Making of foundation for various electrical equipment/transformers and replacement of damaged fencing/boundary around different sub-station installed at Saoner Sub Area of Nagpur Area.

Surafce dressing of the ground including removing vegetation and in- equalities not exceeding 15 cm deep and disposal of rubbish, lead up to 50 m and lift up to 1.5 m.All kinds of soil

Earth work in surface excavation not exceeding 30 cm in depth but exceeding 1.5 m in width as well as 10 sqm on plan including getting out and disposal of excavated earth upto 50 m and lift upto 1.5 m, as directed by Engineer-in- Charge:All kinds of soil

Supplying, spreading & compacting of Agggates size 63mm to 45 mm & 45 to 22.5 mm in two layers as per direction of Eng-In-Chrage.

Repairs to plaster of thickness 12 mm to 20 mm in patchesof area 2.5 sq.meters and under, including cutting thepatch in proper shape, raking out joints and preparing andplastering the surface of the walls complete, includingdisposal of rubbish to the dumping ground, all complete asper direction of Engineer-in-Charge.With cement mortar 1:4 (1 cement : 4 fine sand)

Finishing walls with Premium Acrylic Smooth exterior paint with Silicone additives of required shadeOld work (Two or more coats applied @ 1.43 ltr/ 10 sqm) over existing cement paint surface

Structural steel work in single section, fixed with or without connecting plate, including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer all complete.

Providing and fixing precoated galvanised iron profile sheets (size, shape and pitch of corrugation as approved by Engineer-in-Charge) of total coated thickness 0.50mm (base metal of minimum 0.45mm thickness with total coating thickness of 0.05mm) with zinc coating 120 grams per sqm as per IS: 277, in 240 mpa steel grade, 5-7 microns epoxy primer on both side of the sheet and polyester top coat 15-18 microns. Sheet should have protective guard film of 25 microns minimum to avoid scratches during transportation and should be supplied in single length upto 12 metre or as desired by Engineer-in- charge. The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required.

Earth work in excavation by mechanical means (Hydraulic excavator)/manual means over areas (exceeding 30 cm in depth, 1.5 m in width as well as 10 sqm on plan) including getting out and disposal of excavated earth lead upto 50 m and for all lift, as directed by Engineer-in-charge.All kinds of soil

Supplying and filling in plinth with sand under floors, including watering, ramming, consolidating and dressing complete.

Providing and laying in position cement concrete ofspecified grade excluding the cost of centering andshuttering - All work up to plinth level : 1:4:8 (1 Cement : 4 coarse sand(zone-III) derived fromnatural sources : 8 graded stone aggregate 40 mm nominalsize derived from natural sources)