Nit 06/SE/2025-26 Lot-09

Amount

Granular Sub-base (GSB) with Well Graded Material (Table 400.1)(A) By Mix in Place,Construction of granular sub-base providing well graded material, spreading in uniform layers with motor grader on prepared surface mixing by mix in place mathod with rotavator at OMC and comacting with smooth whell roller to achive the desired density complete as per technical specification clause 401

WBM Grading 2-Providing, laying spreading and compaction stone aggregates of 45-63 mm specific sizes to water bound macadam specification including spreading in uniform thickness, hand packing, rolling with smooth wheel roller 80-100 KN in stages to proper grade and camber, applying and brooming stone sceeing/binding materials to fill up the interstices of coarse aggregate, watering and compacting to the required density Grading-2 as per technical specification clause 405

WBM Grading 3 Providing, laying, spreading compacting stone aggregate of specific size (22.4mm to 53mm) (W.B.M.-G-III) in base coat towater bound macadam specification including spreading in uniform thickness (compacted 75mm, loose 100mm) hand packing, rolling with three wheel 80-100 KN static roller in stages to proper grade and camber, applying and brooming stone screening/ binding materials to fill up the interstices of course aggregate watering and compacting to required density including cost of all material, labour, T&P etc.

Brick edging on both side of road with first class Bricks 8cm wide ,12cm deep laid with mud mortar including cost of all material, labour ,T& P etc. (Per Km.)

Providing & applying primer coat with Bitumen Emulsion(SS) on prepared surface of granular base including cleaning of road surface and spraying primer at the rate of 0.75 kg/sqm using mechanical means.

Providing & applying Tack coat with Bitumen VG-10 using bitumen presser distributor at the rate of 0.35 kg/sqm on the prepared bituminous/granuiar surface cleaned with mechanical broom.

Providing, laying and rolling of open - graded premix surfacing of 20 mm thickness composed of 13.2 mm and 5.6 mm aggregates using viscosity grade bitumen to required line, grade and level to serve as wearing course on a previously prepared base, including mixing in a suitable hot mix plant of appropriate capacity not less then 200 tonne per hour laying and rolling with a smooth wheeled roller finished to required level and grades

Providing and laying premix seal coat with HMP of appropriate capacity not less than 200 tonnes/hours using crushed stone chipping 6.70 mm size and penetration bitumen of suitable grade .

M/S AMBUJ CONSTRUCTION (BID ID -5575670)

M/S SANDEEP TIWARI (BID ID -5578183)

MS VIJAY KUMAR SINGH (BID ID -5577774)

VISHNU SINGH (BID ID -5576384)

RAJENDRA KUSHWAHA (BID ID -5577893)

SHAILENDRA KUMAR MISHRA (BID ID -5576691)

SANTOSH KUMAR (BID ID -5576717)

M/S NAVEEN KUMAR YADAV (BID ID -5576502)