gate Pillers, columns and posts etc complete all as specified

Formwork to faces of walls, retaining walls, abutments, parapets and staircase railings and similar work including attached pillasters, buttresses, etc, vertical or to batter for fair finished surfaces complete all as spd and directed.

Formwork to sides of pillars, posts, struts, piers, columns and stanchions for fair finished surfaces complete all as spd and directed.

M&L for Providing precast cement concrete type B0 1:2:4 (12.5mm graded agg) for louvres and Jallies, 50mm thick (measured solid), including all mouldings but excluding frame set in CM 1:4 including dismantling old RCC Jali complete all as specified and directed.

Dismentling wrought iron or mild steel work of such as grill/roof purlin etc not otherwise provided for complete all as specified & directed.

S&F Mild steel framed work as in doors, gates, grills, grating pintel higes stope hand made sliding bolts etc with ends of bars shouldered and /or riveted or forged into spikes framed guard bars and for ornamentals and intricate design conforming to Fe 410-0 or 310-0 of angle iron of other sections complete drilled for fixing of steel sheeting or other coverings to be prepared for handing or sliding with and incl either hooks and hinges doors (Exclusive of steel sheeting or other covering running rails and guides) and hanging also fastening and fixing with one shop coat of Zinc Chrmate paint (incl preparation of surface at contractor wksp before febrication, complete all as specified.

S&F for Framed work such as grills, gratings, etc. with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks and similar work con- forming to Fe.290.Gde-E-165 complete all as specified and directed.

M&L applying two coats of synthetic enamel paint over a coat of red oxide or zinc chromate primer including preparation of new steel or iron surfaces exc 10 cm width or girth, complete all as specified and directed.

S&F in repair Galvanised 2 strand steel barbed wire 2.24mm dia, barbed with 2mm dia barbs at 75 mm spacing and straining & fixing to RCC posts etc including securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. complete all as specified and directed. Note: (Each line wire to be measured).

S&F for Mild steel angle iron fencing post and sturts in fencing incl necessary cutting, drilling holes, welding etc and bending to swan neck shape as required and drilling holes notching for wires etc, flat iron fillets (for securing wire mesh etc) incl all necessary drilling, bolting or riveting, etc and similar work conforming to Fe-290 Gde E-165 complete all as specified.

S&F MS TMT bars 10mm dia and over deformed cut ot length bent to shape required including cranbing, bending spirrally, hooking ends and binding with and including mild steel wire annealed net less than 0.9 mm dia or securing with clips all as specified.

As per Srl item No 26.00 above but 5mm dia and over upto and including 10mm dia in stirrups, spacers and binders etc complte all as spd and directed.

S&F MS Screw bolts 12mm dia (machine made) with hexagonal or square heads at one end and screwed the other, or screwed both ends, each screwed end to be fitted with washers and one hexagonal or square nut, n.exc 5cm long complete all as specified and directed.

Supply only Chain Link MS Galvanisd Fencing, any size or type as directed

Fixing only Chain Link Fencing incl line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. incl provission of binding wire as specified and directed.

Demolition of cement concrete of any description and in any position not otherwise specially provided for complete all as specified and directed.

M&L for laying at or near ground level factory made Kerb Stone of M-25 graded cement concrete in position to the required line, level and curvature jointed with cement mortar 1:3 including making joints with or without grooves (thickness of joint except at Sharpe curve shall not be more than 5mm) including making drainage opening wherever required complete all as specified and directed by Engr-in-Charge. Note:-Pre cast Kerb Stone shall be approved by GE (I) R&D.

M&L applying two coats of synthetic enamel paint on kerb tone over a coat of primer including preparation of kerb stone surfaces exc 10 cm width or girth, complete all as specified and directed.

Dismantling Stone slabs and tiles of any description or thickness in floors, aprons etc. complete all as specified and directed.

M&L for 18mm thick granite slab of any colour and shade (table rubbed and polished) including pointing in white cement (1:2) using marble dust, of superior quality set and jointed with grey cement slurry and pointed with white cement with admixture of pigment to match the shade of granite stone over and including 15 mm thick screed bed in cement mortar 1:4, cutting the edges in bullnosed shaped and polishing complete all as specified and as directed.

M&L for Providing precast cement concrete type B1 1:2:4 (20mm graded agg) in window or door cills, lintels, bressumers, steps, quoin blocks (for use with ma?sonry), string courses, copings. kneelers, apex stones, pier caps, columns, posts, boundary pillars, bed plates, pintle blocks, ancho-rage blocks, bonders (for stone wallin). corbels, brackets, etc. (of any section indicated), with plain fair faces, including cham?fers, weatherings, throat- ing etc. and setting in mortar 1:4 complete with joints to match complete all as spd and directed.

M&L for Chequered cement concrete tiles 30cm x 30cm x 25mm thk with grey cement and pigment set, jointed and pointed in neat cement slurry as in floors over and including cement screed bedding 15mm thick in cement mortar (1:6) complete all as specified and directed.

M&L for Providing and laying 60mm thick factory made chamfered edge cement concrete Paver Block of M-35 grade with approved colour, design & pattern as in footparth, parks, lawns, drive ways or light traffic parking etc., of required strength, thickness & size/ shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand as specified and directed.

M&L for PCC 1:3:6 type C-2 (using 40mm graded stone aggregate) as in surface channel and drain complete all as specified and directed.

M&L for Extra for Forming fair finished drain or channel 30cm inner girth in cement concrete, using ex-tra cement, incl forms, moulds, mi-tred/ stopped ends etc. complete all as specified and directed.

M&L for Broken Glass coping on top of walls in CM 1:3 as specified and directed.

M&L for Glazed Ceramic Exterior Wall Colour Tiles in Vertical Surface 450x300x7mm thick set and jointed in neat cement slurry with necessary chemical and pointed in white or coloured cement to match over and incl 10 mm thick rendering in CM (1:4), including dismantling old tiles complete all as specified and directed.

M&L for heavy duty parking tiles size 300x300x10mm thick with grey cement and no pigment set, jointed and pointed in neat cement slurry as in floors colour complete including demolition of old unserviceable tiles complete all as specified and directed.

M&L for screed bed or bedding layer of mortar 15mm thick in CM 1:6 for laying floor finishes complete all as specified and directed.

M&L for Extra over rendering or plastering for work in isolated widths or in widths not forming part of general plastering such as in bands, sunk panels, cornices, skirtings, drip moulds and similar work exc 15 cm but n exc 30 cm in width or girth; including cutting to edges, all mitres and stopped ends, etc complete all as specified and directed.

Restraining, resecuring including making good for Galvanised 2 strand, steel barbed wire 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails strain-ing bolts, including, securing or tying at crossings with and provision of galvanised mild steel wire, staples or steel pins, etc. all as specified and directed. (Note: Each line wire to be measured)

Welding / Cuttings out old existings hinges of any type from existings Steel Gate/ Grill and providing/ repair of hinges to fix the old Steel Gate/ Grill and making good complete all as specified and directed.

Lalta Prasad vijay kumar Forwarding Agency (BID ID -3485186)

Baba Siddhnath Construction (BID ID -3480181)