REPAIR/CLEANING OF SEWAGE LINES, MANHOLES, SEPTIC TANKS, SOAK WELL AND REPAIR, REPLACEMENT OF GATE, REPAIR TO COMPOUND WALL, PATH, DRAIN, FENCING, CULVERT, GARBAGE BINS, SHEDS AND OTHER MISC WORK IN OTM AND MD ACCN ZONE - V AREA UNDER AGE B/R IV OF G

Amount

Material and labour for cleaning of sewage lines,manhole by rodding and well flushing the sewage lines after removing of sludge including taking off the manhole cover and refixing after cleaning of manhole of any size and depth. The manhole lines to be cleaned manually /mechanical sludge trailor and all sludge to be removed to a distance with in of 3 km outside of the cantt area.( Note. ( a ) The contractor shall provide sufficient labours everyday to cater for all type of complaints.(b) the period of complection for each complaints shall be 24 hourse .(c) it will be the responsibility of the contractor to get the complaints completed with in stipulated period the labour shall be made to available during the office hours for any complants.(d) The payment shall be made contractor on the basis of complaints slips.No payment shall be done for any incomplete work .(e) The contractor to quote the rates accrodingly.

All as per item No 1.00 above but cleaning the blockage of WC's, toilets, kitchen, Sink complete all as specified and directed.

Cleaning of sewage lines 150mm bore including man holes gully trap, grees trap etc up to 1.50m deep by removing all silt, foreign material and other deposits what so ever completely and making the lines free from all obsticles and testing the flow of sewwr line evenly, smoothly by filling water the operator will carried out in suitable length by blocking the first and last man hole of path and removing the silts/edge out of defence land all as specified and dircted.

Dewatering of soak well/pit/septic tank any size/capacity by discharging the sewage water into a sealed tanker with hanze pipe system including vehicle, complaint and disposing within 3KM outside cantt area all as directed by the Engr-in-Charge.

Excavation and getting out of sludge from septic tank and soak well in any depth by any means and removing to the distance up to 3 kms out side cantt area and deposited in approved lying areas all as directed by Engr-in-Charge.

Excavation in trenches not exceeding 1.5 m wide and not exceeding 1.5 m depth for foundation manholes etc and getting out in loose/soft soil complete all as specifeid and directed.

Exavation in trenches n.exc 1.5 m wide, beyond 1.5m and n.exc 3.0 m in depth and getting out in soft/loose soil, to facilitiate the demolition of drain pipe complete all as specified.and directed.

Material and labour for broken stone or boulders as in hardcore of guage n. exc. 63 mm, deposited, spread and levelled in layers n. exc. 15 cm thick, watered and rammed to a true surface.

Material and labour PCC in foundations, filling and mass-concrete type D2 (1:4:8) using 40 mm graded stone aggregate complete all as specified and directed.

Material and labour PCC in foundations, filling and mass-concrete type B2 (1:2:4) using 40 mm graded stone aggregate complete all as specified and directed.

Material and labour for Plain Cement concrete 1:3:6 type C-1 (20mm gardded aggregate) as in surface channel and drains complete all as specified and directed.

Material and labour for Extra for forming fair finished drain or channel 45 cm inner girth in cement concrete using extra cement, including forms,moulds, mitred/stopped ends etc complete all as specified and directed.

Demolition brick work built in cement mortar including all quoins arches pillars etc complete all as specified and directed.

Material and labour for brick work with fly ash bricks of straight or curved on plan exc 6 metre mean radius built in cement mortar 1:4 complete all as specified & directed.

All as per item No 14.00 above but except bricks complete all as specified and directed.

Material and labour Providing cement concrete 1:2:4 Type B1 (20mm gr agg) plain cement concrete in Coping to concrete block/brick masonry and for filling in road cutting and like etc complete all as specified and directed.

Material and labour for rendering CM (1:4) 15 mm thick on fair faces of brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed.

Material and labour for preparation of newly plastered surface of wall etc and applying two coats of Cement base paint over a coat of alkali resistence primer in any colour complete all as specified and directed.

Returning, filling in, including spreading, levelling, watering and well ramming in layers complete all as specified and directed.

Removing excavated soil materials n.exc 50m and depositing where directed at a level complete all as specified and directed.

Material and labour for PCC 1:3:6 type C2, using 40 mm grade aggregate as in bed to drain pipes of 150 mm bore, inlcuding packing under and haunching against sides of pipes after they are laid and tested, complete all as specified and directed.

Material and labour for Salt glazed stone wire drain pipes 150mm laid in trenches and jointed complete all as specified and directed.

Material and labour PCC 1:3:6 type C-1 (20mm gardded aggregate) as in surface channel, drains complete all as specified and directed.

Material and labour for extra for forming fair finished drain or channle 30cm inner girth in cement concrete, using extra cement, incl forms, moulds, mitred / stopped ends etc complete all as specified and directed.

Demolition cement concrete/Reinforced cement concrete in ground floor and paving not exceeding 15 cm thickness (below of above ground level) un-reinforced as in PCC benching PCC bed etc complete all as specified and directed.

Material and labour for precast cement conc 1:2:4 type B-1 (20mm graded agg) as in manhole/drain covers slabs set in cement mortar 1:4 including necessary form work, Demolition PCC and placing to desired distance complete all as directed by Engr-in-Charge.

Material and labour TMT bars 10mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Material and labour RCC type B-1 1:2:4 using 20 mm graded agg as in slabs supported on walls as in soak well/septic tank etc complete ( cost in situ) including form work and demolition of RCC as per requirement complete all as specified and directed.

Material and labour PCC 1:4:8 type D2, 75 mm thick (using 40 mm graded stone aggregate) as in as in sub base of flooring complete all as specified. including demolotion of old PCC complete all as specified and directed .

Material and labour Chequered cement concrete tiles 30cm x 30cm x 25mm thick, set, jointed and pointed in neat cement slurry in floors With Grey Cement and pigment laid over including 15mm thick screed bed in CM 1:6 complete all as specified and directed.

Material and labour for rubber moulded precast conctete interlocking paver block any shape and size confirming to IS 15658-2006 of 60 mm thickness, M-35 Grade with using grey cement & pigment laid over and inluding 25mm thick coarse sand laid over sub base complete all as specified and directed. Make: Tulip/Mehtab/Jain tiles or equivalent make as specified in PS.

Material & labour for 40mm thick cement concrete 1:2:4 type B-1 (using 20mm graded stone aggregate) as in flooring, surface finished even and smooth by using extra cement including demolotion of old PCC if required complete all as specified and directed .

Supply only 3mm thick and 38 mm wide glass strips as in floor complete all as specified and directed .

Demolition and breaking of drain pipes of 110/75mm size etc complete all as specified & directed.

Supply and fix PVC Pipes single socketed in any length with rubber ring joints, fixed to walls, laid under floors etc. 110 mm bore as in waste and rain water pipes complete all as specified & directed.

Supply and fix PVC bends 110 mm bore, any radius complete all as specified & directed.

S&F PVC (SWR),110mm junction single, (Single T) equal or unequal

S&F as in repair vitreous china squatting pan Orissa pattern, size 580 x 440mm, white, with integral footrest, including flushing cistern & flush pipe fixed as in repair with ‘P’ or ‘S’ trap, including making good the disturbed surfaces and to match with existing surface.

S&F as in repair vitreous china wash down water closet pan (pedestal pattern), white (flushing cistern and flush pipe) fixed with ‘P’ or ‘S’ trap, including making good the disturbed surfaces and to match with existing surface complete all as specified and directed.

Supply & fix in repair white plastic seat cover for W.C.(E.T.) white including M.S. CP or aluminium hinging device complete all as specified and directed.

Dismantling of AC/Fibre corrugated sheet any description as in roof covering incl ridge and removing from site complete all as specified and directed.

Material and labour 6mm thick fiber cement, corrugated or semi-corrugated shets in roofs, walls, etc. Fixed with L-type or J-type or cranked hook bolts complete all as specified & directed.

Material and labour fibre cement two piece adjustable serrated ridge, 6mm thick fixed with L-type or J-type or cranked hook bolts complete all as specified & directed.

S&F pre-painted galvalume aluminium zinc coating GI based corrugated steel sheet 0.50mm thick of a colour having tensile strength of 550 Mpa as in roof covering, Note Bldg height upto 12 mtr complete all as specified and directed by Engr-in-charge.

S&F for pre painted plain galvanise steel sheet of 0.50mm, MS sheeting as in ridge on roof covering valley gutters, drips and straight flashings ( length & girth as fixed) with grade of zinc coating 275 complete all as specified.

S&F for roof trusses (framed), trusses purlins, crane gantries, rail and fastneing and heavey bracket framing (beam,tee,angle,channel of flate sections) including distance piece including butt weldeding conforming Fe-410-W (gde-E250 Quality A) complete all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

Dismantling wrought iron or mild steel work of any description not otherwise provided for complete all as specified and directed.

Dismantling chain link fencing wiremess of any type complete all as specified and directed.

Dismantling posts and struts (wood, steel or RCC) any section, including taking out embeded portion and making good disturb ground complete all as specified and directed.

Material and labour for precast RCC 1:2:4 type B1 (using 20mm graded aggregate) as in fencing post incl necessary form work complete all as specified and directed.

S&F Mild steel angle iron post as in fencing posts, cut to length, drilling holes, welding and embedded in concrete complete, including preparation of new or previously untreated steel & iron surfaces of any description, not otherwise described over 10 cm width or girth and apply two coat of synthetic enamel paint over over a coat of red oxide primer complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type of standards, rails, straining bolts, etc. incl provision of binding wire complete all as specified and directed.

Supply only chain link fencing of 3.10 mm dia wire made upto into matresses complete all as specified and directed.

S&F 40x5 mm thick flat iron as in fastening of chain link fencing fixed to nuts and bolts including holes complete all as specified and directed.

S&F mild steel screw, nut & bolts including washers (machine made) with hexagonal or square heads at one end and screwed complete all as specified and directed.

S&F Mild Steel flat, round or square bar for straining, in available length, cut to length, bent to shape requqired Fe-410W (Gde E-250) quality 'A' complete all as specified and directed.

S&F galvanised 2 strand steel barbed wire 2.24 mm dia barbed with 2 mm dia bars at 75 mm spacing complete all as specified.

vibha associates

Shikha Enterprises