Necessary works required for proper water distribution arrangement in EE-III area, Alwar NIT15/2020/ITEM03

Amount

Repairing of submersible pump set including Rewinding of motor & repairing pump complete job with all necessary material of the same characterstic as orignal as far as posible with following required sizes . The complete work should be done as per direction & complete satisfication of Engineer incharge. 3 HP

Repairing of submersible pump set including Rewinding of motor & repairing pump complete job with all necessary material of the same characterstic as orignal as far as posible with following required sizes . The complete work should be done as per direction & complete satisfication of Engineer incharge. 5 HP

Repairing of submersible pump set including Rewinding of motor & repairing pump complete job with all necessary material of the same characterstic as orignal as far as posible with following required sizes . The complete work should be done as per direction & complete satisfication of Engineer incharge. 7.5 HP

Repairing of submersible pump set including Rewinding of motor & repairing pump complete job with all necessary material of the same characterstic as orignal as far as posible with following required sizes . The complete work should be done as per direction & complete satisfication of Engineer incharge. 10 HP

Supply & fixing of single phase preventor of approved make like Havells, L & T, Bentax etc. or equivalent.The complete work should be done as per direction & complete satisfication of Engineer incharge.

Supply & providing starter oil (Transformer oil) suitable for starter fixed at bore wells at Surya Nagar for water supply. The complete work should be done as per direction & complete satisfication of Engineer incharge.

Supply & fixing tube well cover ( for 200mm dia pipe) of MS sheet 8mm thick at top & 5mm thick 100 mm wide shroud around the edge so as to form a cap on the top end of casing pipe with GI nipple 45cm long & two GI flang at bothend in 50/65 mm size passing through a hle in the center of MS sheet. A 25mm socket with end plug shall also be weld over top plate . A GI nipple having outside thread of size 1/2" for installation pressure gauge shall be provided & welded with GI 50/65 mm nipple near top plate nipple shall be provided with end plug.The complete work should be done as per direction & complete satisfication of Engineer incharge.

Repairing of Oil/Air break starter panel set with all necessary material of the same characterstic as original as far as posible with required. The complete work should be done as per direction & complete satisfication of Engineer incharge.

M.K. Contractor

M/S DEEPAK KUMAR AHUJA

JGBK CONSTRUCTION COMPANY

M/S DEEPAK KUMAR AHUJA