REPAIR / REPLACEMENT FENCING, BOUNDARY WALL, GATE PILLAR, DRAINAGE AND FOOTPATH / HARD STANDING TO E/M INSTALLATION AT DRONACHAL BHOPAL

Amount

Demolition of brick work or stone /boulder masonry built in cement mortar including all quoins, arches, pillers etc. but excluding ashlar facings, dressed stone work and precast conc rete articles.

Demolition of cement concrete (un-reinforced) in ground floors and pavings n. exc. 15 cm thickness (below or above ground level)

Demolition of Concrete of any description and in any position not otherwise specifically provided for cement concrete unreinforced all as specified and directed.

Demolition of Concrete of any description and in any position not otherwise specifically provided for cement concrete reinforced all as specified and directed.

Dismantling of fencing wire mesh, any type.

Taking down cement plaster on brick or stone wall etc including racking out joints hacking for key scrubbing down with water etc, complete all as specified and directed.

M&L for three coats of white wash including preparation of new concrete surfaces of drain and wall etc all as specified.

M&L for PCC 1:3:6 (type C2) (using 40 mm graded stone aggregate) as in foundation filling and mass concrete

M&L Brickwork with fly ash bricks, straight or curved on plan exc 6m mean radius, built in CM (1:6)

Material and labour for rendering 15 mm thick on other than fair faces of brick work or concrete surfaces of wall in cement mortar 1:4 for finished even and smooth (without using extra cement)

M&L PCC 1;2:4 type Bo (using 12.5 mm grade stone aggregate) as in coping complete all as specified and directed.

Material and labour for providing precast cement concrete Type B1 1:2:4 (20mm graded aggregate)as in cover slabs (for manholes, drains etc.) of any size and thickness as required Set in cement mortar 1:4 Note :- Reinforcement will be measured and paid saperately

M&L for mild steel TMT bars 10 mm dia and over cut to length bent to sharp required including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) but less than 0.9 mm dia Securing with clips complete all as specified and directed.

Supply & fixing 6 to 8mm dia TMT bars, cut to length, bent to shape required, including cranking, bending spirally for hooping for columns, hooking ends and binding with and including mild steel wire (annealed) not less than 0.9mm dia or securing with clips quality conforming to complete all as specified and directed

S&F 75 mm dia PVC (SWR) pipes single socketed fixed in walls and floors or trenches etc. as in weep holes of retaining wall with suitable gravel & complete all as specified and directed.

M&L for walling of random rubble uncoursed well bounded, bedded, and solidly hearted, builted in Cement Mortar 1:6 complete all as specified and directed

M&L for face work finised as under Granite or trap stone rock faced extra over hammer dressed facings with maximum depression on face from straight edge held against the dressed surface n.exe 20mm to block in course masonary complete all as specified and directed

Dismantling of structural steel work including doors, gates but excluding framed truss etc.

M&L for mild steel Framed work as in doors or gates of angle or other section with gusset plates, rails, braces, etc., complete, drilled for fixing of steel sheeting or other covering, Doors etc. to be prepared for hanging or sliding with and including either hooks and hinges or steel hanging door fittings (exclusive or steel sheeting or other covering, running rails and guides) and hanging; also fastening and fixing complete confirming to Fe410-S

M & L for sand filling under floors or in fdn including watering and consolidation as in bedding layers for laying tiles.

M & L Machanic pressed precast concrete interlocking paver block any shape and 80mm thickness, jointed and pointed with grey cement and pigment in floor/ footpath.

M&L for 75mm thick PCC 1:3:6 type C1 using 20 mm graded stone aggregate as in plinth protection surface finished even and smooth using with extra cement

M & L for Hardcore of gauge n exc. 63 mm, deposited, spread and levelled in layers n exc. 15 cm thick, watered and rammed to a true surface complete all as specified and directed

M&L for RCC (1:2:4) type B1(nominal mix) using 20 mm graded stone aggregate as in foundations, including rafts, footing foundation beams, plinth beam, base for coulm, etc basement slab under ream piles and mass concrete.

M&L for Use and waste of formwork to sides of concrete foundation ,footing,base of column ,raft beams , sides and soffits (if any) of foundation and plinth beams and similar work vertical or to batter to rough finish surface of concrete flat.

M&L for RCC (1:2:4) type B1(nominal mix) using 20 mm graded stone aggregate as in retaining walls, basement walls, ballast walls and the like any thickness; above top of footings; including attached pilasters and buttresses complete all as specified and directed

M&L for Use and waste of formwork to Formwork to faces of walls, retaining walls, abutments, parapets and staircase railing and similar work including attached pillasters, buttresses, etc vertical or to better complete all as specified and directed

Excavating in post holes (or similar holes) each n exc 0.5 cu. m, getting out in hard/dense soil, returning, filling in and ramming earth or broken rubble mixed with earth around, in layers not exceeding 25 cm, complete all as specified and directed.

S&F, angle iron (Fe-310) as in posts, struts in fencing including cutting top to shape required, drilling holes, notching for wire etc (ISA 6060 5mm Thick) complete all speciified and directed

S&F steel flat iron including necessary drilling hole bolting or reveting etc and similar work complete conforming to Fe -290 Gde E - 165 (40mm widht 4mm thick) complete all speciified and directed

Supply only Chain link MS galvanisd fencing, any size or type weighting not less than 2.80 Kg/Sqm complete all as specified and directed.

Fixing only chain link fencing including line wires, any mesh, size and type to any type of standards, rails, straining bolts, etc. including provission of binding wire complete all as specified and directed.

S&F, galvanised 2 strand steel barbed wire 2.24mm dia barbed with 2 mm dia barbs at 75 mm spacing and straining and fixing to any type of standard rails straining bolts including securing or tying at crossing with and provision of galvanised mild steel wire complete all speciified and directed

M&L preparation of new steel surface of any description over 10cm width or girth and applying two coats of synthetic enamel paint over a coat of red oxide primer complete all as specified and directed.

CREATIVE CONSTRUCTION

RAJPATI CONSTRUCTION

M/s VIKAS TRADERS

SATHI ENTERPRISES