Repair/maint of external surfaces including grit,rough cast,staircases,saucer drains and misc B/R works under AGE B/R (M) at Faridkot Mil Stn

Amount

M&L for taking down cement plaster on brick or stone walls/ceiling etc including raking out joints, hacking for key, scrubbing down with water etc complete all as specified and directed.

M&L for rendering 15 mm thick in cement mortar 1:4 on brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed .

M&L for preparation of newly plastered surfaces of wall and applying two coat of cement base paint complete all as specified and directed

M&L for preparation of newly plastered or unplastered wall surfaces and applying two coats of white wash complete all as specified and directed .

M & L for washed stone grit plaster on exterior walls in two layers, under layer 12mm cement plaster 1:4 (1 Cement : 4 Coarse Sand) the under layer with scratching tool, applying cement slurry on the under layer @ 3 Kg of cement per square meter, top layer 15mm cement Plaster 1:1/2:2 (1 Cement : 1/2 Coarse sand : 2 Stone chipping 10mm nominal size) in panels with grooves all round as per approved pattern including scrubbing and washing, the top layer with brushes and water to expose the stone chippings complete all as specified and directed. Note : Payment for providing grooves shall be made separately)

M&L for Forming groove of uniform size 15mm wide and 15mm deep in the top layer of washed stone grit plaster as per approved pattern using wooden battens, nailed to the under layer including removal of wooden battens, repair to the edges of panels and finishing the groove complete as per specifications and direction of the Engineer-in-charge

M&L for 5mm thick rough cast plaster over and including 10mm thick rendering in cement mortar 1:4 on fair faces of brick or concrete surface complete all as specified and directed . Note : The rough cast mixture shall consist of crushed stone / fine gravel aggregate, coarse sand & cement in the ratio of 1:1:1 over the rendering coat.

M&L for preparation of newly rough cast plastered surfaces of wall and applying two coat of cement base paint complete all as specified and directed

M&L for rendering 10 mm thick in cement mortar 1:6 on brick work or concrete surfaces finished even and smooth without using extra cement complete all as specified and directed .

M&L for preparation of newly plastered or unplastered surfaces of wall and applying two coat of distemper oil emulsion (white/tinted) after finishing the surfaces with a coat of wall care putty by hand roller complete all as specified and directed .

M&L for complete removal of existing treatment of old decorated surfaces of wall by brooming down and scrapping down smoke soot, moulds, moss and efflorescent salts,treating oil and greasy spots and applying two coats of distemper oil emulsion (white/ tinted) complete all as specified and directed.

M&L for preparation of old decorated surfaces of walls by brooming down and scrapping down smoke soot, moulds, moss and efflorescent salts, treating oil and greasy spots and applying two coats of cement base paint complete all as specified and directed .

M&L for dismantling structural steel work including doors,gates,rungs,framed work etc complete all as specified and directed .

S&F Mild Steel framed work such as grills, gratings etc. with ends of bars shoulderd and/or riveted, or forged into spikes, framed guard bars, barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks,cooler stand,ladder and similar work conforming to Fe290, Gde-E-165 complete all as specified and directed.

M&L for preparation of new or previously untreated steel surface of any description over 10cm width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed

Excavation in trenches in any type of soil not exceeding 1.5m deep and 1.5m wide, for foundation etc or manholes,piers,shafts etc not exceeding 10 Sqm on plan and getting out complete all as specified and directed.

Removing excavated material or surplus soil not exc 50 meter and depositing where directed at a level not exc 1.5 mtr above the starting point complete all as specified and directed .

M&L for cement concrete 1:3:6 type C2 (using 40 mm graded crushed stone aggregate) as in foundation, filling and mass concrete complete all as specified and directed .

M&L for brick work with sub class 'B' bricks using old size bricks, straight or curved on plan to any radius in half brick thick walls, built in cement mortar 1:4 complete all as specified and directed .

M&L for PCC 1:2:4 type B-1 (using 20mm graded crushed stone aggregates) as in coping,bed blocks and similar works including slightly rounded or chamfered angles including necessary formwork complete all as specified and directed.

M&L for Extra for forming fair finished drain or channel 30 cm inner girth in cement concrete, using extra cement, including forms, moulds, mitred/stopped ends etc.complete all as specified and directed.

Demolition of Brickwork or stone/boulder masonry,built in cement mortar including all quoins, arches, pillars etc, but excluding ashlar facings, dressed stonework and precast concrete articles complete all as specified and directed

M&L for brick work with fly ash bricks using old size bricks, straight or curved on plan exceeding 6m mean radius, built in cement mortar 1:6 complete all as specified and directed .

All as per Srl item No. 23 here-in-before but except bricks.

Demolition of concrete (un-reinforced) in ground floors and pavings n exc 15cm thickness (below or above ground level) complete all as specified and directed

M&L for 75 mm thick cement concrete 1:3:6 type C2( using 40mm graded crushed stone aggregates) as in plinth protection/path finishing surfaces even and fair complete all as specified and directed .

S&F in repair anodised aluminium frame ,powder coated of coating not less than 50 micron and of any colour, fixed type for door, window, ventilator or partition counter frame with one of more rebates including joining cleat for fixing etc complete all as specified and directed .

S&F in repair powder coated (thickness of powder coating not less than 50 micron) coloured aluminium door shutters, aluminium section weighing 0.55 Kg/m including necessary joining cleats, glazing clips, rubber neoprene packing, powder coated aluminium snap beading, screws, handles 2 Nos in each door, hinges, complete all as specified and directed .

M&L for 4.8 mm thick frosted glass, ordinary quality and glazing with rubber beading in square n. exc 0.5 sqm in each pane complete all as specified and directed .

S&F in repair aluminium (Die cast) body door closer, hydraulically regulated, designation No. 3, universal type, suitable for door shutters of 851 to 1000mm in width and weight between 61 to 80 kg and fixed complete all as specified and directed .

S&F Brass Mortice lock, vertical type, size 100 mm, 4 levers complete all as specified and directed.

S&F in repair galvanised mild steel wire cloth 0.56 mm nominal dia of wire and average width of aperture 1.18 mm and fixed with tinned tacks or galvanised wire staples complete all as specified and directed .

Dismantling stone slabs of any description or thickness in floors, apron etc laid bedded and pointed in any mortar complete all as specified and directed

M&L for 75mm thick plain cement concrete 1:4:8 type D-2 (using 40mm graded crushed stone aggregates) as in sub base complete all as specified and directed .

M&L for sand filling under floor with washed and screened dry fine river sand including watering, well ramming and consolidation complete all as specified and directed

M&L for Machine pressed Precast cement concrete interlocking coloured paver block with glossy finish with grey cement and pigment any shape and size confirming to IS 15658-2006 of 60 mm thickness M-35 grade complete all as specified and directed .

S&F factory made precast kerb stones in PCC 1:2:4 type B-1(using 20mm graded crushed stone agreegates) including chamfers, weatherings,throatings etc in smooth finish & set in cement mortar 1:4 including necessary excavtion and earth work for embedding kerb stone at a depth as directed and temping around kerb stone and removal of surplus soil to a distance not exceeding 50 m and depositing where directed complete all as specified and directed .

M&L for preparation of new plastered /concrete surface and painting with two coats of synthetic enamel paint (white/golden yellow) over a coat of primer complete all as specified and directed

M&L for plain cement concrete 1:2:4 type B-2 (using 20mm graded crushed stone aggregates) as in surface channel and drains complete all as specified and directed . Note :- A Sum of Rs. 96,900.00 will be deducted on account of credit for dismantling/ demolished/ taking down material. Please refer detail on srl page No. 17 (Schedule of credit) of Tender Documents.

G.S CONSTRUCTION.CO

NEW AMRITSAR CONSTRUCTION COMPANY

BANSAL BUILDERS