Athanur TP 15th SFCPurchase of 1 No of TATA ACE vehicles

Displacement (CC)/Engine apacity 700CC-1250 CC,Max Power :20-30BHP @ 2500rpmand above.Max Torque:500NM@ andabove.Typeof el:Diesel,LoadCapacity:2cu.m,Vehicleemission Norms:BS-Vl,Noofcylinderinengine:2-4cylinder,Lengthofchassis:3800mm3950mm.Widthofchassis:1500m1550mm&Groundclearance.150mm-165mm,Fuel tank capacity:Diesel-30ltrsto 40 ltrs&CNG-12-25kg,Sizeof Tyre's& No's :145R&12-5 Nos ,Wheel base:1900 mm- 2250 mm ,Gross vehiclewei:155kg90kg,Clutch:Singleplatedryfrictiondiaphragm,TransmissionSystem :Manual ,No of speed-forward gears : 4 Nos Speeds(4F+1R),Type of steering :Manual/ Power ,Speed Governors :Shall be Fitted ,Pay Load:800Kg t1000Kg,Tipper body length :2100 mm - 2200 mm, Mild steel.Tipperbodywidth :1400 mm -1500 mm&Mild Steel ,Tipper body Height:750 mm - 950 mm &Mild Steel,Sideportion (LH & RH) &rear doorsSheet thickness :2 mm & Mild Steel.Tipper Body top sheet including frame sheet thickness :1.6 mm& MildSteel,TipperBody Top Lid Sheet thickness :1.2mm & Mild Steel,TipperContainer:Tipper Container should be Fabricated with two doors on the rear sideand four doors on four top corners of the containers with hinges and locking system. A partition should be provided on themiddle of container along the vertical lenth of the body,Hydraulic cylinder make:Reputed Make,Hydraulicsystem Operate DC Power Pack System:As per IS standard ,Painting :Should be painted withone coat of Anti-corrosive epoxyprimerand two coats ofenamel paint for approved quality to ensure long lasting resistance for weatherizingand breakage. The color shade should be as per norms.Lettering:To be carried out as directed by Dept officers.Tipper body rear door :Shall be with necessary locking facility,Side safety guard:Shall be Temp Registration as per RTO requirement,NOTE:WarrantyDistance/ Year-25000KM// 12monthswhicheverisearlier

Special repair of clear water vertical wet type single phase submersible pumpset conforming to IS 8034/2002 and as amended thereafter and BEE 3 Star Rated capable of discharging noted LPM against head of water column due to all causes. The pump shall be with stainless steel shaft and dynamically balanced bronze or Cast SS impeller, brass screws and CI FG 200 grade pump bowl/diffuser with ISI mark. The pump shall be directly coupled to a continuos rated two pole suitable wet type vertical squirrel cage induction motor suitable for operation in AC single phase 230 V+/- 10 %,50 HZ +/-5 % with cable wire removing and re errecting the moter with electrical works etc complete

Supply and delivery of DOL Panel Board suitable for Single phase motor and confirming to IS 8034 with ISI marking as per standard specification.