NIT Item no. 01

Construction of granular sub-base by providing …………... and compacting with smooth wheel roller …...complete as per Technical Specificationin clause 401 .

Cement Concrete with 2 cm gauge brick ballast, fine sand & cement proportion of 1:4:8 complete work as per S.i no. 281

M-150 class Bricks work of mix 1:4 cementand coarse sand in foundation i/c supply of all materials,labour, T & P etc.

12mm thick cement plaster with cement & coarse sand of mix 1:4 complete.

C.C 1:2:4 with cement, C.sand and stone grit complete asper S.I. No. 279(a).

Construction of un-reinforced, dowl jointed at expansion and construction joint only, plain cement concrete pavement, thickness as per design, over a prepared sub base, with 43 grade cement or any other type as per Clause 1501.2.2 M 30(Grade), coarse and fine aggregates conforming to IS:383, maximum size of coarse aggregate not exceeding 25 mm, mixed in a concrete mixer of not less than 0.2 cum capacity and appropriate weigh batcher using approved mix design, laid in approved fixed side formwork (steel channel, laying and fixing of 125 micron thick polythene film, wedges, steel plates including levelling the formwork as per drawing), spreading the concrete with shovels, rakes, compacted using needle, screed and plate vibrators and finished in continuous operation including provision of contraction and expansion, construction joints, applying debonding strips, primer, sealant, dowel bars near approaches to bridge/culvert and construction joints, admixtures as approved, curing of concrete slabs for 14-days,using curing compound (where specified) and water finishing to lines and grade as per drawing and finished with Power Trowel Cum Floter-Trimix Flooring Machine. Technical Specification Clause 1501 S.I No.20.12 b

Supply and laying 80mm thick cement inter locking tiles with 4cm. Cushin fine sand layer all material, labour and T&P etc. comp. work.

Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete DSR 10.2