03 - Kasba Tikri mai bne MRF Center pr andar jane hetu CC Sadak ve Gate nirman karya.

Construction of embankment /patri with material obtained from borropit cartage 5.00km . Construction of embankment / patri with material obtained from borropits cartage 5.00 km . Construction of embankment /patri with approved material obtained from borrow pits with all lift and leads transporting to site spreading grading to required slope and compacting to meet requirement of table 300.2

Contruction of granular sub- base by providing well graded material spreading in uniform layers with motor grader on prepared surface ,mixing by mix in place method with rotavtor at OMC,and compacting with smooth wheel roller to achieve the desired drnsity ,as per MORD,specification 401

CC in (1:2:4) with approved ( 1 cement ;4coarse sand ; 8 stone grit ) in comp.position DSR2023 SI. NO . 4.1.3

M-150 brick work in (1:4)mortar with cement and f/sand in Sub structure in comp.position in sub -structure D.S.R 2023 SI NO 6.1.1

12 MM thick plaster on wall in 1 : 6 ( 1 cement , 6 course sand ) DSR 13.4.2

Cement Concrete Pavement.construction of un - reinforcement dowel jointed at expansion and construction joint only, plain cement concrete pavement thickness as per design over a prepared sub base with 43 grade cement or any other as per clause 1501.2.2 M 30 (Grade) coarse and fine aggregates conforming to is 383 maximum size of coarse aggregate not exceeding 25 mm mixed in a concrete mixer of not less than 0.2 cum capacity and opproriate weigh batcher using approved weigh batcher using mix design ,laid in approved fixed side formwork (steel channel laying and fixing of 125 micron thick polythen film wedges steel plates including leveling the formwork as per drawing) spreeding the concrete with shovels rakes compacted using needle screed and plate vibrators and finished in continuous opertion including provision of contraction and expansion construction joint applying debonding strips primer sealant dowel bars near approaches to bridge / culvert and construction joints admixture as approved curing of concrete slab for 14 days using curing compound (where specified) and water finishing to lines and grade as per drawing and technical specification clause 1501

Rcc work in (1:1;5;3) mortar in plinth beam with 2cm gauge stone grit cement c/sand including all material labour tools etc in comp.position DSR 2023 SI NO 5.2.2

mild steel in rcc work in comp.position (s.i-504)

STEEL WORK WELDED IN BUILT UP SECTIONS / FRAMED WORK INCLUDING CUTTING HOISTING FIXING IN POSITION AND APPLYING A PRIMING COAT OF APPROVED STEEL PRIMER USING STRUCTURAL STEEL ETC AS REQUIRED . IN GRADING FRAMES GUARD BAR LADDER RALLING BRACKETS GATES AND SIMILAR WORKS IN DSR 10.25 .2