MP FUND 23-24 HIGHMAST LIGHT PERUNDURAI TOWN PANCHAYAT

Amount

Earth work open excavation and depositing on bank with in the initial lead of 10m and a lift of 2m in hard stiff clay, stiff block cotton, hard red earth, shales, murram, gravel, stoney earth and earth mixed with small size boulders etc. complete. Complying with Standard Specifications as per SS 20 B TNDSS No. 23 & 24 V,VI,S2

Plain Cement Concrete 1:4:8 Mix (one part cement, four part sand and Eight part of aggrigate) using 40 mm size ISS HBG metal from approved quarry including cost and conveyance of all materials to site. Loading and unloading charges and labour charges for mixing. Laying and curing etc. complete. Complying with Standard Specifications as per TNDSS No. 28 V, VI (S2) (S5A) VII

Supplying and errecting centering to sides and soffits including supports and strutting for drainage sides and culvert body wall sides using M.S Sheets of size 90cm x 60cm and B.G 10stifened with welded mild steel angles of size 25mm x 25mm x 3mm for boarding laid over( silver oak joists ) of size 10cm x 6.50cm spread at about 90cm including all labour charges and cost and conveyance of all materials to site etc. complete Complying with Standard Specification as per TNDSS No.90(S3),86,86A,V,VI,(S3),VII (For Drain,Deck slab & Retainingwall)

Supply and fabrication and placing in position of TMT steel rods to required size and length as directed by the departmental officers including cost of binding wire, cutting, bending and tying with proper position etc., including cost and conveyance of all materials to site and all labour charges etc., complete Complying with Standard Specification as per TNDSS No.S5,86 & 86A,V,VI,(S3),(S6),VII

Reinforced Cement Concrete 1:1½:3 Mix (One part cement, one and half part sand and three part of aggrigate)using 20mm size ISS HBG metal machine crushed from approved quarry including cost and conveyance of all materials to site, loading and unloading charges and labour charges for mixing, laying and curing but excluding cost of reinforcement etc..,Complete Complying with Standard Specifications as per TNDSS No.30 V,VI (S5) VII & I3

Supply and Erection of 12 M high mast system with 6 Nos of 150 W LED lights and fitting with higher end with its accessories, Mast shaft shall be in one section, hot dip galvanized and suitable for wind velocity as per IS 875. It shall also include accessories for high mast including head frame, Galvanized lantern carriage suitable for 6 luminaries summetrically and lighting. The mast shall have an integral power tool installed inside with raising cum lowering system comprising head frame, luminaries carriage suitable to install 6 nos., double drum winches, control gearbox, steel wire rope, trailing cable, conductor, integral power tool motor, manual handle, junction box lightening arrester including earthpit with coal and salt filling etc. complete and the base compartment for its operation, inclusive of foundation bolts. nuts. anchor plates and templates.

Earthing as per PWD standard with an earth electrode of 2 metre Class 'B' GI pipe of dia not less than 32mm complete with necessary masonry work SD 234

GSC TECHNOLOGY AND SERVICES