Linking of additional source to WSS Dhagoli Dogri in Tehsil Chirgaon Distt Shimla HP

Amount

Excavation in foundation and trenches etc. in earth work in all kinds of soil such as pick work, jumper work, blasting soft or hard rock or by chiselling soft or hard rock where blasting is prohibited in all leads and lifts including trimming / dressing of sides and bed, stacking the excavated soil clear from the edge of excavation and returning the excavated soil after completion of work in 15cm layers when required into plinth, sides of foundation etc. consolidating each deposited layers by ramming and watering and then disposing of all surplus excavated soil complete in all respect as per direction and to the entire satisfaction of the Engineer-in-Charge.

Providing and laying cement concrete 1:3:6(1cement:4sand:8graded stone aggregate of 40mm nominal size)and curing complete excluding cost of form work including all leads and lifts: a) Foundation and Plinth.

Providing and laying 1:1:2(1cement,1 sand, 2graded stone agg 20mm N/S) and curing complete excluding cost of form work and reinforcement for fainforced concreet work in wall (any thikness)atteched pillastter,buttresses beam girders and contilevers upto the floor lavel.

foundation

Walls

Providing and laying cement concrete 1:2:4(1cement:2sand:4graded stone agg.20mm nominal size) and curing complete excluding cost of form work and reinforcement for reinforced concrete work

a) Suspended floors, roofs, landings, shelves and their supports balconies, beams girders bressumers and cantilevers upto floor two levels

Providing form work with steel plates 3.15mm thick welded with angle iron in frame 30x30x5mm so as to give a rough finish including centering shuttering strutting and propping etc. height of propping and centering below supporting floor to ceiling not exceeding 4mtrs.and removal of the same for in situ reinforced concrete and plain concrete work including all leads and lifts:

Vartical surface such as wall (any thickness).

Edge of slab

flate surface

Providng ,Laying /Placing Mild steel/tor steel reinforcement for RCC. Work including binding bending and placing in position complete up to all floor level. a) Tor steel

Providind and fixing (M.S Sheet and angle iron) 600x600 mm dia main hole cover with frame and controling chanel for wheel valve complete. In all respect i.e locking arrangment etc(Not less then 35 kg each) and angle iron stair case for up and down (Not less then 75kg)

Providing and fixing GMS ventilating pipe/over flowpipe (25 to 32) mm dia including all fitting as required.

Providing and fixinf GMS tubes of following dia in walls floor etc including tube fitting and making the wall, floors etc. good. Ie welding with one feet 25mm flat iron both side of req. pipes.

Providing and fixing controlling arrangment with (25 to 32) MM dia wheel valve i/c all type of fitting complete.

10mm Cement plaster in single coat in fair side of brick /stone masonry for interior plastering up to floor two level including arises internal rounded angles chamfers and/or rounded angels not exceeding 80mm in earth and finished even and smooth including all leads and lifts a) 1:3 (1Cement:3sand).

RAJNEESH THAKUR (BID ID -541536)

NIKHIL TEGTA (BID ID -541537)