8504 REPAIRS TO BR SERVICES INCLUDING CEILING, FLOORING AND INTERNAL WATER SUPPLY, WELCOME MAINTENANCE, PERIODICAL SERVICES, PLINTH PROTECTION, DRAIN, PATH, FENCING, GATE ETC IN MD ACCN OF ZONE A AREA OF AGE BR-II UNDER GE (CENTRAL) PUNE

Amount

Demolition of cement concrete in ground floors and paving not exc 15cm (below or above groiund) and removing of debris out side of defence land complete all as directed.

M & L for Cement concrete 1:3:6 , type C-2, using 40mm graded stone aggregates as in foundations, filling and mass concrete complete all as specified and directed.

M & L for rubber moulded glossy chequered cement concrete tiles 30cm x 30cm x 20mm thick set, jointed and pointed in neat cement slurry with grey cement and no pigments as in floors over and including 20mm thick screed bed in cement mortar 1:6 complete all as specified and directed.

M & L for Providing and laying 60mm thick factory made chamfered edge cement concrete paver block of M-35 grade with approved colour,design & pattern as in footparth, parks,lawns, drive ways or light traffic parking etc.,of required strength, thickness & size/shape, made by table vibratory method using PU mould, laid in required colour & pattern over and including 50mm thick compacted bed of fine sand, compacting and proper embedding/ laying of inter locking paver blocks into the sand bedding layer through vibratory compaction by using plate vibrator, filling the joints with sand and cutting of paver blocks as per required size and pattern, finishing and sweeping extra sand complete all as specified and directed.

Dismantling posts or struts (wood, steel or R.C.C) any section including taking out embedded portion in cement concrete and making good disturbed ground complete all as directed.

Dismantling fencing wire mesh, any type and inclusive of removal to store complete all as directed.

M & L for cement concrete 1:4:8 , type D-2, using 40mm graded stone aggregates as in foundation, filling and mass concrete complete all as specified and directed.

S & F mild steel work in Posts and struts in fencing including cutting tops to shape as directed, drilling holes, notching for wire etc flat iron fillets (for securing wire mesh etc) including all necessary drilling, bolting or riveting, etc and similar work conforming to Fe 290-0 Grade E-165 complete all as specified and as directed.

S & F MS flats 40x 5mm)as in bands, straps, supports or stays for securing chain link fencing to angle iron posts and welded to post iduring embedding in PCC complete all as specified and directed.

S & F Mild steel screws bolts (machine made) with hexagonal or square heads at one end and screwed at the other end, each screwed end to be fitted with washers and one hexagonal or square nut, n.exc 5 cm long and diameter of neck 11 to 15mm complete complete all as specified and as directed.

Supply only chain link MS galvanised fencing any size or type of mesh size 50 x 50mm and dia of wire 4mm complete all as specified and directed.

Fixing only chain link, fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc including provision of binding wire complete all as specified and directed.

S & F in repair galvanised 2 strand, steel barbed wir 2.24mm dia barbed with 2mm dia barbs at 75mm spacings and straining and fixing to any type of standard rails straining bolts, including , securing or tying at crossing with and provision of galvanised mild steel wie, staples or steel pins etc complete all as specified and directed. (Note:- each line wire to be measured)

M & L for preparation of new or previously untreated steel or iron surfaces of any description over 10cm in width or girth, not otherwise described and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

M & L for precast cement concrete block masonry exceeding 10cm in width with solid blocks of PCC (1:5:8) grade D-5 and setting in CM 1:6 including dismantling of brick or stone / boulders masonry, built in cement mortar including all quoins, arches, pillars etc. but excluding ashlars facing, dressed stone work and precast concrete articles complete all as specified and directed.

M & L for 15mm thick Rendering in cement mortar 1:4 on fair faces of brick work or cement concrete finishing the surface even and smooth without using extra cement complete all as specified and directed .

M & L cement concrete 1:2:4, B-1 , using 40mm graded stone aggregates as in copings / bearing course over brick / PCC block walls etc and like complete using 40mm graded stone aggregates complete all as specified and directed

M & L for 15mm thick rendering in CM 1:4 on brick or stone masonry surfaces finished the surface even & smoth with sagol finish including taking down old cement plaster including raking out joints, hacking for key, scrubbing down with water complete all as specified and directedcomplete all as specified and directed.

M & L for cement concrete 1:2:4, type B-1 using 20mm graded stone aggregates as in precast cover slabs for manholes cover and similar articles with plain faces etc set in cement mortar 1:4 including use and waste of necessary formwork including demoiltion of old precast cover slab complete all as specified and directed.

M & L Mild steel TMT bars 8mm dia and over, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips complete all as specified and directed.

Dismantling structural steel work in doors, gates but excluding framed truss etc complete all as directed.

S & F portions framed & hung as gates including pintle hinges, stops, hand made sliding door bolts etc with ends of bars shouldered and/or riveted, or forged into spikes; framed guard bars; barred iron doors; ladders; framed balusters; walk ways; railings; framework of water tanks & similar work conforming to Fe 290-0 Gde E-165

Dismantling floor, heath or wall tiling including cement mortar bedding (but not backing) rand rubbish off the premises complete all as directed.

Dismantling of stone slabs and tiles of any description laid in CM as in floors, approns etc complete all as directed.

M & L for 25mm thick cement concrete 1:2:4, type B-1, using 20mm graded stone aggregates as in levelling course in complete all as specified and directed

Material and labour for Non skid coloured ceramic tiles of size 600mm x 600mm x 8 to 9mm thick (Square / rectangular) over & including 15mm thick screed bed in CM 1:6 in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match the tiles complete all as specified and as directed.

All as per item No 26 above but in skirting / vertical surfaces over and including 10mm thick baking coat of CM 1:4 complete all as specified and directed.

Material and labour for Non skid coloured ceramic tiles of size 300mm x 300mm x 7 to 8mm thick (Square / rectangular) over & including 15mm thick screed bed in CM 1:6 in floors etc set and jointed in neat cement slurry and pointed in white or coloured cement to match the tiles complete all as specified and as directed.

M & L for coloured glazed ceramic tiles of size 450 x 300 x 7 to 8mm thick as in vertical surface set and jointed in neat cement slurry and pointed flush in white cement with pigment over and including 10mm thick baking coat of CM 1:4 complete all as specified and directed.

M & L for preparing new plastered surfaces of walls and applying two coats of oil bound distemper over a coat of alkali resistant primer of same make complete all as specified and directed.

M & L for preparing new plastered surface of walls and applying two coats of cement based paint over a coat of cement primer of same make complete all as specified and directed.

Complete removal of existing treatment of walls and applying two coats of oil bound distemper over one coat of alkali resistance primer over & including thin layer coat of wall care putty complete all as specified and as directed.

M & L for preparing old plastered or unplastered surfaces of walls and applying two coats of oil bound distemper complete all as specified and directed.

M & L for preparing old plastered or unplastered surfaces of walls and applying one coat of oil bound distemper complete all as specified and directed.

M & L for preparing old plastered or unplastered surfaces of ceiling and applying one coat of oil bound distemper complete all as specified and directed.

M & L for preparing old plastered or unplastered surface of walls and applying one coat of cement based paint complete all as specified and directed.

S & F in repairs 15mm bore dia bib taps cast copper alloy with crutch or butterfly handle, chromium plated , fancy type screwed down, screwed for iron pipe or for brass ferrule complete all as specified and directed. Make :- Jaquar Cat part No:FLR-5047N or equivalent model in KOHLER and ROCA.

S & F in repairs for 15mm bore dia angle cock copper alloy chromium plated , fancy type screwed down high pressure with crutch or butterfly handle screwed both ends for iron pipe or for union complete all as specified and directed . Make :- Jaquar Cat part No : FLR-5053N or equivalent model in KOHLER and ROCA.

S & F in repair Brass chromium plated wall mixer (2-in-1) for mixing hot & cold water screwed down for iron pipe with provision for both hand shower and overhead shower complete with 115mm long bend pipe, connecting legs & wall flange and fixed complete all as specified and directed. Make :- Jaquar Cat part No : FLR-5281N or equivalent model in KOHLER and ROCA.

S & F in repair 100mm round shape brass chromium plated overhead shower, single flow with rubit cleaining system fitted to steel pipe or union complete all as specified and directed. Make :- Jaquar Cat part No : OHS-1989 or equivalent model in KOHLER and ROCA.

S & F in repair PVC connection 115mm size with PTMT nuts to length 450mm all as specified and directed

Supply and fix in repairs 15mm bore dia pillar taps, cast copper with capstan head, chromium plated, screwed down high pressure with or without lettered 'hot' and 'cold' with long screwed shank and fly nut for iron pipe complete all as specified and directed. Make :- Jaquar Cat part No : FLR-5015 or equivalent model in KOHLER and ROCA.

M & L for GI tubing 15mm bore dia medium grade including all fittings such as bend, elbow, union, tee, short pieces etc fixed to walls, ceilings or laid in floors including taking up or down old tubing any type complete all as specified and as directed.

M & L for GI tubing 20mm bore dia medium grade including all fittings such as bend, elbow, union, tee, short pieces etc fixed to walls, ceilings or laid in floors including taking up or down old tubing any type complete all as specified and as directed.

S & F 1000 litres capacity rotational mouded polyethylene three layer water storage tanks (cylindrical vertical with closed top) hoisted and fixed in position including dismantling of old water tank any type complete all as specified and directed.

S & F in repairs 20mm bore dia ball brass valves, high pressure with polythene float and fly nut complete screwed for iron pipe / PPR pipe or brass ferrule and fixed complete all as specified and directed.

S & F in repair 20mm bore dia Gun metal, globe or gate valves ISI marked, , with iron wheel head, screwed both end for iron pipe and fixed complete all as specified and directed.

M & L for rendering 10mm thick in cement mortar 1:6 on brick / concrete surfaces finished even & smooth with a thin layer of sagol finish in patches work including taking down old cement plaster including taking down old cement plaster including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed.

M & L for rendering 15mm thick in CM 1:4 in two layers (10+5), 5mm thick in CM 1:4 over a coat of 10mm thick in CM 1:4 on brick / concrete surfaces finished the surfaces with sponge finish in patches work including taking down old cement plaster including raking out joints, hacking for key, scrubbing down with water complete all as specified and directed.

Dismantling Wall and ceiling boards (fibre, pulp, insulation etc) or insulation boards / slabs / blankets any thickness including cover fillets.all as directed.

S & F aluminium powder coated snap grid framed work of size 600mm x 600mm for false ceiling and including suspended hangers 4mm dia G.I (upto 1200mm long) adjusting level fixed to roof slabs/purlin/rafter with the help of cleats made out of G.I flat 40 x 3mm of size 60mm long and expansion hold fastener 12.5mm dia 40mm long with including 8mm thick one side prelaminated Gypsum ceiling board of as approved including applying tree coats of white wash complete with following aluminium anodised sections :- (a) Main and cross Tee shall be of size 36.5mm x 23.5mm x 1.5mm thick and 23.5mm x 23.5mm x 1.28mm thick respectively and jointed at junction/crossing with aluminium anodised angle bracket of size 15mm x 15mm x 1.5mm thick weighing 0.12 Kg/RM fixed with suitable M.S bolt, Nuts & washers as per manufaturere's insructions . (b) The snap grid (Main / Cross Tee) section shall be suported at the end along the wall with aluminium anodised angle of size 40mm x 25mm x 2mm thick weighing 0.36 Kg/RM. (c) PVC protcted sheeting shall be used to avoid scraches, damages to frame work while fixing to ceiling.

PRANAV ENTERPRISES

GS Associates

Suma Construction

greenstone construction