Supply of 1100 Litre four wheeled GI Garbage Bin at Different Places in Nagar Palika Deoli for collection of garbage

Amount

TECHNICAL SPECIFICATION OF 1.1 CUM CONTAINER General: Mild Steel structured and Gi sheet rectangular Garbage Container for waste collection should be provided with 4 numbers heavy duty legs. The garbage containers should be of approximately 1100 liters (1.1 cum) capacity. The container construction should be of pressed steel section for ensuring adequate structural strength. The body and bottom of the container shall be fabricated by 2.0mm thick GI sheet and lid by 2.0 mm thick Gl sheet and weight should be 150 kg. TECHNICAL SPECIFICATION 1 internal dimension of the container (Length - 1195mm, width 1000mm and depth-1030mm) , 2. Upper frame angle and lower frame angle for bottom of 50x50x5mm size., 3. Side frame vertical angles (Four nos) of 50X50X5mm size) 4. Outside support on container's both Length side opposite walls of 75 x 5mm Flat., 5 Outside support on container's both width sides opposite walls of 50X50X5mm angle. Two supports in horizontal support shall be for mounting of lifting pin made of 100X50 mm channel and another one made of 50x50x5min angle. , 6. Lifting pins on both width sides of 45mm outer diameter with 4mm thick and 120mm long MS pipe. These pins shall consist of stoppers on their both ends by 65 x65mm or 65mm dia 4mm Thick steel sheet., 7. Lifting pins shall be mounted on upper horizontal side support of 100x50 mm channel. To support these pins, an additional horizontal 100x50 mm flat shall be provided inside the channel., 8. Bottom of the container shall be supported by 2 No. 100x50mm channel in width and cross supported by 2 Nos. 100 50mm channel in width and cross supported by 50x50x5 angle., 9. Twelve holes of 30mm diameter shall be made in the bottom for liquid drain., 10. Containers shall stand over 4 Nos mild steel legs Each leg shall be made of 120mm long,madeof 3" B class Gl pipe These legs shall be capped by 4mm thick mild steel plate and welded with the bottom channel of 100x50mm channel., 11. Lid of the containers should be made in two pieces by 2.0mm thick MS Sheet and supported by at least 3 no hinges m each piece, Lids shall be supported by 25x3 mm angles frame inside or corrugation of sheet. , 12. The entire Gi sheet shall be riveted with the solid rivet of aluminum / Gi nut bolt of suitable size no welding will allow on Gl sheet except hooks and handles., 13. The whole structure of container should be cleaned property prior to coating / painting. The structure of the containers to be coated with two coat anticorrosive red-oxide primer and one coat of silver enamel paint., 14.Container Wait should not less than 150 kg.

NAKODA TRADERS

Choudhary Industries

JSK GROUP