Improvement works to Sri Ram Colony, Edayarpalayam Kuniyamuthur Urban Public Health Center in ward No.93, South Zone

Amount

Supplying and fixing UPVC (Un-Plasticized Polyvinyl Chloride) Windows of casement type (open) from the profile the size of outer frame 60mm x 58mm and shutter profile are inforcement with GI/1mm 125GSM and 100% corrosion free, the profiles are multi chambered sections with wall thick of 2mm. The EPDM rubber (black colour) covered with over all the edges of frame and shutter the shutter will be provided with Espag multi power point locks and also it operates as handle.

S/F OF CUDAPPA SLAB of approved quality and colour of size all floors over 40mm thick cement mortar 1:3 (One cement and three sand) base above the existing bed concrete and pointed with same color cement added.

Flooring with Stain free Nano polish Vetrified flooring tiles of size 600 x 600 x 8mm of approved colour and quality of required size laid in cement mortar 1:3 mix 20mm thick and pointing with the same mortar complete and finish very neatly etc complete

Flooring with Ellis pattern using 6mm chips (No sand to be used)

Finishing the top of roof with one course of PRESSED TILES of size 23 cm X 23 cm of approved quality laid in cement mortar 1:3 (One cement and three sand) 12mm thick mixed with water proofing compound conforming to I.S. at 2% by weight of cement used and the top pointed with same mortar mixed with red oxide to the full depth of tiles, complete complying with standard specification and as directed by the departmental officers.

Manufacturing, Supplying and Fixing of Stainless Steel Hand rails for staircase near wet riser using 50mm dia 304L Grade Stainless Steel pipe of 1.60mm thick will be provided with tubular supports made of 304L Grade Stainless Steel pipe of 25mm dia of 1.60mm thick welded to the railing. The supports will be grouted into the wall and provided with 93.00mm thick Stainless Steel circular base plate of 304Grade. The rate shall included for grouting into concrete with necessary supporting arrangements the hand rail in floor polishing buffing, bonding, cutting, grinding, conveyance, welding charges, electrical charges, etc. complete

Roofing with Pre painted Galavalume sheet 0.47mm thick with necessary bolt and nuts and washers including allmaterials and labour charges etc complete - 10m2

Supply of PVC Water Tank including cost and conveyance of complete complying with standard specifications and drawings and as directed by the departmental Engineers

Painting two coats with ready mixed plastic emulsion paint of 1st class quality and of approved color over a priming coat including through scraping clean removal of dirt etc., complete and including necessary plaster of paris putty wherever required - 1 m2

Painting with enamel paint two coats over a base coat of approved colour etc complete - For Iron works

Supplying, fabricating and fixing in position of Alumi.Anod.natural colour matt finish door half glazed and half PLB board using 12 mm thick PLB board and 5.5 mm thick glazed door using rectangular Alu.Box section of following sizes for frame and shutter with necessary accessories such as rubber beading, Al. Clips, Best double action floor springs, Aluminium Handles on both sides,floor stopper,Tower bolt, Locks and glass including all materials, Labour, power consemption charges required for fabrication if necessary chipping, dismantling making necessary holes in RCC Coloums, Beams or Masonry wherever necessary with power drill to the extent required and made good to the original conditions after fixing etc.,complete. The Alumi. surface must be anodised with matt finish under electrically controlled condition in accordance with IS specification 1868 / 1962 of Anodic filthickness of not less than 15 Microns (Fifteen) for all sections.All the materials should be got approved by the Engineer - In -charge before fixing as directed.

Supplying and fixing of 1200mm(48")sweep AC ceiling fan complete with stepped electronic 300W Regulator with 1 metre down rod with fan clamp with side plates and crpss arm of size 450mm(18") SD106

Earth work excavation in all soils and sub-soils and the full depth as may be directed by the departmental officers with initial lead and lift and cleaning and levelling the site etc., complete complying with standard specification

Brick work in cement mortar 1:5 mix using Fly Ash bricks of 230x110x70mm (8 3 /4" x 41 /4" x 2 3 /4") including cost of materials and labour charges etc., as per standard specification - 1m3

Random rubble masonry in cement mortar 1:5 mix with using old blue granite rough stones for foundation and basement 10 m3 (Old stone supplied by department)

Plastering with CM 1:5 (One cement and five sand) mix 12 mm thick including finishing cost and conveyance of all materials to work site and all labour charges watering, curing and and all other incidental charges etc., complete complying with standard specifications.

Supplying and erecting CENTERING AND SHUTTERING with necessary supports for plane surfaces such as RCC SLABS,LINTEL SUNSHADES, etc., with all cross bracings using mild steel sheets etc., complete.

Supplying, fabrication and placing in position of steel reinforcement using mild steel of Ribbed tor steel rods, for all RCC works as per the design given by the departmental officers including cost of steel and binding wore and all labour charges for cutting, bending & tying etc., complying with standard specifications - 1 Quintal

Reinforced Cement concrete 1:1.5 :3 (one cement, one & half M.sand and three course aggregate) using 20mm gauge hand broken/ and broken granite stone for all RCC items of works excluding centering shuttering and cost of reinforcement but including curing etc.,complete and also including fixing fan clamps and fixtures in rcc works wherever necessary as directed by departmental officer etc., complete.

Provision for plumping including materials and labour cost etc., complete

Provision for name board hand written including materials and labour cost etc.,

JAYALAKSHMI BUKDERS (BID ID -1357241)