1) Upgradation of KMI- Provision of ramps, New Booking office and renovation of existing booking office into waiting room and CI Office, Raising of PF 1& 2 upto 84cm. (This work primarily involves civil work associated with i) Construction of 2.20m wide ramp for PF no. 1 & 2(1:12) at KMI, near New Booking office KMI and towards Durg end. ii) Construction of Divyang parking near New Booking office KMI, iii)Construction of Electrical room of size 16x8m , iv) Conversion of existing booking office and concourse into waiting room with separate toilet facilities for male, female & divyangjan passengers and provision of camp office for sectional CI v) Construction of booking counter of size 16x8m with 16x8m concourse and divyang parking, vi) Raising of platform from medium level to high level platform at KMI station platform no.1 &2 (surfacing and raising work.) 2) Replacement of existing old and damaged misting system at Platform no.1, 2 & 3 of Durg station.

water supply and Pile work

Execution of all works as per CPWD-DSR-2021-Ver-2 connected with above work covered under

S No. Item No Description of Item Unit Qty Rate Amount

17.0 SANITARY INSTALLATIONS

Providing and fixing wash basin with C.I.

brackets, 15 mm C.P. brass pillar taps, 32 mm

17.7 C.P. brass waste of standard pattern, including

painting of fittings and brackets, cutting and

making good the walls wherever require:

17.7.3 White Vitreous China Wash basin size 550x400 Each 11 2040.85 22449.35

mm with a pair of 15 mm C.P. brass pillar taps

17.7.4 White Vitreous China Flat back wash basin size Each 4 1679.6 6718.4

2 550x 400 mm with single 15 mm C.P. brass

18.0 WATER SUPPLY

18.7S C.P.V.C. PIPES

Providing and fixing G.I. Pipes complete with

G.I. fittings and clamps, i/c making good the

18.11 walls etc. concealed pipe, including painting

with anti corrosive bitumastic paint, cutting

chases and making good the wall :

RAIPUR DIVISION-ENGINEERING/SOUTH EAST CENTRAL RLY

Providing and fixing G.I. pipes complete with

18.12 G.I. fittings including trenching and refilling

etc.-External work

18.15S BRASS FITTINGS

Providing and fixing gun metal gate valve with

C.I. wheel of approved quality (screwed end) :

C.I. SLUICE VALVES/ FIRE HYDRANTS &

18.48 Providing and placing on terrace (at all floor Litre 4000 9.7 38800

levels) polyethylene water storage tank, IS :

12701 marked, with cover and suitable locking

arrangement and making necessary holes for

inlet, outlet and overflow pipes but without

fittings and the base support for tank.

20.0 PILE WORK

Boring with hydraulic piling rigs with power

units, providing and installing cast in situ

single under reamed piles of specified

diameter and length below pile cap in M-25

cement concrete, to carry a safe working load

20.3 not less than specified, excluding the cost of

steel reinforcement but including the cost of

boring with bentonite solution and the length

of the pile to be embedded in pile cap etc. all

complete. (Length of pile for payment shall be

measured upto to the bottom of pile cap) :

Extra over single under ream for providing

additional bulbs in under reamed piles, under

specified diameter(only the nos. of extra bulbs

are to be paid)