Theme based interior of lobby 1 lobby 2 and mezzanine finishing work of Multipurpose Auditorium building in PU South Campus Sector 25 Chandigarh

Providing and fixing WPC flueted panel with L corner wherever required complete in all respect over existing base. (NS)

Providing and fixing 19mm thick Premium quality Commercial Ply to be fixed over existing frame with the help of screws in any height including lead and lift complete in all respect and to the entire satisfaction of Engineer-in-charge. (Make:- Greenply,Duro, Century, Archidply). (NS)

Providing and fixing 1mm thick Laminate to be fixed over existing ply with the help of adhesive and nails complete in all respect and to the entire satisfaction of Engineer-in-charge. (Make:- Greenply, Century, Archidply, Duro). (NS)

Providing and fixing 4mm Veneer to be fixed over existing ply with the help of adhesive and nails complete in all respect and to the entire satisfaction of Engineer-in-charge. (Make:- Greenply, Century, Archidply, Duro). (NS)

Polishing in high gloss/matt finish melamine clear polish on wood work in required color/wooden shade texture with following process in the sequence as detailed below: 1. The surface to be polished is rubbed with sand paper 80/120 no. and then with sand paper of 160/180 nos. 2. Applying two coats of sealer with spray gun and allowing sufficient drying time for 1st coat and 2nd coat is allowed to dry for 8 to 12 hrs. 3. On drying of sealer coat, wet rubbing with emery cloth of finer grading with ample water to remove excess sealer layer and make the surface further smooth after this wet rubbing, then surface is applied with special grade melamine fillers to fill all the small and big holes/ grooves etc. Filler coat to be allowed to dry for 4 to 6 hrs on which again a light wet rubbing is done this surface is further allowed to dry for 12 hrs. 4. On this, 1st coat of melamine polish is applied with spray gun using melamine clear polish and melamine thinner in required proportion. This 1st coat is allowed to dry for 24 hrs then this dry surface is again fine wet rubbed smooth, which is further allowed to dry for 12 hrs. The final melamine polish is applied with compressor pressure spray gun using melamine clear polish and melamine thinner mixed in required proportion complete as per direction of Engineer-in-Charge. (Final coat to be done in 1 or 2 layers without gap of time.) (NS)

Providing and fixing ISI marked 30 mm thick flush door shutters conforming to IS: 2202 (Part-1) non-decorative type, core of block board construction with frame of 1st class hard wood and well matched teak 3 ply veneering with vertical grains or cross bands and face veneers on both faces of shutters. Complete with two S.S handle of 1'6" long. (including ISI marked Stainless Steel butt hinges with necessary screws) (NS)

Providing and fixing 6 mm thick toughned glass for aluminium windows. Ventilators and partition etc for undulatory special Section Aluminium 8"x2-1/2" & 6"x2- 1/2" & 4"x2-1/2" etc. as specifications, drawings and direction of Engineer-in-Charge Complete. ( For External Glazzing as per approved by Architect drawing) complete in all respect and to the entire satisfaction of Engineer-in-charge. (NS)