Construction of additional Floor for UPHC at Pillaiyar Koil Street in Division-103, Unit-22, Zone-08 (UNDER MLA FUND).

Fabricating Supplying and fixing in position of Al... anodic film thickness of 15 microns etc.Complete.

Roofing with Galvanised corrugated iron sheet of thickness 0.8mm

MS ANGLES - 11/2” x 11/2” x 1/4” (37.5 x 37.5 x 6.24mm) (1M = 3.25 kg)

Iron works for trusess and record racks (labour only)

Supplying, fabricating and placing in position Rib...t and binding wire) Above plinth / Basement level

Supplying and erecting steel centering including n...l be given after the concrete is laid). FOUNDATION

Supplying and erecting centering for plane surface...g shall be given after the concrete is laid). SLAB

Providing and laying in position, standardised con...the Department for the excess usage of materials).

Brick work in following Cement Mortar using best q...Executive Engineer in charge. In Cement Morter 1:5

Paving the floor with fine polished cuddapah stone...se on work) - Cuddapah Slab of 38 to 40mm thick

Plastering the surface of walls with Cement Mortar...d as directed by the departmental officers. (Wall)

Painting New Plastered Wall Surface with Two finis...ed by the Executive Engineer before use on works.)

Paving the floor with best quality vitrified Til...pproved by Executive Engineer before use on works)

Supplying and fixing Mild Steel grills for windows...ions and as directed by the departmental officers.

Painting new iron works such as steel doors...ed by the Executive Engineer before use on works.)

Supplying, laying and jointing UPVC pipes of Class...ve ground level. For laying UPVC pipes of dia 25mm

Supplying and fixing in position best quality and ...s).White Glazed Wash Hand Basin - without pedestal

AC Ceiling Fan complete 1200 mm (48”) Sweep with 300mm Down Rod (without Regulator)

20W LED Tube Light for T8 Fitting (Single Side)

PLUG AND SOCKETS IN SHEET STEE...CLOSURE WITHOUT MCBs - LOWER END - 32A Triple Pole

Wiring with 2 x 1.5 sq.mm. PVC insulated SC unshe...light point / fan point (for electronic regulator)

Supplying and fixing in position best approved of ...tmental officers 110mm dia PVC Pipe for Two Floors

Supply and installation of two-track sliding ...mplete and as directed by the department officers.

Supplying and fixing in positon Indian Water Close...ed by the Executive Engineer before use on works).

PVC Screw Down Tap Heavy Type 20mm dia

Dismantling - Pressed Tiles & Weathering Course

Acrylic anti-carbonation coati...on as per the direction of the Engineer In charge.

Paving the Top of roof with Solar refelective cera...ved by the Executive Engineer before use on works)

Pointing with Cement Mortar 1:3 to Full Depth of ...plete complying as per the standard specifications

Painting Old Plastered Wall Surface with Two finis...ed by the Executive Engineer before use on works.)

Supplying and fixing in position best quality PVC ...ines are proposed to laid below ground level 110mm

Manufacturing, Supplying and Fixing of Stainless S...onveyance, electrical charges, etc. complete

Supplying and fixing in position White / Colour Sp...flush fittings with normal seat cover Wall Fitting

Stainless Steel Health Faucet

Supplying, laying and jointing PVC pipes (having w...ove ground level. For laying PVC pipes of dia 20mm

Supplying and fixing in position 15mm dia b...utive Engineer before use on the works) Pillar Tap

Manufacturing, supplying and fixing of Entrance st...tal officers. - Single leaf of size 1.00m x 2.40m.

LIFT CHARGES Concrete - Above Ground Level - Add ...upper floor over the rate of preceeding floor

Labour charges for fixing aluminium doors, windows and ventilators

Providing And Erecting Direction And Palce Identif... Irc 67:2012 (As Per Mort &H Specification No.801)

Supplying and fabricating of stainless steel pipe ...ges including polishing and generator charges etc.

Drilling of borewell anywhere in Chennai including...lot Bore upto 60 m depth ending below ground level

Charges for developing the Borewell with air compr...e Borewell with air compressor of 600 CFM capacity

Special Blue Pipes for Bore Well 125mm dia

Special Blue Slotted Pipes for Bore Wells 125mm dia

End Cap for Bore Well End Cap for Bore Well 125mm dia

HDPE PIPES FOR SUB-MERSIBLE PUMP IN BORE WELL Class-5 (1 MPa or 10 kg./cm2 pressure) 50mm dia

2.0 HP Submersible Pump

3 Phase Panel Board including labour charges

Construction of INSPECTION CHAMBER following ...per standard specification. CLEAR SIZE 0.90 X 0.90

Tamil Stainless Steel Letters 25cm (10”)

Supplying and fixing in position best approved of ...rtmental officers 110mm dia PVC Pipe for One Floor

Fixing in position mild steel grills for windows, ventila- tors, etc.

Paving the floor with pre-polished concrete anti-...pproved by Executive Engineer before use on works)

(As per Sch.no BD-883, 2024-25) Providing two legged scaffolding using 15cm dia casuarinas post of 4 M over all length (3 M Height + 0.5 M Projection + 0.5 M into the Ground) the distance between the two rows being 1.25 M and the spacing of posts being 2.0 M in both the rows with two horizontal posts with 0.5 M. Overlap on either side and braces at 2.0 M center to center including longitudinal and transverse middle braces to step up and providing a platform with country wood planks of 40mm thick and 1.M width, etc. in a complete from using coil and nails.(Rate for an initial height of 3 M and length of 1 M)

(As per Sch.no BD-884, 2024-25) Scaffolding charges for every additional height of 2.5 M height over the initial height of 3 M.

Providing fixing Solar Pannels

Please Enable Macros to View BoQ information