Upgradation /Renovation of ADM Block with Providing and laying Structural steel work and Roof sheets on open area of ADM Block at 31st Bn ITBP, YUPIA (Arunachal Pradesh).

Steel work in built up tubular (round, square or rectangular hollow tubes etc.) trusses etc., including cutting, hoisting, fixing in position and applying a priming coat of approved steel primer, including welding and bolted with special shaped washers etc. complete.

Providing and laying in position specified grade of reinforced cement concrete, excluding the cost of centering, shuttering, finishing and reinforcement - All work up to plinth level :1:1.5:3 (1 cement : 1.5 coarse sand (zone-III) derived from natural sources : 3 graded stone aggregate 20 mm nominal size derived from natural sources)

Providing, laying and jointing glazed stoneware pipes class SP-1 with stiff mixture of cement mortar in the proportion of 1:1 (1 cement : 1 fine sand) including testing of joints etc. complete :200 mm diameter

Wiring for circuit/ submain wiring alongwith earth wire with the following sizes of FRLS PVC insulated copper conductor, single core cable in surface/ recessed steel conduit as required.2 X 2.5 sq. mm + 1 X 2.5 sq. mm earth wire

Providing and fixing polycarbonat sheet (size, shape and Colour as approved by Engineer-in-charge) 10 mm thickness and 04 layers with Aluminium frame structure supplied in single length upto 12 metre or as desired by Engineer-in-charge.The sheet shall be fixed using self drilling /self tapping screws of size (5.5x 55 mm) with EPDM seal, complete upto any pitch in horizontal/ vertical or curved surfaces, excluding the cost of purlins, rafters and trusses and including cutting to size and shape wherever required

Suppying of No-power Roof Turbine Ventilator Exhaust Fan 600 mm Outer to Outer ,as required.

Supplying and fixing 200 wt LED Flood lightmake etc as required.

Preparation and submiting detail architectural and enginering design and drawings (Plan,elevations , side elevations ,section elevation) of RCC Retaining wall ,The contractor will liaiseand co-ordinate with IIT/NIT and he is responsible for vetting these design and drawing with IIT/NIT or any goverment institute . The contractor is responsible to pay all fess to IIT/NIT or any Govt institute for vetting these design , no additional payement will make to contractor for this.