Development of Green Belt and balance Parks in One Room Tenements in the Village Dhanas Chandigarh

Earth work in excavation by mechanical means (Hydraulic excavator) / manual means in foundation trenches or drains (not exceeding 1.5 m in width or 10 sqm on plan), including dressing of sides and ramming of bottoms, for all lift, including getting out the excavated soil and disposal of surplus excavated soil as directed, within a lead of 50 m. All kinds of soil. (DSR 2.8.1)

Providing and laying in position cement concrete of specified grade excluding the cost of centering and shuttering - All work up to plinth level : 1:5:10 (1 cement : 5 coarse sand (zone-Ill) derived from natural sources : 10 graded stone aggregate 40 mm nominal size derived from natural sources) (DSR 4.1.10)

Brick work with common burnt clay F.P.S. (non modular) bricks of class designation 7.5 in foundation and plinth in: Cement mortar 1:4(1 cement :4 coarse sand) (DSR 6.1.1)

15 mm cement plaster on the rugh side of single or half brick wall of mix: 1:4 (1 cement: 4 fine sand) (DSR 13.2.1)

Providing and fixing M.S. Flat iron railing 50mmx12mm (2"x 1-1/2") 4'-0" high (3' above ground level and 1 below ground level) welded with 3 Nos. MS Flat 40mmx10mm (1-1/2"x3/8") horizontally at distance of 6" fro upper and 6" &13-1/2" from bottom and 6mm 1/4") MS square bars at 45 angle at 5" center to center between the horizontal 3 Nos. MS Flat iron. THe rates shall incude the cost of 2 Nos. 12mm dia nut, bolt and 2 Nos. G.I Pipe 19mm dia 3" long sleeves piece, 9" long an charge piece of MS Flats welded at bottom and 50x12mm MS Flats embedded in 9" thick cement concrete 1:2:4 beam above ground level for fixing of MS flat iron railing and painted with two coats complete in all respect as per C.A's drawing and to the entire satisfaction of Engineer-in-charge. NS

62 mm thick cement concrete flooring with concrete hardener topping, under layer 50 mm thick cement concrete 1:2:4 (1 cement : 2 coarse sand : 4 graded stone aggregate 20 mm nominal size) and top layer 12 mm thick cement hardener consisting of mix 1:2 (1 cement hardener mix : 2 graded stone aggregate, 6 mm nominal size) by volume, hardening compound mixed @ 2 litre per 50 kg of cement or as per manufacture's specifications. This includes cost of cement slurry, but excluding the cost of nosing of steps etc. complete. (DSR 11.5)

Providing and filling in position bitumen mix filler of proportion 80 kg. of hot bitumen, 1 kg. of cement and 0.25 cubic metre of coarse sand for expansion joints. (DSR 5.27)

Finishing walls with Acrylic Smooth exterior paint of required shade: New work (Two or more coat applied @ 1.67 ltr/10 sqm over and including priming coat of exterior primer applied @ 0.90 litre/10 sqm) DSR 13.46.1